1. State Key Laboratory of HVDC Electric Power Research Institute China Southern Power Grid Guangzhou 510663 China; 2. School of Electrical Engineering Southeast University Nanjing 210096 China
Abstract：The active power impact caused by commutation failure (CF) at the inverters of line-commutated-converter-based high voltage direct current (LCC-HVDC) can easily increase the risk of power angle instability in the sending-end ac system. However, the real-time control methods to maintain the transient power angle stability after suffering CF are still insufficient in the existing literatures, since the current researches mainly focus on the qualitative analysis, offline decision and dc control strategy, lacking the quantitative methods and real-time control strategies generator tripping. To solve the issue, the principle of generator rotor acceleration and power angle instability caused by the power impact of CF is firstly analyzed. When a dc system suffers CF, the transmitted active power would experience a sudden drop, equivalent to an increase of the equivalent mechanical power in the sending-end system. If dc system suffers continuous CFs, causing multiple power impacts, the equivalent mechanical power would increase again and form an acceleration area due to the power drop before returning to its initial value. Similarly, the relative kinetic energy under continuous power impacts of CFs can be derived. The analysis results indicate the relative kinetic energy change of the sending-end system can be characterized only by the relative speed of the equivalent generator. If the relative speed of the equivalent generator can be obtained in real time, the relative kinetic energy change of the sending-end ac system is independent of the curve trend of the dc power drop and recovery, as well as the duration of CF. Then the remaining acceleration area of the rotor movement is calculated based on the relative speed of the equivalent generator when DC power is restored to steady state, and the deceleration area and cutting amount required to maintain the transient power angle stability of the system can thus be obtained. Based on the theory researches, a real-time generator tripping control strategy is developed, the specific steps are as follows: (1) If CF occurs at the inverter of dc system, start the calculation and control strategy, calculate the equivalent mechanical power and electromagnetic power of the generators. (2) Monitor whether the transmission power of dc system has recovered to the steady-state value. If so, record the equivalent relative speed of generators at this time and calculate the increased relative kinetic energy after CF. At the same time, calculate the maximum possible deceleration area, if the value of which is less than the relative kinetic energy of increased by power impact, implement the generator tripping control strategy. (3) Calculate the required tripping amount of the generators, and implement the strategy after 200 ms time delay. Since dc overload operation is equivalent to reducing equivalent mechanical power, increase the reference value of the transmitted power of the dc system to the 1.1 times of steady state value during the time delay. Simulations are implemented based on the simple system and actual power grid, which shows that the proposed method can accurately calculate the required cutting amount to maintain the transient power angle stability and effectively reduce the risk of power angle instability after commutation failure. Owing to the generator tripping strategy, voltages of the critical nodes can be maintained at a relatively higher level and the trend of continuous increase of the phase angle difference is effectively suppressed, with the phase angle difference maintained within 180°.
朱益华, 郑晨一, 常东旭, 朱煜昆. 换相失败后提升送端暂态功角稳定性的实时控制方法[J]. 电工技术学报, 2024, 39(21): 6734-6745.
Zhu Yihua, Zheng Chenyi, Chang Dongxu, Zhu Yukun. Real-Time Control Method for Improving Transient Power Angle Stability of the Sending-End System after Commutation Failure. Transactions of China Electrotechnical Society, 2024, 39(21): 6734-6745.
[1] 孟沛彧, 向往, 潘尔生, 等. 分址建设直流输电系统拓扑方案与运行特性研究[J]. 电工技术学报, 2022, 37(19): 4808-4822. Meng Peiyu, Xiang Wang, Pan Ersheng, et al.Research on topology and operation characteristics of HVDC transmission system based on site-division construction[J]. Transactions of China Electrotechnical Society, 2022, 37(19): 4808-4822. [2] 周孝信, 陈树勇, 鲁宗相, 等. 能源转型中我国新一代电力系统的技术特征[J]. 中国电机工程学报, 2018, 38(7): 1893-1904, 2205. Zhou Xiaoxin, Chen Shuyong, Lu Zongxiang, et al.Technology features of the new generation power system in China[J]. Proceedings of the CSEE, 2018, 38(7): 1893-1904, 2205. [3] Rahimi E, Gole A M, Davies J B, et al.Commutation failure analysis in multi-infeed HVDC systems[J]. IEEE Transactions on Power Delivery, 2011, 26(1): 378-384. [4] 汪娟娟, 郑睿娜, 傅闯, 等. 基于逆变站动态无功控制的后续换相失败抑制方法[J]. 电工技术学报, 2023, 38(17): 4672-4682. Wang Juanjuan, Zheng Ruina, Fu Chuang, et al.A method based on constant reactive power control of inverter to suppress the subsequent commutation failure in HVDC system[J]. Transactions of China Electrotechnical Society, 2023, 38(17): 4672-4682. [5] 郑晨一, 汤奕. 考虑多直流无功交互影响的换相失败预防协调控制方法[J]. 电力系统自动化, 2023, 47(4): 102-110. Zheng Chenyi, Tang Yi.Coordinated control method for commutation failure prevention considering reactive power interaction among multiple HVDC systems[J]. Automation of Electric Power Systems, 2023, 47(4): 102-110. [6] 汤奕, 郑晨一. 高压直流输电系统换相失败影响因素研究综述[J]. 中国电机工程学报, 2019, 39(2): 499-513, 647. Tang Yi, Zheng Chenyi.Review on influencing factors of commutation failure in HVDC systems[J]. Proceedings of the CSEE, 2019, 39(2): 499-513, 647. [7] 张炎, 丁明, 韩平平, 等. 直流闭锁后风电送端系统暂态稳定及控制策略研究[J]. 电工技术学报, 2020, 35(17): 3714-3726. Zhang Yan, Ding Ming, Han Pingping, et al.Study on the transient stability and control schemes of the sending-end system involving wind power after UHVDC block[J]. Transactions of China Electrotechnical Society, 2020, 35(17): 3714-3726. [8] 汤奕, 崔晗, 党杰. 基于继承思想的时变性电力系统暂态稳定预测[J]. 中国电机工程学报, 2021, 41(15): 5107-5119. Tang Yi, Cui Han, Dang Jie.Transient stability prediction of time-varying power systems based on inheritance[J]. Proceedings of the CSEE, 2021, 41(15): 5107-5119. [9] 王科, 游大海, 尹项根, 等. 基于支路势能脊的电力系统暂态稳定分析和临界割集识别[J]. 电工技术学报, 2013, 28(11): 262-269. Wang Ke, You Dahai, Yin Xianggen, et al.Power system transient stability analysis and critical cutset detection based on branch ridge[J]. Transactions of China Electrotechnical Society, 2013, 28(11): 262-269. [10] 顾卓远, 汤涌, 张健, 等. 基于相对动能的电力系统暂态稳定实时紧急控制方案[J]. 中国电机工程学报, 2014, 34(7): 1095-1102. Gu Zhuoyuan, Tang Yong, Zhang Jian, et al.Real-time power system transient stability emergency control scheme based on the relative kinetic energy[J]. Proceedings of the CSEE, 2014, 34(7): 1095-1102. [11] 王佳丽, 刘涤尘, 廖清芬, 等. 基于暂态能量的电力系统切机控制措施[J]. 电力系统保护与控制, 2016, 44(10): 1-9. Wang Jiali, Liu Dichen, Liao Qingfen, et al.Generator tripping strategy based on transient energy of power system[J]. Power System Protection and Control, 2016, 44(10): 1-9. [12] 卢锦玲, 郭鲁豫. 基于改进深度残差收缩网络的电力系统暂态稳定评估[J]. 电工技术学报, 2021, 36(11): 2233-2244. Lu Jinling, Guo Luyu.Power system transient stability assessment based on improved deep residual shrinkage network[J]. Transactions of China Electrotechnical Society, 2021, 36(11): 2233-2244. [13] 余贻鑫, 刘辉, 曾沅. 基于实用动态安全域的紧急控制策略[J]. 电力系统自动化, 2004, 28(6): 6-10. Yu Yixin, Liu Hui, Zeng Yuan.A novel emergency control strategy based on practical dynamic security regions[J]. Automation of Electric Power Systems, 2004, 28(6): 6-10. [14] 任伟, 房大中, 陈家荣, 等. 大电网暂态稳定紧急控制下切机量快速估计算法[J]. 电网技术, 2008, 32(19): 10-15, 55. Ren Wei, Fang Dazhong, Chen Jiarong, et al.A fast algorithm to estimate generation capacity tripped by emergency control for transient stability of large power system[J]. Power System Technology, 2008, 32(19): 10-15, 55. [15] 吴为, 汤涌, 孙华东. 基于系统加速能量的切机控制措施量化研究[J]. 中国电机工程学报, 2014, 34(34): 6134-6140. Wu Wei, Tang Yong, Sun Huadong.Quantitative research of generation capacity tripped based on acceleration energy of power system[J]. Proceedings of the CSEE, 2014, 34(34): 6134-6140. [16] 陈长胜, 马世英, 郑超, 等. 基于暂态偏差能量的紧急控制效果超前评估方法[J]. 中国电机工程学报, 2018, 38(17): 5118-5125, 5308. Chen Changsheng, Ma Shiying, Zheng Chao, et al.The advance evaluation of emergency control based on transient deviation energy[J]. Proceedings of the CSEE, 2018, 38(17): 5118-5125, 5308. [17] 朱劭璇, 王彤, 王增平, 等. 考虑主导不稳定平衡点变化的电力系统暂态稳定切机控制策略[J]. 电力系统保护与控制, 2021, 49(5): 20-28. Zhu Shaoxuan, Wang Tong, Wang Zengping, et al.Generator tripping strategy in transient stability control of a power system considering the change of the controlling unstable equilibrium point[J]. Power System Protection and Control, 2021, 49(5): 20-28. [18] 屠竞哲, 张健, 王建明, 等. 大规模直流异步互联系统受端故障引发送端稳定破坏的机理分析[J]. 中国电机工程学报, 2015, 35(21): 5492-5499. Tu Jingzhe, Zhang Jian, Wang Jianming, et al.Mechanism analysis on the sending-side instability caused by the receiving-side contingencies of large-scale HVDC asynchronous interconnected power systems[J]. Proceedings of the CSEE, 2015, 35(21): 5492-5499. [19] 贾俊川, 张健, 仲悟之, 等. 应对多回并列直流换相失败的送端系统安全稳定控制措施研究[J]. 中国电机工程学报, 2017, 37(21): 6320-6327. Jia Junchuan, Zhang Jian, Zhong Wuzhi, et al.Research on the security and stability control measures of the sending side system coping with multiple parallel-operation HVDCs simultaneous commutation failure[J]. Proceedings of the CSEE, 2017, 37(21): 6320-6327. [20] 苏寅生, 陈董秀, 鲍颜红, 等. 应对直流连续换相失败的紧急控制策略[J]. 电力系统保护与控制, 2017, 45(4): 126-131. Su Yinsheng, Chen Dongxiu, Bao Yanhong, et al.An emergency control strategy coping with continuous commutation failure in DC system[J]. Power System Protection and Control, 2017, 45(4): 126-131. [21] 王少辉, 唐飞, 刘涤尘, 等. 应对多直流同时换相失败的直流功率能量补偿调制方法[J]. 电网技术, 2018, 42(9): 2876-2884. Wang Shaohui, Tang Fei, Liu Dichen, et al.DC power energy compensation modulation method coping with simultaneous multiple HVDC commutation failures[J]. Power System Technology, 2018, 42(9): 2876-2884. [22] Ramon G L F. Prediction and control of transient instability using wide area phasor measurement[D]. Winnipeg, Canada: University of Manitoba, 2011.
2024, Vol. 39 
