电工技术学报  2023, Vol. 38 Issue (16): 4479-4488    DOI: 10.19595/j.cnki.1000-6753.tces.221231
高电压与放电 |
基于M-W极化模型的低电场极性反转下XLPE/硅橡胶空间电荷与电场分布特性研究
宋柯1, 钱定冬1, 鲍国栋1, 王伟1, 齐佳乐2
1.新能源电力系统国家重点实验室(华北电力大学) 北京 102206;
2.国网北京市电力公司电力科学研究院 北京 100096
Study on Space Charge and Field Distribution Characteristics of XLPE/SR under Low Electric Field Polarity Reversal Based on the M-W Model
Song Ke1, Qian Dingdong1, Bao Guodong1, Wang Wei1, Qi Jiale2
1. State Key Laboratory of Alternate Electrical Power System with Renewable Energy Sources North China Electric Power University Beijing 102206 China;
2. Electric Power Research Institute of State Grid Beijing Electric Power Company Beijing 100096 China
全文: PDF (1575 KB)   HTML
输出: BibTeX | EndNote (RIS)      
摘要 相比于单一介质的电缆绝缘,高压直流电缆附件复合绝缘因介质不连续性更易在界面处积聚空间电荷。在基于电网换相器的高压直流(LCC-HVDC)输电系统中,进行潮流反转调整时需改变电压极性,高压直流电缆附件将会承受极性反转电场,尽管是短时的,但由于空间电荷的累积效应也会在局部产生极高的电场,严重影响绝缘性能。为此,该文利用实验获得交联聚乙烯(XLPE)与硅橡胶(SR)电导率与电场强度的变化关系,基于Maxwell-Wagner(M-W)极化模型仿真研究了低电场极性反转下XLPE/SR双层介质中空间电荷与电场的分布特性。结果表明:室温下,SR的低电场电导率要高于XLPE,且SR电导率受电场强度的影响相对较小而XLPE则较大。由于界面电荷极性变化滞后于电压极性变化,极性反转期间界面处残留的负极性电荷造成SR中出现最大瞬态电场;电压极性反转越快,XLPE/SR界面残留的负极性电荷越多,SR中的最大瞬态电场强度越高;外施电压越高,由于SR与XLPE的电导率比值降低,SR中的最大瞬态电场畸变率越小。
服务
把本文推荐给朋友
加入我的书架
加入引用管理器
E-mail Alert
RSS
作者相关文章
宋柯
钱定冬
鲍国栋
王伟
齐佳乐
关键词 直流电缆附件极性反转电导率空间电荷电场畸变Maxwell-Wagner极化模型    
Abstract:As the key equipment of connecting the cable system, high voltage direct current (HVDC) cable accessory has become the weakest insulation point of the cable system due to the composite insulation composed of different dielectrics. Compared with cable body insulation of a single dielectric, the HVDC cable accessory of composite insulation is more easily to accumulate space charges at the interface due to the discontinuity of dielectric. In the line commutated converter high voltage direct current (LCC-HVDC) transmission system, the voltage polarity needs to be reversed when performing the power flow reversal adjustment, and cable accessories will withstand polarity reversal electric field. Although it is temporary, an extremely high electric field would be applied locally due to the cumulative effect of space charge, which threatens the safety of cable system.
Firstly, the conductivities of cross-linked polyethylene (XLPE) and silicone rubber (SR) under different electric fields were measured at room temperature. Then, fitting these experimental data, the conductivity model parameters of XLPE and SR could be obtained. Finally, the finite element method was used to study the space charge and electric field distribution characteristics of XLPE/SR under polarity reversal voltage based on the Maxwell-Wagner model. Furthermore, the effects of voltage reversal time and voltage amplitude on the interface charges and the maximal transient electric field were discussed.
The conductivity test results show that, the conductivity of SR is higher than XLPE within 14 kV/mm. As the field increases, the conductivity of XLPE shows an exponential growth trend and its change is obvious, while that of SR changes less and increases relatively slowly. Simulation results show that: Firstly, set the field to 5 kV/mm, voltage reversal time to 30 s and temperature to 25℃. When voltage reversal is completed, the residual negative charges at the interface enhance the field in the SR, which causes the maximal transient field reaches 8.06 kV/mm, and weaken the field in the XLPE, which reaches -1.14 kV/mm. The space charge and field distributions in the steady state before and after voltage inversion show a "mirror" distribution. Secondly, keep the temperature and field unchanged, when voltage reversal time is 5 s, 30 s, 90 s, the maximal transient field distortion rate in the SR is 63.82%, 61.30%, 55.18%, respectively. Thirdly, hold voltage reversal time and temperature unchanged, When voltage amplitude is 1.56 kV, 2.60 kV, 3.64 kV, the XLPE steady-state electric field distortion rate before voltage inversion is 125.55%, 110.38%, 90.31%, and that of SR is -85.40%, -74.28%, -59.56%,while the maximal transient field distortion rate in the SR is 71.78%, 61.29%, 46.59%, respectively.
The results show that: (1) The conductivity of SR is higher than XLPE. There is a clear difference in the conductivity properties of XLPE and SR as a function of electric field, which is one reason for the accumulation of interface charges. (2) Since interface charge polarity change lags voltage polarity change, the residual negative charge at the interface would cause the maximal transient field in the SR. (3) The shorter the reverse period, the more residual negative charge at the XLPE/SR interface, resulting in a higher maximal transient field in the SR. (4) As the applied voltage increases, The conductivity ratio of SR to XLPE decreases gradually, so the maximal transient field distortion rate in SR decreases with increasing electric filed.
Key wordsDC cable accessory    polarity reversal    conductivity    space charge    electric field distortion    Maxwell-Wagner model   
收稿日期: 2022-06-28     
PACS: TM85  
基金资助:国家自然科学基金资助项目(51377056)
通讯作者: 王伟, 男,1960年生,教授,博士生导师,研究方向为高电压绝缘技术、电气设备在线监测与故障诊断等。E-mail:wwei@ncepu.edu.cn   
作者简介: 宋柯, 男,1996年生,硕士研究生,研究方向为高压直流电缆绝缘空间电荷。E-mail:songke0513@163.com
引用本文:   
宋柯, 钱定冬, 鲍国栋, 王伟, 齐佳乐. 基于M-W极化模型的低电场极性反转下XLPE/硅橡胶空间电荷与电场分布特性研究[J]. 电工技术学报, 2023, 38(16): 4479-4488. Song Ke, Qian Dingdong, Bao Guodong, Wang Wei, Qi Jiale. Study on Space Charge and Field Distribution Characteristics of XLPE/SR under Low Electric Field Polarity Reversal Based on the M-W Model. Transactions of China Electrotechnical Society, 2023, 38(16): 4479-4488.
链接本文:  
https://dgjsxb.ces-transaction.com/CN/10.19595/j.cnki.1000-6753.tces.221231          https://dgjsxb.ces-transaction.com/CN/Y2023/V38/I16/4479