Abstract：The induction motor is the most common AC motor type in industrial applications. Due to its complex working conditions, various stator, rotor, or bearing faults will occur. According to statistics, the inter-turn fault (ITF) accounts for about 26%~36% of the total motor fault. After the fault occurs, it will cause changes in the magnetic field, thermal field, vibration, and motor noise. Besides, the overheating problem caused by the fault will accelerate the deterioration of winding insulation and deepen the fault degree. Recently, the research focused on the thermal characteristics caused by ITF, which has achieved good results in temperature detection, fault identification, modeling, and simulation. However, there are still areas for improvement in many research methods. Therefore, the transient thermal field simulation and temperature rise (TR) experiment are adopted to analyze the temporal-spatial characteristics of motor thermal field distribution and the differences in winding temperature before and after the fault. In addition, the thermal characteristics related to the fault can be summarized. Firstly, the 3D transient simulation model of the motor is established after reasonable equivalence. The motor loss values under no-load, light load, and rated load conditions before and after the fault are used as the heat source, and the whole domain thermal field distribution of the normal and faulty motor under different conditions is obtained by simulation. Secondly, the thermistors are embedded at several key temperature measuring points inside the prototype to carry out the TR experiment of the motor under various working conditions. Also, the results of TR experiments verify the simulation accuracy. Finally, according to the simulation and measured temperature results, three TR characteristics caused by ITF are summarized, and a fault diagnosis method based on the winding temperature difference is proposed. The simulation and experimental results show that ITF will cause three characteristics of the motor TR: time, space, and winding temperature difference. As the heat generation rate of each part of the faulty motor changes greatly, the TR time of the four critica positions of the motor after the fault is shortened by 97.6%, 38.9%, 34.3%, and 37.0%, respectively, compared with the normal time, and the TR of each part will rise significantly, especially in the faulty slot. In addition, the spatial temperature distribution after the fault is uneven due to the differences in the circumferential heat dissipation conditions of the motor and the heat generation of each component after the fault. The temperature difference characteristics of winding are the most obvious in the temperature variation of each motor component caused by faults. By analyzing the temperature data of winding at different times, a fault diagnosis method using the variance value of winding temperature is proposed. The results show that the data with the variance value as the characteristic quantity after the fault is more than 20 times larger than the normal one, which indicates that the method can diagnose faults under different load conditions. The following conclusions can be drawn from the comprehensive analysis of the research results: (1) ITF will cause the differential distribution of the transient and steady thermal field of the motor, and the above characteristics are most obvious in the winding temperature difference. (2) The variation trend of temperature characteristics of motor winding under different working conditions is approximately the same. The faulty slot winding shows the transient characteristics of TR with drastic changes. In addition, the temperature distribution among windings also changes from almost the same at the normal time to a considerable difference after the fault. (3) The TR characteristics of the motor change obviously after ITF. The winding temperature monitoring and variance analysis method proposed in this paper can effectively diagnose the fault from the perspective of the thermal field.
陈鹏, 谢颖, 李道璐. 感应电机定子匝间短路故障温升特性研究[J]. 电工技术学报, 2023, 38(18): 4875-4888.
Chen Peng, Xie Ying, Li Daolu. Research on the Temperature Rise Characteristics of Induction Motors with Stator Inter-Turn Fault. Transactions of China Electrotechnical Society, 2023, 38(18): 4875-4888.
[1] Singh G K, SASA Kazzas.Induction machine drive condition monitoring and diagnostic research-a survey[J]. Electric Power Systems Research, 2003, 64(2): 145-158. [2] Ojaghi M, Sabouri M, Faiz J.Diagnosis methods for stator winding faults in three-phase squirrel-cage induction motors[J]. International Transactions on Electrical Energy Systems, 2014, 24(6): 891-912. [3] 张业成, 刘国海, 陈前. 基于电流波动特征的永磁同步电机匝间短路与局部退磁故障分类诊断研究[J]. 电工技术学报, 2022, 37(7): 1634-1643, 1653. Zhang Yecheng, Liu Guohai, Chen Qian.Discri-mination of interturn short-circuit and local demag-netization in permanent magnet synchronous motor based on current fluctuation characteristics[J]. Transactions of China Electrotechnical Society, 2022, 37(7): 1634-1643, 1653. [4] Mirzaeva G, Saad K I.Advanced diagnosis of stator turn-to-turn faults and static eccentricity in induction motors based on internal flux measurement[J]. IEEE Transactions on Industry Applications, 2018, 54(4): 3961-3970. [5] Praveen K N, Isha T B.FEM based electromagnetic signature analysis of winding inter-turn short-circuit fault in inverter fed induction motor[J]. CES Transa-ctions on Electrical Machines and Systems, 2019, 3(3): 309-315. [6] Filho P C M L, Santos D C, Batista F B, et al. Axial stray flux sensor proposal for three-phase induction motor fault monitoring by means of orbital analysis[J]. IEEE Sensors Journal, 2020, 20(20): 12317-12325. [7] 何玉灵, 张文, 张钰阳, 等. 发电机定子匝间短路对绕组电磁力的影响[J]. 电工技术学报, 2020, 35(13): 2879-2888. He Yuling, Zhang Wen, Zhang Yuyang, et al.Effect of stator inter-turn short circuit on winding elec-tromagnetic forces in generators[J]. Transactions of China Electrotechnical Society, 2020, 35(13): 2879-2888. [8] 王栋悦, 谷怀广, 魏书荣, 等. 基于机电信号融合的DFIG定子绕组匝间短路故障诊断[J]. 电力系统自动化, 2020, 44(9): 171-178. Wang Dongyue, Gu Huaiguang, Wei Shurong, et al.Diagnosis of inter-turn short-circuit fault in stator windings of DFIG based on mechanical and electrical signal fusion[J]. Automation of Electric Power Systems, 2020, 44(9): 171-178. [9] 吴柏禧, 万珍平, 张昆, 等. 考虑温度场和流场的永磁同步电机折返型冷却水道设计[J]. 电工技术学报, 2019, 34(11): 2306-2314. Wu Boxi, Wan Zhenping, Zhang Kun, et al.Design of reentrant cooling channel in permanent magnet synchronous motor considering temperature field and flow field[J]. Transactions of China Electrotechnical Society, 2019, 34(11): 2306-2314. [10] 秦雪飞, 沈建新, Nilssen R, 等. 高速永磁同步电机在多物理场和变流器约束下的设计[J]. 电工技术学报, 2022, 37(7): 1618-1633. Qin Xuefei, Shen Jianxin, Nilssen R, et al.Design of high-speed PMSM considering multi-physics fields and power converter constraints[J]. Transactions of China Electrotechnical Society, 2022, 37(7): 1618-1633. [11] 谢颖, 胡圣明, 陈鹏, 等. 永磁同步电机匝间短路故障温度场分析[J]. 电工技术学报, 2022, 37(2): 322-331. Xie Ying, Hu Shengming, Chen Peng, et al.Thermal field analysis on inter-turn short circuit fault of permanent magnet synchronous motor[J]. Transa-ctions of China Electrotechnical Society, 2022, 37(2): 322-331. [12] Mohammed A, Melecio J I, Djurović S.Stator winding fault thermal signature monitoring and analysis by in situ FBG sensors[J]. IEEE Transactions on Industrial Electronics, 2018, 66(10): 8082-8092. [13] Mohammed A, Djurović S.FBG thermal sensing ring scheme for stator winding condition monitoring in PMSMs[J]. IEEE Transactions on Transportation Electrification, 2019, 5(4): 1370-1382. [14] Kumar P S, Xie Lihua, Halick M S M, et al. Stator end-winding thermal and magnetic sensor arrays for online stator inter-turn fault detection[J]. IEEE Sensors Journal, 2021, 21(4): 5312-5321. [15] Singh G, Kumar T C A, Naikan V N A. Induction motor inter turn fault detection using infrared thermo-graphic analysis[J]. Infrared Physics and Technology, 2016, 77: 277-282. [16] Glowacz A, Glowacz Z.Diagnosis of the three-phase induction motor using thermal imaging[J]. Infrared Physics & Technology, 2017, 81: 7-16. [17] Bento F, Adouni A, Muxiri A C P, et al. On the risk of failure to prevent induction motors permanent damage, due to the short available time-to-diagnosis of inter-turn short-circuit faults[J]. IET Electric Power Appli-cations, 2021, 15(1): 51-62. [18] Dusek J, Arumugam P, Brunson C, et al.Impact of slot/pole combination on inter-turn short-circuit current in fault-tolerant permanent magnet machines[J]. IEEE Transactions on Magnetics, 2016, 52(4): 1-9. [19] Li G J, Ojeda J, Hoang E, et al.Thermal-electromagnetic analysis of a fault-tolerant dual-star flux-switching permanent magnet motor for critical applications[J]. IET Electric Power Applications, 2011, 5(6): 503-513. [20] Shi Yanwen, Wang Jiabin, Wang Bo.Transient 3-D lumped parameter and 3-D FE thermal models of a PMASynRM under fault conditions with asymmetric temperature distribution[J]. IEEE Transactions on Industrial Electronics, 2021, 68(6): 4623-4633. [21] 刘慧开, 杨立, 孙丰瑞. 异步电动机定子绕组槽内匝间短路早期故障的表面温升[J]. 电工技术学报, 2007, 22(3): 49-54. Liu Huikai, Yang Li, Sun Fengrui.Study of surface temperature rise of induction motor with stator winding inter-turn short circuit fault in slot[J]. Transactions of China Electrotechnical Society, 2007, 22(3): 49-54. [22] 王艳武, 杨立, 孙丰瑞. 异步电动机定子绕组匝间短路三维温度场计算与分析[J]. 中国电机工程学报, 2009, 29(24): 84-90. Wang Yanwu, Yang Li, Sun Fengrui.Simulation and analysis of 3D temperature field for stator winding short-circuit in asynchronous motor[J]. Proceedings of the CSEE, 2009, 29(24): 84-90. [23] Boglietti A, Carpaneto E, Cossale M, et al.Stator winding thermal conductivity evaluation: an industrial pro-duction assessment[J]. IEEE Transactions on Industry Applications, 2016, 52(5): 3893-3900. [24] Ball K S, Farouk B, Dixit V C.An experimental study of heat transfer in a vertical annulus with a rotating inner cylinder[J]. International Journal of Heat and Mass Transfer, 1989, 32(8): 1517-1527. [25] 谢颖, 郭金鹏, 单雪婷, 等. 油田抽油机用感应电动机三维瞬态温度场计算分析[J]. 电机与控制学报, 2019, 23(10): 59-67. Xie Ying, Guo Jinpeng, Shan Xueting, et al.Three-dimensional transient temperature field calculation and analysis of induction motor for oilfield pumping unit[J]. Electric Machines and Control, 2019, 23(10): 59-67. [26] Chen Peng, Xie Ying, Hu Shengming.Electromagnetic performance and diagnosis of induction motors with stator interturn fault[J]. IEEE Transactions on Industry Applications, 2020, 57(2): 1354-1364. [27] 黄国治, 傅丰礼. 中小旋转电机设计手册[M]. 北京: 中国电力出版社, 2007. [28] 魏永田, 孟大伟, 温嘉斌. 电机内热交换[M]. 北京: 机械工业出版社, 1988.
2023, Vol. 38 
