Abstract：Due to the advantages of high power level, small torque ripple, and strong reliability, dual three-phase permanent magnet synchronous motors (DTP-PMSM) have been widely used in electric vehicles, ship propulsion, and aerospace power systems. The high fault-tolerant capability for open-phase faults is an important application feature of DTP-PMSM. Developing fault-tolerant control strategies is crucial for improving fault-tolerant performance. While both the minimum loss (ML) and maximum torque (MT) control strategies offer their advantages, stator copper loss and torque output capacity cannot be simultaneously considered. The full range minimum loss (FRML) control strategy comprehensively considers both ML and MT optimization objectives. The stator copper loss is effectively reduced without sacrificing the output torque range. Currently, the FRML control strategies usually add the restriction of sinusoidal current mode. However, the restriction of the sinusoidal current mode narrows the solution space of the current reference and prevents further improvement of the fault-tolerant performance. Therefore, a FRML control strategy based on harmonic current injection is proposed. Firstly, considering the control complexity and optimization effect, third harmonics are injected into the fault-tolerant phase current to expand the solution space. By optimizing the current references, the fault-tolerant performance of ML and MT control strategies is further improved. Secondly, considering the stator copper loss and torque output capacity holistically, an allocation coefficient is introduced to combine the ML and MT strategies nonlinearly. The fault-tolerant trajectory can be smoothly switched online by adjusting the allocation coefficient under various load conditions. The proposed FRML control strategy simplifies the implementation complexity and produces a unified expression of current reference, which effectively reduces stator copper loss over the torque range. Finally, the proposed control strategy is verified on a surface-mounted DTP-PMSM platform. The quasi-proportional resonance controllers ensure accuracy in tracking the AC current reference. Both ML and MT control strategies achieve smaller stator copper loss and larger torque output capacity after the third harmonic injection than the sinusoidal current mode. When the FRML control strategy based on harmonic current injection is applied, the allocation coefficient is modified in real-time with the change of load condition. Under the rated load of 65.5%, 67.7%, and 69.7%, the stator copper loss is lowered by 6.2%, 4.91%, and 3.1%, respectively, compared to the MT control strategy. The fault-tolerant control strategy is verified. The following conclusions can be drawn. (1) The strategies with the injection of third harmonic exhibit the superior performance of copper losses and torque output capability than that with sinusoidal current mode thanks to the more thorough current optimization. Therefore, the fault-tolerant control strategy based on third harmonic injection is more favorable for the stator copper loss optimization in the full torque range. (2) The proposed FRML control strategy based on harmonic current injection can further expand the range of torque optimization and enhance adaptability to various load conditions. (3) The proposed fault-tolerant control strategy is scalable. Future work will be focused on extending the applicability of the proposed control strategy to other polyphase motors, such as nine-phase motors.
艾星全, 肖岚, 伍群芳. 基于谐波注入的双三相PMSM全转矩范围最小铜耗缺相容错控制策略[J]. 电工技术学报, 2025, 40(10): 3157-3169.
Ai Xingquan, Xiao Lan, Wu Qunfang. Fault-Tolerant Control Strategy of Open-Phase Fault with Minimum Loss in Full Torque Operation Range for DTP-PMSM Based on Harmonic Current Injection. Transactions of China Electrotechnical Society, 2025, 40(10): 3157-3169.
[1] 陶涛, 赵文祥, 程明, 等. 多相电机容错控制及其关键技术综述[J]. 中国电机工程学报, 2019, 39(2): 316-326, 629. Tao Tao, Zhao Wenxiang, Cheng Ming, et al.Review on fault-tolerant control of multi-phase machines and their key technologies[J]. Proceedings of the CSEE, 2019, 39(2): 316-326, 629. [2] 刘自程, 李永东, 郑泽东. 多相电机控制驱动技术研究综述[J]. 电工技术学报, 2017, 32(24): 17-29. Liu Zicheng, Li Yongdong, Zheng Zedong.Control and drive techniques for multiphase machines: a review[J]. Transactions of China Electrotechnical Society, 2017, 32(24): 17-29. [3] Levi E, Barrero F, Duran M J.Multiphase machines and drives-revisited[J]. IEEE Transactions on Indu- strial Electronics, 2016, 63(1): 429-432. [4] 孙嘉伟, 郑泽东, 李驰, 等. 对称型多相电机断相容错运行下的电流谐波分析与补偿[J]. 电工技术学报, 2022, 37(21): 5424-5434. Sun Jiawei, Zheng Zedong, Li Chi, et al.Analysis and compensation of current harmonics in symmetrical multiphase machines in fault-tolerant operation against open-phase faults[J]. Transactions of China Electrotechnical Society, 2022, 37(21): 5424-5434. [5] 孙玉华, 赵文祥, 吉敬华, 等. 高转矩性能多相组永磁电机及其关键技术综述[J]. 电工技术学报, 2023, 38(6): 1403-1420. Sun Yuhua, Zhao Wenxiang, Ji Jinghua, et al.Overview of multi-star multi-phase permanent magnet machines with high torque performance and its key technologies[J]. Transactions of China Electrotech- nical Society, 2023, 38(6): 1403-1420. [6] Barrero F, Duran M J.Recent advances in the design, modeling, and control of multiphase machines: part I[J]. IEEE Transactions on Industrial Electronics, 2016, 63(1): 449-458. [7] 王晓姬, 王道涵, 王柄东, 等. 电动汽车驱动/充电一体化系统及其控制策略综述[J]. 电工技术学报, 2023, 38(22): 5940-5958. Wang Xiaoji, Wang Daohan, Wang Bingdong, et al.A review of drive-charging integrated systems and control strategies for electric vehicles[J]. Transa- ctions of China Electrotechnical Society, 2023, 38(22): 5940-5958. [8] Lin F J, Hung Y C, Tsai M T.Fault-tolerant control for six-phase PMSM drive system via intelligent complementary sliding-mode control using TSKFNN- AMF[J]. IEEE Transactions on Industrial Electronics, 2013, 60(12): 5747-5762. [9] 杨金波, 李铁才, 杨贵杰. 一相开路双三相永磁同步电机建模与控制[J]. 电工技术学报, 2011, 26(10): 167-173, 187. Yang Jinbo, Li Tiecai, Yang Guijie.Modeling and control of dual three-phase PMSM with one open phase[J]. Transactions of China Electrotechnical Society, 2011, 26(10): 167-173, 187. [10] Che Hang seng, Duran M J, Levi E, et al. Postfault operation of an asymmetrical six-phase induction machine with single and two isolated neutral points[J]. IEEE Transactions on Power Electronics, 2014, 29(10): 5406-5416. [11] 周长攀, 杨贵杰, 苏健勇, 等. 基于正常解耦变换的双三相永磁同步电机缺相容错控制策略[J]. 电工技术学报, 2017, 32(3): 86-96. Zhou Changpan, Yang Guijie, Su Jianyong, et al.The control strategy for dual three-phase PMSM based on normal decoupling transformation under fault con- dition due to open phases[J]. Transactions of China Electrotechnical Society, 2017, 32(3): 86-96. [12] Baneira F, Doval-Gandoy J, Yepes A G, et al.Control strategy for multiphase drives with minimum losses in the full torque operation range under single open- phase fault[J]. IEEE Transactions on Power Elec- tronics, 2017, 32(8): 6275-6285. [13] 刘海涛, 易新强, 王东, 等. 五相感应电机缺相容错运行的全转矩范围效率优化控制策略[J]. 中国电机工程学报, 2020, 40(5): 1642-1653. Liu Haitao, Yi Xinqiang, Wang Dong, et al.An efficiency-optimized control strategy in the full torque operation range for five-phase induction motor under open-circuited fault conditions[J]. Proceedings of the CSEE, 2020, 40(5): 1642-1653. [14] 李修东, 郑晓钦, 王海峰, 等. 最大转矩范围内九相永磁同步电机缺相容错运行铜耗优化策略[J]. 电工技术学报, 2022, 37(17): 4355-4363. Li Xiudong, Zheng Xiaoqin, Wang Haifeng, et al.Copper loss optimization strategy for nine-phase permanent magnet synchronous motors fault-tolerant operation in maximum torque range[J]. Transactions of China Electrotechnical Society, 2022, 37(17): 4355-4363. [15] Yang Guanghui, Hussain H, Li Sheng, et al.A unified fault-tolerant strategy for multiphase machine with minimum losses in full torque operation range based on closed-form expressions[J]. IEEE Transactions on Power Electronics, 2022, 37(10): 12463-12473. [16] Wang Wei, Zhang Jinghao, Cheng Ming, et al.Fault- tolerant control of dual three-phase permanent- magnet synchronous machine drives under open- phase faults[J]. IEEE Transactions on Power Elec- tronics, 2017, 32(3): 2052-2063. [17] Wang Xueqing, Wang Zheng, He Mingzhi, et al.Fault-tolerant control of dual three-phase PMSM drives with minimized copper loss[J]. IEEE Transa- ctions on Power Electronics, 2021, 36(11): 12938-12953. [18] Jin Luhan, Mao Yao, Wang Xueqing, et al.Optimization- based maximum-torque fault-tolerant control of dual three-phase PMSM drives under open-phase fault[J]. IEEE Transactions on Power Electronics, 2023, 38(3): 3653-3663. [19] Geng Qiang, Li Zhongchen, Wang Huimin, et al.Natural fault-tolerant control with minimum copper loss in full torque operation range for dual three- phase PMSM under open-circuit fault[J]. IEEE Transactions on Power Electronics, 2024, 39(1): 1279-1291. [20] Hu Yashan, Zhu Z Q, Odavic M.Comparison of two-individual current control and vector space decomposition control for dual three-phase PMSM[J]. IEEE Transactions on Industry Applications, 2017, 53(5): 4483-4492. [21] 周长攀, 刘海峰, 景国秀, 等. 双三相永磁同步电机缺相容错运行虚拟矢量间接修正方法及其在直接转矩控制中应用[J]. 电工技术学报, 2023, 38(2): 451-464. Zhou Changpan, Liu Haifeng, Jing Guoxiu, et al.The indirect correction method of virtual vectors for dual three-phase permanent magnet synchronous motors under the open-phase fault and its application in the direct torque control[J]. Transactions of China Elec- trotechnical Society, 2023, 38(2): 451-464. [22] 周长攀, 刘海峰, 景国秀, 等. 非正弦反电势五相永磁同步电机容错矢量控制[J]. 电气工程学报, 2021, 16(4): 108-119. Zhou Changpan, Liu Haifeng, Jing Guoxiu, et al.Fault-tolerant vector control of five-phase permanent magnet synchronous motor of non-sinusoidal back EMF[J]. Journal of Electrical Engineering, 2021, 16(4): 108-119.
2025, Vol. 40 
