Abstract：With the continuous development of aerospace, military, industrial production and other related fields, the requirements for machining accuracy and Angle measurement in related industries are also gradually increased. However, the code disk of grating and rotary encoder belong to the position sensor of optical principle, which cannot work in the occasions with strong cosmic rays and rapid temperature changes, and the maintenance difficulty and cost are high, but the induction synchronizer through electromagnetic Induction principle transmits position signal, strong anti-interference and easy to clean and maintain, has relatively stable performance and long service life, Therefore, this kind of non-contact position sensor is widely used in high-speed and high-precision occasions such as Angle measurement and platform Angle position measurement of spacecraft. At the same time, with the miniaturization of space equipment, the research and development of small-size induction synchronizer is of great significance. However, the traditional induction synchronizer uses segmentalized stator structure, which has very strict requirements on the precision of line cutting. Thus, the further miniaturization and integration of induction synchronizer are limited. The form of double-row winding induction synchronizer is constructed to compensate the influence caused by the wire cutting deviation. The stator windings of the segmented winding synchronizer are divided into inner and outer rows and staggered by a group of pitch according to the principle of consistent specific potential. The inner and outer row conductors are directly connected through effective conductors and are approximately in the form of continuous windings. The number of effective conductor coupling becomes twice as much as that of the traditional winding, and no extra lead wire is added, and the influence of conductor deviation is suppressed. In the actual design process, the inner and outer conductors are staggered so as to inhibit the influence of the non-effective potential generated at the end on the output potential, and a 3D model is established for simulation. The output potential is decomposed by fast Fourier and compared with the traditional induction synchronizer, which effectively improves the accuracy of Angle measurement and has important significance for reducing the difficulty and cost of the induction synchronizer. By establishing the effective conductor current density model, the optimization strategy of suppressing the third and fifth harmonics is proposed, which further improves the Angle measurement accuracy of the induction synchronizer. On this basis, the 3D simulation model of the induction synchronizer is established. The correctness and feasibility of this method are verified by finite element analysis and fast Fourier decomposition of the output potential. Through the winding width design, the third and fifth harmonics of output potential can be effectively suppressed and the sinusoidal property of output potential can be guaranteed. Finally, the ultra-thin PCB prototype is used for verification. Compared with the traditional induction synchronizer with the same processing technology and size, the orthogonal error Angle of the optimized double-row winding induction synchronizer is about 30% of that of the single-row induction synchronizer. In other words, the error range of plus or minus 10 seconds can be reached under the same process, which greatly inhibits the harmonic error of the induction synchronizer and reduces the requirement of line precision.
刘承军, 张逸飞, 孙剑飞. 小尺寸双排绕组感应同步器输出电动势的谐波抑制[J]. 电工技术学报, 2023, 38(zk1): 91-100.
Liu Chengjun, Zhang Yifei, Sun Jianfei. Harmonic Suppression of Output Potential of Small Size Double-Row Winding Inductosyn. Transactions of China Electrotechnical Society, 2023, 38(zk1): 91-100.
[1] 刘莎莎, 王博文, 黄文美, 等. 仿生磁致伸缩触觉传感阵列设计与输出特性[J]. 电工技术学报, 2021, 36(12): 2576-2584. Liu Shasha, Wang Bowen, Huang Wenmei, et al.Design and output characteristics of bionic magnetostrictive tactile sensor array[J]. Transactions of China Electrotechnical Society, 2021, 36(12): 2576-2584. [2] 郭强, 李山, 谢诗云, 等. 多相交错并联DC-DC变换器单电流传感器控制策略[J]. 电工技术学报, 2022, 37(4): 964-975. Guo Qiang, Li Shan, Xie Shiyun, et al.Single-sensor sampling current control strategy of multiphase interleaved DC-DC converters[J]. Transactions of China Electrotechnical Society, 2022, 37(4): 964-975. [3] 陈起超, 张伟超, 白仕光, 等. 非本征光纤法-珀传感器局部放电检测研究进展[J]. 电工技术学报, 2022, 37(5): 1305-1320. Chen Qichao, Zhang Weichao, Bai Shiguang, et al.Research progress of extrinsic fiber fabry-perot interferometer sensor in partial discharge detection[J]. Transactions of China Electrotechnical Society, 2022, 37(5): 1305-1320. [4] 李姗姗, 王力农, 方雅琪, 等. 基于布拉格光纤光栅传感技术的复合材料杆塔老化寿命预测[J]. 电工技术学报, 2018, 33(1): 217-224. Li Shanshan, Wang Linong, Fang Yaqi, et al.Aging prediction of composite tower based on FBG sensing technology[J]. Transactions of China Electrotechnical Society, 2018, 33(1): 217-224. [5] 江军, 马国明, 宋宏图, 等. 基于侧边抛磨光纤布拉格光栅的变压器油中溶解氢气传感器[J]. 电工技术学报, 2017, 32(13): 264-270. Jiang Jun, Ma Guoming, Song Hongtu, et al.Dissolved hydrogen sensor in power transformer oil based on side polishing fiber Bragg grating[J]. Transactions of China Electrotechnical Society, 2017, 32(13): 264-270. [6] Ou Qibiao, Zhao Jianchuan, He Wei, et al.Effect of grating period on transmission spectrum of long-period fiber grating coupled at turning point[C]//2020 4th Annual International Conference on Data Science and Business Analytics (ICDSBA), Changsha, China, 2021: 199-204. [7] Lee K, Hwang H Y, Kim Y.Efficient PWM waveform generation using rotary encoder on spartan-6E starter kit[C]//2020 International Conference on Electronics, Information, and Communication (ICEIC), Barcelona, Spain, 2020: 1-2. [8] Mata-Contreras J, Herrojo C, Martín F.Electromagnetic rotary encoders based on split ring resonators (SRR) loaded microstrip lines[C]//2018 IEEE/MTT-S International Microwave Symposium - IMS, Philadelphia, PA, USA, 2018: 43-46. [9] Wang Jinxiang, Cui Xu.Rotary encoder based self-positioning method for mobile robot[C]//2018 5th International Conference on Information Science and Control Engineering (ICISCE), Zhengzhou, China, 2019: 500-504. [10] 霍炎, 任顺清, 李巍. 圆感应同步器扇区刻划误差的测试方法[J]. 电机与控制学报, 2019, 23(7): 19-26, 37. Huo Yan, Ren Shunqing, Li Wei.Measurement method for sector etching error of round inductosyn[J]. Electric Machines and Control, 2019, 23(7): 19-26, 37. [11] 李海霞, 张嵘, 韩丰田. 感应同步器测角系统误差测试及补偿[J]. 清华大学学报(自然科学版), 2016, 56(6): 611-616. Li Haixia, Zhang Rong, Han Fengtian.Error testing and compensation of an inductosyn-based angular measurement system[J]. Journal of Tsinghua University (Science and Technology), 2016, 56(6): 611-616. [12] Mirzaei M, Machac J, Ripka P, et al.Design of a flat-type magnetic position sensor using a finite-difference method[J]. IET Science, Measurement & Technology, 2020, 14(5): 514-524. [13] Liu Chengjun, Xu Fanrong.A novel absolute angle-measuring method with rotary inductosyn[C]//2018 Eighth International Conference on Instrumentation & Measurement, Computer, Communication and Control (IMCCC), Harbin, China, 2020: 1753-1757. [14] 肖飞, 许观达, 连传强, 等. 永磁同步电机单电流传感器系统的三相电流重构策略[J]. 电工技术学报, 2022, 37(7): 1609-1617. Xiao Fei, Xu Guanda, Lian Chuanqiang, et al.Three-phase current reconstruction strategy of permanent magnet synchronous machine drives using a single current sensor[J]. Transactions of China Electrotechnical Society, 2022, 37(7): 1609-1617. [15] 李帆, 罗海云, 杜娟, 等. 基于直流辉光放电等离子体的气体压力传感器[J]. 电工技术学报, 2021, 36(15): 3163-3171. Li Fan, Luo Haiyun, Du Juan, et al.Pressure sensor based on direct current discharge plasma[J]. Transactions of China Electrotechnical Society, 2021, 36(15): 3163-3171. [16] Yan Jiaxuan, Feng Renjian, Wu Yinfeng, et al.A calibration scheme with combination of the optical shaft encoder and laser triangulation sensor for low-frequency angular acceleration rotary table[J]. IEEE Transactions on Instrumentation and Measurement, 2021, 70: 1-13. [17] Böller S, Alić B, Hennig A, et al.Noninvasive current measurement in multi-conductor cables[C]//2021 IEEE Sensors, Sydney, Australia, 2021: 1-4. [18] Brandão G L F, Silva E J, Soares Í V, et al. Analysis of angular stability of fractal artificial magnetic conductor metasurface using generalized boundary conditions[C]//2021 SBMO/IEEE MTT-S International Microwave and Optoelectronics Conference (IMOC), Fortaleza, Brazil, 2021: 1-3. [19] Kwon O I, Sajib S Z K, Sersa I, et al. Current density imaging during transcranial direct current stimulation using DT-MRI and MREIT: algorithm development and numerical simulations[J]. IEEE Transactions on Biomedical Engineering, 2016, 63(1): 168-175. [20] Chen Hao, Wang Yinshun, Wang Jiuke, et al.Experimental study on quasi-isotropic critical current of an HTS conductor with high engineering current density[J]. IEEE Transactions on Applied Superconductivity, 2019, 29(5): 1-4. [21] Jiu Yuanwei, Chen Ziyin, Cui Chenpeng, et al.A round inductosyn measuring system based on quadrant comparison and adjustment fusion algorithm[C]//2021 China Automation Congress (CAC), Beijing, China, 2022: 8068-8071. [22] Song Li, Kang Jianbing, Li Jing.A design of inductosyn angle measurement system based on AD2S80A and FPGA[C] //2017 36th Chinese Control Conference (CCC),Dalian, China,2017: 5350-5353.
2023, Vol. 38 
