Effect of Rectangular Wave Excitation with Different Duty Ratio on Magnetization Process of Nanocrystalline Alloys
Wang Yifan1, Zou Liang1, Zhan Li1, Li Yongjian2, Sun Qiuxia3
1. School of Electrical Engineering Shandong University Jinan 250061 China; 2. Key Laboratory of Electromagnetic Field and Electrical Apparatus Reliability of Hebei Province Hebei University of Technology Tianjin 300130 China; 3. Shandong Taikai Transformer Co. Ltd Taian 271000 China
Abstract:With the increase of operating frequency, high-frequency transformers show excellent performance.Furthermore, nanocrystalline alloy, especially iron-based nanocrystalline alloy,due to its unique properties performs well as one of the core materials. In the actual working environment, the high frequency transformer is affected by the rectangular wave excitation with the change of duty ratio, which leads to the change of the material’s magnetization process. the duty ratio of the rectangular wave affects the magnetization time of nanocrystalline alloy for the core material, which affects whether high frequency transformer can reach the saturation operating point. Based on the theory of the random anisotropy, a micromagnetic model of the nanocrystalline alloy at mesoscale is established, and the rectangular wave excitation with different duty ratios D is applied to the model. In addition,the magnetization ratev is defined. The influence of D on the magnetization process is analyzed from the three aspects which are the hysteresis loss Pv, the magnetization ratev and the magnetic moment deviation angular velocity ω respectively. The results show that Pv is the smallest when D=0.5, and Pv increases when D increases or decreases. When the sum of different duty ratios is 1, Pv is the same correspondingly. If the exciting magnetic field is located at the rising edge, v and ω are the smallest when D=0.1, or the largest when D=0.9. If the exciting magnetic field is at the falling edge, v and ω are the smallest when D=0.9, and the largest when D=0.1. The above results show that D can affect the magnetization time of the material. Due to magnetic relaxation, changing the magnetization time determines whether the material can achieve saturation magnetization. It proves that the difference in hysteresis loss caused by different duty ratios is caused by the rising edge and falling edge, that is, In the rectangular wave high-low level conversion, on the one hand the macro level asv, and on the other hand the micro level asω, which is caused by the difference between the two variables. In view of the fact that there exists a critical state in exploring the influence of D on the magnetization process, whichcan make nanocrystalline alloy magnetized to the saturation magnetization state exactly under the action of the external excitation source. This critical state is defined as the critical duty ratio (CDR), represented by Dc.By comparing the relationship between different duty ratios and the difference between the magnetization intensity before the transition stage and the saturation magnetization, it is found that when D<0.5, the value of Dc1 ranges from 0.2 to 0.21. When D is less than 0.5, the value of Dc2 ranges from 0.8 to 0.81.When D<Dc1, in the high level holding phase and can not achieve the saturation magnetization, when Dc1<D<Dc2, the material can reach the saturation magnetization regardless of whether it is in the high level or low level stage, when D>Dc2, it cannot achieve the saturation magnetization in the low level holding phase. It provides reference for the selection of high frequency transformer operating points under different working conditions.
王怡凡, 邹亮, 张黎, 李永建, 孙秋霞. 矩形波激励对纳米晶合金高频磁化过程的微观影响机理[J]. 电工技术学报, 2024, 39(11): 3259-3269.
Wang Yifan, Zou Liang, Zhan Li, Li Yongjian, Sun Qiuxia. Effect of Rectangular Wave Excitation with Different Duty Ratio on Magnetization Process of Nanocrystalline Alloys. Transactions of China Electrotechnical Society, 2024, 39(11): 3259-3269.
[1] 惠希东, 吕旷, 斯佳佳, 等. 高饱和磁化强度铁基非晶纳米晶软磁合金发展概况[J]. 工程科学学报, 2018, 40(10): 1158-1167. Hui Xidong, Lü Kuang, Si Jiajia, et al.Development of Fe-based amorphous and nanocrystalline alloys with high saturation flux density[J]. Chinese Journal of Engineering, 2018, 40(10): 1158-1167. [2] 王迎迎, 程红. 应用于功率变换器的多绕组高频变压器模型[J]. 电工技术学报, 2021, 36(19): 4140-4147. Wang Yingying, Cheng Hong.Dual multi-winding high-frequency transformer equivalent circuit for power converter applications[J]. Transactions of China Electrotechnical Society, 2021, 36(19): 4140-4147. [3] Takenaka K, Setyawan A D, Zhang Yan, et al.Production of nanocrystalline (Fe, co)-Si-B-P-Cu alloy with excellent soft magnetic properties for commercial applications[J]. Materials Transactions, 2015, 56(3): 372-376. [4] 杨庆新, 李永建. 先进电工磁性材料特性与应用发展研究综述[J]. 电工技术学报, 2016, 31(20): 1-29. Yang Qingxin, Li Yongjian.Characteristics and developments of advanced magnetic materials in electrical engineering: a review[J]. Transactions of China Electrotechnical Society, 2016, 31(20): 1-29. [5] 陈彬, 李琳, 赵志斌. 双向全桥DC-DC变换器中大容量高频变压器绕组与磁心损耗计算[J]. 电工技术学报, 2017, 32(22): 123-133. Chen Bin, Li Lin, Zhao Zhibin.Calculation of high-power high-frequency transformer’s copper loss and magnetic core loss in dual-active-bridge DC-DC converter[J]. Transactions of China Electrotechnical Society, 2017, 32(22): 123-133. [6] Füzer J, Dobák S, Kollár P.Magnetization dynamics of FeCuNbSiB soft magnetic ribbons and derived powder cores[J]. Journal of Alloys and Compounds, 2015, 628: 335-342. [7] 曾汉超, 许俊阳, 陈道炼. 带低频纹波抑制的单级充放电高频环节DC-AC变换器[J]. 电工技术学报, 2018, 33(8): 1783-1792. Zeng Hanchao, Xu Junyang, Chen Daolian.Single-stage charging/discharging high-frequency link DC-AC converter with low-frequency harmonic suppression[J]. Transactions of China Electrotechnical Society, 2018, 33(8): 1783-1792. [8] Herzer G.Modern soft magnets: amorphous and nanocrystalline materials[J]. Acta Materialia, 2013, 61(3): 718-734. [9] 赵争菡, 汪友华, 凌跃胜, 等. 大容量高频变压器绕组损耗的计算与分析[J]. 电工技术学报, 2014, 29(5): 261-264, 270. Zhao Zhenghan, Wang Youhua, Ling Yuesheng, et al.Calculation and analysis of loss in high-capacity high-frequency transformers[J]. Transactions of China Electrotechnical Society, 2014, 29(5): 261-264, 270. [10] Liu C, Inoue A, Kong F L, et al.Fe-B-Si-C-Cu amorphous and nanocrystalline alloys with ultrahigh hardness and enhanced soft magnetic properties[J]. Journal of Non-Crystalline Solids, 2021, 554: 120606. [11] 姬俊安, 赵志刚, 张时, 等. 基于能量模型与电磁场数值法的高频激励下纳米晶材料磁滞特性预测模型[J/OL]. 中国电机工程学报, 2024: 1-12[2024-01-09]. https://kns.cnki.net/kcms/detail/11.2107.TM.20240108.1734.019.html. Ji Jun’an, Zhao Zhigang, Zhang Shi, et al. Prediction method for hysteresis characteristics of nanocrystalline materials at high frequency based on energy model and electromagnetic field numerical method[J/OL]. Proceedings of the CSEE, 2024: 1-12[2024-01-09]. https://kns.cnki.net/kcms/detail/11.2107.TM.20240108.1734.019.html. [12] Kim K C, Ryu D S, Kim M G.Characteristics of ferromagnetic materials due to uneven magnetic saturation[J]. IEEE Transactions on Magnetics, 2011, 47(10): 3669-3672. [13] 韩智云, 邹亮, 伍珈乐, 等. 外部和内部因素对纳米晶合金kHz级饱和磁化过程影响的微磁学分析[J]. 电工技术学报, 2019, 34(8): 1589-1598. Han Zhiyun, Zou Liang, Wu Jiale, et al.Micromagnetic analysis of external and internal impact factors on kHz level saturation magnetization for nanocrystalline alloy[J]. Transactions of China Electrotechnical Society, 2019, 34(8): 1589-1598. [14] Elrefai A L, Sasayama T, Yoshida T, et al.Magnetic core-size distribution of magnetic nanoparticles estimated from magnetization, AC susceptibility, and relaxation measurements[J]. IEEE Transactions on Magnetics, 2017, 53(11): 8204605. [15] 代岭均, 邹亮, 郭凯航, 等. 纳米晶合金晶粒尺寸与体积分数对高频磁损耗特性影响分析[J]. 电工技术学报, 2023, 38(18): 4853-4863. Dai Lingjun, Zou Liang, Guo Kaihang, et al.Analysis of grain size and volume fraction of nanocrystalline alloy on high frequency magnetic loss characteristics[J]. Transactions of China Electrotechnical Society, 2023, 38(18): 4853-4863. [16] Tallon J, Bernhard C, Bowden M, et al.Coexisting ferromagnetism and superconductivity in hybrid rutheno-cuprate superconductors[J]. IEEE Transactions on Applied Superconductivity, 1999, 9(2): 1696-1699. [17] Wang Yifan, Zou Liang, Zhang Li, et al.Effect of high-frequency non-sinusoidal excitation on the magnetic moment deflection angular velocity of nanocrystalline alloys under saturation magneti-zation[C]//2023 IEEE 6th International Electrical and Energy Conference (CIEEC), Hefei, China, 2023: 2440-2444. [18] 赵志刚, 贾慧杰, 刘朝阳, 等. 考虑PWM波形特征的纳米晶磁心损耗模型研究及验证[J]. 电工技术学报, 2024, 39(6): 1602-1612. Zhao Zhigang, Jia Huijie, Liu Zhaoyang, et.al. Research and verification of nanocrystalline core loss model considering pwm waveform character-istics[J]. Transactions of China Electrotechnical Society, 2024, 39(6): 1602-1612. [19] Venkatraman P S.Winding eddy current losses in switch mode power transformers due to rectangular wave currents[C]//Proceedings of Powercon 11, Dallas, USA, 1984: 1-11. [20] 贲彤, 王进, 陈龙, 等. 考虑磁致伸缩逆效应的非晶合金开关磁阻电机减振方法[J]. 电工技术学报, 2023, 38(10): 2648-2660. Ben Tong, Wang Jin, Chen Long, et al.Vibration reduction method of switched reluctance motor with amorphous alloy cores based on inverse-magnetostriction effect[J]. Transactions of China Electrotechnical Society, 2023, 38(10): 2648-2660. [21] Guo Yunxiang, Lu Cheng, Yu Feng, et al.Investigation of core loss calculation methods for nanocrystalline core in medium frequency range[J]. Energy Engineering, 2020, 117(6): 429-438. [22] 刘欢, 李永建, 张长庚, 等. 非正弦激励下纳米晶材料高频磁心损耗的计算方法改进与验证[J]. 电工技术学报, 2023, 38(5): 1217-1227. Liu Huan, Li Yongjian, Zhang Changgeng, et al.Calculation and experimental verification of core loss in high frequency transformer under non-sinusoidal excitation[J]. Transactions of China Electrotechnical Society, 2023, 38(5): 1217-1227. [23] Lax B, Button K J.Microwave ferrites and ferrimagnetics[M]. New York: McGraw-Hill, 1962. [24] Sparks M.Ferromagnetic-relaxation theory[M]. New York: McGraw-Hill, 1964. [25] Patton C E.Microwave resonance and relaxation[M]. London: John Wiley, 1975. [26] Ngai K L, Rajagopal A K, Teitler S.Slowing down of relaxation in a complex system by constraint dynamics[J]. The Journal of Chemical Physics, 1988, 88(8): 5086-5094.