电工技术学报  2023, Vol. 38 Issue (18): 5017-5028    DOI: 10.19595/j.cnki.1000-6753.tces.221402
电力电子 |
基于Si和SiC器件的混合型级联多电平变换器及其调控优化方法
任鹏, 涂春鸣, 侯玉超, 郭祺, 王鑫
国家电能变换与控制工程技术研究中心(湖南大学) 长沙 410082
Research on a Hybrid Cascaded Multilevel Converter Based on Si and SiC Device and Its Control Optimization Method
Ren Peng, Tu Chunming, Hou Yuchao, Guo Qi, Wang Xin
National Electric Power Conversion and Control Engineering Technology Research Center Hunan University Changsha 410082 China
全文: PDF (3513 KB)   HTML
输出: BibTeX | EndNote (RIS)      
摘要 针对现有级联型多电平变换器器件多、损耗大、功率密度低等问题,该文提出一种基于Si和SiC器件的混合型级联多电平变换器(HCMC)拓扑结构。HCMC由全Si IGBT器件的中性点钳位(NPC)型三电平单元与由Si IGBT、SiC MOSFET器件混合的级联H桥(CHB)单元串联构成。针对此拓扑提出一种特定的高低频混合调制策略,充分发挥SiC MOSFET开关损耗低、Si IGBT通态损耗低的优势,并对NPC单元直流侧电压和CHB单元子模块数进行优化设计。此外,为解决子模块电容电压不平衡问题,提出一种轮换均压控制策略。最后,在6kV系统无功补偿工况下进行仿真和实验,验证了HCMC拓扑结构和调制策略的可行性,并将HCMC和现有级联型多电平变换器进行综合对比,证明了所提拓扑在保证输出性能的条件下大大降低了运行损耗。
服务
把本文推荐给朋友
加入我的书架
加入引用管理器
E-mail Alert
RSS
作者相关文章
任鹏
涂春鸣
侯玉超
郭祺
王鑫
关键词 混合多电平变换器Si IGBTSiC MOSFET混合调制电压平衡策略    
Abstract:In traditional cascaded multilevel converters, problems include a large number of devices, high running loss, and low power density. Recently, some methods have been proposed to reduce the size of the device by optimizing the cascaded topology. At the same time, as the technology of high-performance SiC power devices matures, the method of mixing SiC devices and Si devices provides a new way to improve converter efficiency. Therefore, a hybrid cascaded multilevel converter (HCMC) topology based on Si and SiC devices is proposed. In addition, A specific high-frequency and low-frequency hybrid modulation strategy is proposed for HCMC topology, which fully utilizes the advantages of low switching loss of SiC MOSFET and low on-state loss of Si IGBT. The proposed control strategy can greatly reduce the loss of the device while ensuring the topology output performance.
Firstly, the HCMC topology can be divided into a neutral point clamped (NPC) three-level unit and a cascaded H-bridge (CHB) unit. Among them, one bridge arm in the CHB high-frequency sub-module uses a SiC MOSFET device, and other power devices in the topology are Si IGBTs. Secondly, the high and low frequency hybrid modulation strategy arranges the modulation strategies of different switching frequencies into corresponding modules to make the NPC unit outputs three-level square waves, the CHB low-frequency sub-module outputs multilevel staircase waves, and the CHB high-frequency sub-module outputs high-frequency PWM waves. Third, the relationship between the DC side voltage of the NPC unit and the maximum output voltage of the CHB units in the topology is analyzed. Therefore, the minimum conditions for the number of sub-modules of CHB units under different voltage levels are solved. Finally, the energy fluctuation of the high-frequency sub-module is quantitatively analyzed. An alternate voltage balancing control strategy is proposed to stabilize the capacitor voltage of the CHB high-frequency sub-module.
To further verify the feasibility and effectiveness of the HCMC topology, modulation strategy, and alternate voltage balancing control strategy, the simulation and experiments are carried out in a 6 kV system. In terms of device loss, the total losses of HCMC topology and typical multilevel topology at different equivalent switching frequencies are compared in the Matlab/Simulink and PLECS co-simulation platform. When the compensation capacity of the converter is 3 Mvar and the equivalent switching frequency of the output voltage is 20 kHz, the HCMC reduces the total loss by 44.9 % compared with the traditional CHB topology. Moreover, with the increase of the equivalent switching frequency, HCMC has a greater advantage in reducing running losses. In terms of the number of devices, the total number of HCMC devices has been reduced by more than half compared with the traditional CHB topology. In addition, the traditional CHB topology is all high-frequency devices, and the HCMC topology only contains six high-frequency devices and the rest are all low-frequency devices.
The following conclusions can be drawn from the simulation and experimental analysis: (1) The proposed HCMC combines different structural modules. When only one NPC unit is added, the number of full-bridge sub-modules of HCMC is reduced by 2/3, and the number of devices is reduced by more than half compared with the traditional CHB topology. (2) The proposed high and low frequency hybrid modulation strategy concentrates most of the switching action in the SiC MOSFET device, which gives full play to the advantages of the low open loss of Si IGBT and low switching loss of SiC MOSFET. (3) The proposed alternate voltage balancing control strategy achieves good stability of the DC side voltages of the NPC and CHB units.
Key wordsHybrid multilevel converter    Si IGBT    SiC MOSFET    hybrid modulation    voltage balancing strategy   
收稿日期: 2022-07-21     
PACS: TM464  
基金资助:国家自然科学基金重点项目(52130704)和湖南省科技领军人才计划项目(2019RS3014)资助
通讯作者: 侯玉超,男,1997年生,博士,研究方向为电力电子在电力系统中的应用。E-mail: houyuchaoyx@163.com   
作者简介: 任鹏,男,1998年生,硕士研究生,研究方向为电力电子在电力系统中的应用。E-mail: 873046398@qq.com
引用本文:   
任鹏, 涂春鸣, 侯玉超, 郭祺, 王鑫. 基于Si和SiC器件的混合型级联多电平变换器及其调控优化方法[J]. 电工技术学报, 2023, 38(18): 5017-5028. Ren Peng, Tu Chunming, Hou Yuchao, Guo Qi, Wang Xin. Research on a Hybrid Cascaded Multilevel Converter Based on Si and SiC Device and Its Control Optimization Method. Transactions of China Electrotechnical Society, 2023, 38(18): 5017-5028.
链接本文:  
https://dgjsxb.ces-transaction.com/CN/10.19595/j.cnki.1000-6753.tces.221402          https://dgjsxb.ces-transaction.com/CN/Y2023/V38/I18/5017