Modeling and Analysis of Segmented Long Primary Double-Sided Linear Induction Motor
Zhang Mingyuan1,2, Shi Liming1, Guo Keyu1,2, Yang Zeyu1, Xu Fei1
1. Key Laboratory of Power Electronics and Electric Drive Institute of Electrical Engineering Chinese Academy of Sciences Beijing 100190 China; 2. University of Chinese Academy of Sciences Beijing 100049 China
Abstract:Thesegmented long primary double-sided linear induction motor (LP-DSLIM) system is composed of several segments of unit motors powered in series or in parallel. To accurately describe the state change of unit motor and the transient process when passing through segments during secondary motion, a new mathematical model of unit motor and a segmented LP-DSLIM system model are proposed in this paper. Firstly, the characteristics of the segmented LP-DSLIM system are analyzed. By introducing the virtual secondary board, the secondary coupling of each unit motor is extended to the same length as the primary, so that the primary and secondary of the unit motor are always fully coupled. Then, the actual secondary flux linkage and primary flux linkage are obtained by combining with the coupling factor. The new unit motor mathematical model is derived, and the segmented LP-DSLIM system model is established. Finally, the proposed new unit motor mathematic model and segmented LP-DSLIM system model are verified by FEM calculation and experiments.
张明远, 史黎明, 郭科宇, 杨泽宇, 徐飞. 分段长初级双边直线感应电动机建模分析[J]. 电工技术学报, 2021, 36(11): 2344-2354.
Zhang Mingyuan, Shi Liming, Guo Keyu, Yang Zeyu, Xu Fei. Modeling and Analysis of Segmented Long Primary Double-Sided Linear Induction Motor. Transactions of China Electrotechnical Society, 2021, 36(11): 2344-2354.
[1] Bushway R R.Electromagnetic aircraft launch system development considerations[J]. IEEE Transactions on Magnetics, 2001, 37(1): 52-54. [2] Yang Tong, Zhou Libin, Li Langru.Influence of design parameters on end effect in long primary double-sided linear induction motor[J]. IEEE Transactions on Plasma Science, 2011, 39(1):192-197. [3] 曹瑞武,苏恩超,张学.轨道交通用次级分段型直线磁通切换永磁电机研究[J].电工技术学报,2020,35(5):1001-1012. Cao Ruiwu, Su Enchao, Zhang Xue.Investigation of linear flux-switching permanent magnet motor with segmented secondary for rail transit[J]. Transactions of China Electrotechnical Society, 2020,35(5):1001-1012. [4] 张志华, 史黎明, 李耀华. 栅格次级双边直线感应电机特性[J]. 电工技术学报, 2014, 29(3):103-110. Zhang Zhihua, Shi Liming, Li Yaohua.Characteristics of double sided linear induction motors withladder-slit type secondary[J]. Transactions of China Electrotechnical Society, 2014, 29(3): 103-110. [5] 鲁军勇, 马伟明, 李朗如. 高速长初级直线感应电动机纵向边端效应研究[J]. 中国电机工程学报, 2008, 28(30): 73-78. Lu Junyong, Ma Weiming, Li Langru.Research on longitudinal end effect of high speed long primary double-sided linear induction motor[J]. Proceedings of the CSEE, 2008, 28(30): 73-78. [6] 孙兆龙, 马伟明, 鲁军勇, 等. 长初级双边直线感应电动机静态纵向边端效应及阻抗矩阵研究[J]. 中国电机工程学报, 2010, 30(18): 72-77. Sun Zhaolong, Ma Weiming, Lu Junyong.Research of static longitudinal end effect and impedance matrix for long primary double-sided linear induction motors[J]. Proceedings of the CSEE, 2010, 30(18): 72-77. [7] 杨通, 周理兵. 长初级双边直线感应电机纵向动态端部效应第一部分:气隙磁场[J]. 电机与控制学报, 2014, 18(4):52-59. Yang Tong, Zhou Libing.Longitudinal dynamic end effect in long primary double-sided linear induction motor Part 1: airgap magnetic field[J]. Electric Machines and Control, 2014, 18(4): 52-59. [8] 杨通, 周理兵. 长初级双边直线感应电机纵向动态端部效应第二部分:性能计算[J]. 电机与控制学报, 2014, 18(8):67-74. Yang Tong, Zhou Libing.Longitudinal dynamic end effect in long primary double-sided linear induction motor Part 2: performance calculation[J]. Electric Machines and Control, 2014, 18(8): 67-74. [9] 任晋旗, 李耀华, 王珂. 动态边端效应补偿的直线感应电机磁场定向控制[J]. 电工技术学报, 2007, 22(12):61-65. Ren Jinqi, Li Yaohua, Wang Ke.Indirect field oriented control of linear induction withend effect compensation[J]. Transactions of China Electrotechnical Society, 2007, 22(12): 61-65. [10] 李卫超, 胡安, 马伟明, 等. 新型长定子直线感应电机闭环控制策略[J]. 中国电机工程学报, 2010, 030(z1): 226-231. Li Weichao, Hu An, Ma Weiming, et al.Control strategy of a novel double-sided long primary linear induction motor[J]. Proceedings of the CSEE, 2010, 30(z1): 226-231. [11] 王江波, 李耀华, 严陆光. 长初级双边直线电机高性能控制策略[J]. 电工技术学报, 2011, 26(5):126-131. Wang Jiangbo, Li Yaohua, Yan Luguang, et al.High performance control strategy for long primary double sided linear motors[J]. Transactions of China Electrotechnical Society, 2011, 26(5):126-131. [12] 陈晓,赵文祥,吉敬华,等. 考虑边端效应的双边直线永磁游标电机模型预测电流控制[J].电工技术学报,2019,34(1):49-57. Chen Xiao, Zhao Wenxiang, Ji Jinghua, et al.Model predictive current control of double-side linear vernier permanent magnet machines considering end effect[J]. Transactions of China Electrotechnical Society, 2019, 34(1): 49-57. [13] 许金, 马伟明, 鲁军勇, 等. 长定子直线感应电机饱和特性和非线性计算[J]. 电工技术学报, 2012, 27(9): 183-190. Xu Jin, Ma Weiming, Lu Junyong.Saturation characteristics analysis and nonlinear calculation methods of long-stator linear induction motors[J]. Transactions of China Electrotechnical Society, 2012, 27(9): 183-190. [14] 张千, 刘慧娟, 马杰芳, 等. 考虑后退行波的长初级双边直线感应电机电磁性能计算[J]. 电工技术学报, 2020, 35(7): 1398-1409. Zhang Qian, Liu Huijuan, Ma Jiefang, et al.Calculation of electromagnetic performance for long primary double sided linear induction motors considering backward traveling wave[J]. Transactions of China Electrotechnical Society, 2020, 35(7): 1398-1409. [15] 王明杰,徐伟,杨存祥,等.基于精确子域模型的永磁直线同步电机空载磁场解析计算[J].电工技术学报,2020,35(5):942-953. Wang Mingjie, Xu Wei, Yang Cunxiang, et al.Analytical calculation of no-load magnetic field in permanentmagnet linear synchronous motors based onan accurate subdomain model[J]. Transactions of China Electrotechnical Society, 2020,35(5):942-953. [16] 邸珺, 范瑜, 刘亚静. 基于等效次级的直线感应电机的电磁分析与参数辨识[J]. 电工技术学报, 2017, 32(11): 145-154. Di Jun, Fan Yu, Liu Yajing.Electromagnetic analysis and parameter estimation for the linearinduction motor based on equivalent secondary[J]. Transactions of China Electrotechnical Society, 2017, 32(11): 145-154. [17] 张明元, 马伟明, 何娜. 长初级直线电动机分段供电技术综述[J]. 中国电机工程学报, 2013, 33(27):96-104. Zhang Mingyuan, Ma Weiming, He Na.Application of block feeding methods in long primary linear motors[J]. Transactions of China Electrotechnical Society, 2013, 33(27): 96-104. [18] 马名中, 马伟明, 范慧丽, 等. 长初级直线感应电机分段供电切换暂态过程[J]. 电机与控制学报, 2015, 19(9): 1-7. Ma Mingzhong, Ma Weiming, Fan Huili, et al.Switch transient process of section powered long-primary linear induction motor[J]. Electric Machines and Control, 2015, 19(9): 1-7. [19] Sun Xiao, Shi Liming, Zhang Zhihua, et al.Thrust control of double sided linear induction motor with segmented power supply[J]. IEEE Transactions on Industrial Electronics, 2019, 66(6): 4891-4900. [20] 龙遐令. 直线感应电动机的理论和电磁设计方法[M].北京:科学出版社,2006. [21] 鲁军勇, 马伟明, 许金.高速长定子直线感应电动机的建模与仿真[J]. 中国电机工程学报, 2008, 28(27): 89-94. Lu Junyong, Ma Weiming, Xu Jin.Modeling and simulation of high speed long primary double-sided linear induction motor[J]. Proceedings of the CSEE, 2008, 28(27): 89-94. [22] 张明元, 马伟明, 徐兴华, 等. 一种考虑电流过零的直线电机分段供电策略[J]. 海军工程大学学报, 2019, 31(4): 11-16. Zhang Mingyuan, Ma Weiming, Xu Xinghua, et al.A block feeding strategy for linear motor considering switching at current-crossing point[J]. Journal of Naval University of Engineering, 2019, 31(4): 11-16. [23] 上官璇峰,励庆孚,袁世鹰.多段初级永磁直线同步电动机驱动系统整体建模和仿真[J].电工技术学报,2006, 21(3):52-57. Shangguan Xuanfeng, Li Qingfu, Yuan Shiying.Integrated modeling and simulation of the systems driven by multi-segment primary permanent linear synchronous motors[J]. Transactions of China Electrotechnical Society, 2006, 21(3):52-57. [24] 上官璇峰,励庆孚,袁世鹰. 多段初级永磁直线同步电动机系统建模及制动仿真[J]. 西安交通大学学报, 2006, 40(6):694-698. Shangguan Xuanfeng, Li Qingfu, Yuan Shiying.Modeling of the systems driven by multi-segment primary permanent magnet linear synchronous motor and the simulation of brake process[J]. Journal of Xi'an Jiaotong University, 2006, 40(6): 694-698. [25] 孙晓, 史黎明, 张志华, 等. 并联双边直线感应电机次级定向控制[J]. 中国电机工程学报, 2019, 39(4): 1181-1189. Sun Xiao, Shi Liming, Zhang Zhihua, et al.The secondary field oriented control of parallel connected double sided linear induction motor[J]. Proceedings of the CSEE, 2019, 39(4): 1181-1189. [26] Sun Xiao, Shi Liming, Zhang Zhihua, et al.A novel field oriented control for parallel-connected double-sided LIM[C]//2016 IEEE 8th International Power Electronics and Motion Control Conference (IPEMC-ECCE Asia),Hefei, 2016: 1894-1897.