基于计算流体力学的非晶合金轴向磁通永磁电机冷却系统设计

doi:10.19595/j.cnki.1000-6753.tces.160137

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (19982 KB)
输出: BibTeX | EndNote (RIS)

摘要

采用一种新型材料——非晶合金作为轴向磁通永磁（AFPM）电机的定子铁心。研制非晶合金和硅钢片两种材料的定子铁心,对其损耗特性进行对比,实验数据显示非晶合金替代常规硅钢片作为电机铁心,能够降低电机的铁耗,但是同时由于高频率的选择使得电机转子部分等损耗有所增加。为进一步提高非晶合金轴向磁通永磁电机冷却效率,优化电机设计保证电机的安全运行,对该类电机的冷却系统进行设计。研究四种冷却结构并建立相应的三维流体场数学模型和物理模型,基于计算流体力学（CFD）理论基础,通过有限体积法,在相同的计算条件、网格划分前提下,研究四种冷却结构的热特性和流动特性。优选出螺旋型结构并对其进行具体尺寸参数设计,最后对无隔水板和螺旋结构进行温升试验。试验结果表明,螺旋结构的绕组和转子冷却效率高出无隔水板结构33.1%和26.5%,为该类新型材料的永磁电机冷却结构设计及电磁方案优化提供了指导。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	韩雪岩
	张华伟
	徐昕
	兰玉华

关键词 ：非晶合金, 轴向磁通永磁电机, 冷却结构, 有限体积法, 温度场

Abstract：

In this paper, a new type of material amorphous alloy is used as the stator of axial flux permanent magnet (AFPM) motor. The stator core of amorphous alloy and silicon steel sheet are developed, and their loss characteristics are compared. The test data show the iron core using amorphous alloy instead of silicon steel can decrease the loss of motor．However, due to the selection of high frequency, the loss in the rotor increases. In order to further improve the cooling efficiency of amorphous alloy AFPM motor and optimize the motor design to ensure the safe operation of the motor, the cooling system is designed in this paper. Four kinds of cooling structures are studied. The corresponding mathematical and physical models of 3D fluid field are established based on computational fluid dynamics (CFD). Under the same calculation and meshing conditions, the thermal and flow characteristics of these four kinds of cooling structures are studied by the finite volume method. The spiral structure is optimized and the specific size parameters are designed. Finally, the temperature rise tests of the parallel and spiral structure are carried out. The results show that, the cooling efficiencies of spiral structure in windings and rotor are increased 33.1% and 26.5% respectively, much higher than those of parallel structure. It provides guidance for using this new material to design cooling structure and optimize electromagnetic scheme of permanent magnet motors.

Key words： Amorphous alloy axial flux permanent magnet (AFPM) motor cooling structure finite volume method temperature field

收稿日期: 2016-01-22 出版日期: 2017-10-30

PACS:

TM315

基金资助:

国家科技支撑计划（2013BAE08B00、2015BAF06B04）和国家自然科学基金（51307111）资助项目

通讯作者: 韩雪岩女,1978年生,博士,副教授,硕士生导师,研究方向为特种电机及其控制技术。E-mail: hxyslm@163.com

作者简介: 张华伟男,1988年生,硕士研究生,研究方向为特种电机及其控制技术。E-mail: 292256828 @qq.com

引用本文:

韩雪岩, 张华伟, 徐昕, 兰玉华. 基于计算流体力学的非晶合金轴向磁通永磁电机冷却系统设计[J]. 电工技术学报, 2017, 32(20): 189-197. Han Xueyan, Zhang Huawei, Xu Xin, Lan Yuhua. Design of Cooling System for Amorphous Alloy Axial Flux Permanent Magnet Motor Based on Computational Fluid Dynamics. Transactions of China Electrotechnical Society, 2017, 32(20): 189-197.

链接本文:

https://dgjsxb.ces-transaction.com/CN/10.19595/j.cnki.1000-6753.tces.160137 https://dgjsxb.ces-transaction.com/CN/Y2017/V32/I20/189

[1] 韩雪岩, 佟文明, 唐任远. 非晶合金在电机中的应用[J]. 电工电能新技术, 2014, 33(12): 46-52.
Han Xueyan, Tong Wenming, Tang Renyuan. Application of amorphous alloy in motor[J]. Advanced Technology of Electrical Engineering and Energy, 2014, 33(12): 46-52.
[2] 刘婷. 非晶合金电机的有限元分析及控制研究[D]. 天津: 天津理工大学, 2012.
[3] 朱龙飞, 朱建国, 佟文明, 等. 非晶合金永磁同步电机空载损耗[J]. 电机与控制学报, 2015, 19(7): 21-26.
Zhu Longfei, Zhu Jianguo, Tong Wenming, et al. Study on no-load losses of permanent magnet synchronous motor with amorphous alloy stator core[J]. Electric Machines and Control, 2015, 19(7): 21-26.
[4] 李立毅, 黄旭珍, 寇保泉, 等. 基于有限元法的圆筒型直线电机温度场数值计算[J]. 电工技术学报, 2013, 28(2): 132-138.
Li Liyi, Huang Xuzhen, Kou Baoquan, et al. Numerical calculation of temperature field for tubular linear motor based on finite element method[J]. Transactions of Electrotechnical Society, 2013, 28(2): 132-138.
[5] 李伟力, 孙佳慧, 孙宏丽. 汽轮发电机稳态与负序工况下转子涡流损耗计算和温度场分析[J]. 电工技术学报, 2012, 27(9): 175-182.
Li Weili, Sun Jiahui, Sun Hongli. Calculation and analysis of eddy loss and temperature field in rotor of synchronous generator under steady state and negative sequence[J]. Transactions of Electro- technical Society, 2012, 27(9): 175-182.
[6] 胡田, 唐任远, 李岩, 等. 永磁风力发电机三维温度场计算及分析[J]. 电工技术学报, 2013, 28(3): 122-126.
Hu Tian, Tang Renyuan, Li Yan, et al. Thermal analysis and calculation of permanent magnet wind generators[J]. Transactions of Electrotechnical Society, 2013, 28(3): 122-126.
[7] Darabi A, Sarreshtehdari A, Tahanian H. Design of the forced water cooling system for a claw pole transverse flux permanent magnet synchronous motor[C]//21st Iranian Coference on Electrical Engineering (ICEE), Mashhad, Iran, 2013: 1-5.
[8] Shafaie R, Kalantar M, Gholami A. Thermal analysis of 10MW class wind turbine HTS synchronous generator[J]. IEEE Transactions on Applied Super- conductivity, 2014, 24(2): 90-98.
[9] Polikarpova M, Roytta P, Alexandrova J, et al. Thermal design and analysis of a direct-water cooled direct drive permanent magnet synchronous generator for high-power wind turbine application[C]//Inter- national Conference on Electrical Machines, Marseille, France, 2012: 1488-1495.
[10] Borges S S, Cezario C A, Kunz T T. Design of water cooled electric motors using CFD and thermography techniques[C]//18th International Conference on Electrical Machines, Vilamoura, Portugal, 2008: 1-6.
[11] 孔晓光, 王凤翔, 刑军强. 高速永磁电机的损耗计算与温升分析[J]. 电工技术学报, 2012, 27(9): 166-173.
Kong Xiaoguang, Wang Fengxiang, Xing Junqiang. Losses calculation and temperature field analysis of high speed permanent magnet machines[J]. Transa- ctions of Electrotechnical Society, 2012, 27(9): 166- 173.
[12] 温嘉斌, 和海波. 对旋轴流通风机流场预测及两级电机功率匹配研究[J]. 电工技术学报, 2015, 30(1): 105-111.
Wen Jiabin, He Haibo. Flow field estimation of counter-rotating axial flow fan and power matching research of two motors[J]. Transactions of Electro- technical Society, 2015, 30(1): 105-111.
[13] Li C P, Chai F, Feng X C, et al. Optimization design and analysis of cooling system used for mini electric vehicle motor[C]//17th International Conference on Electrical Machines and Systems, Hangzhou, China, 2014: 1-5.
[14] 王晓远, 杜静娟. 应用CFD流固祸合热分析车用高功率密度电机的水冷系统[J]. 电工技术学报, 2015, 30(9): 31-38.
Wang Xiaoyuan, Du Jingjuan. Design and analysis of water cooling system for HEVs high-power-density motor using CFD and thermal technology[J]. Transa- ctions of Electrotechnical Society, 2015, 30(9): 31-38.
[15] 杜海, 曲延滨, 张鹏. 新型旋转电磁热机流体流动与传热的丰禺合计算与实验[J]. 电工技术学报, 2015, 30(12): 291-297.
Du Hai, Qu Yanbin, Zhang Peng. Coupling calculation and experiment of fluid flow and heat transfer a new rotating induction heater[J]. Transa- ctions of Electrotechnical Society, 2015, 30(12): 291-297.
[16] 师元康, 姜振超, 赵书涛. 基于内部温度的继电保护装置时变失效率研究[J]. 电力系统保护与控制, 2016, 44(4): 123-128.
Shi Yuankang, Jiang Zhenchao, Zhao Shutao. Research on time-varying failure rate of protection devices based on internal temperature[J]. Power System Protection and Control, 2016, 44(4): 123-128.
[17] 陈跃明, 王月琴, 郝曼彤. 非晶定子水冷永磁盘式电机: 中国, 201210458986.8[P]. 2012-11-14.