Abstract:To improve the performance of switched reluctance generators at medium and low speeds,an off-line control parameters optimization method for switched reluctance generators is proposed in this paper.The maximum output power,the system efficiency and the torque smoothing coefficient are considered as the optimization objectives.The influences of turn-on angle,turn-off angle and reference current on each optimization objective are analyzed.The optimal control parameters of each single-objective optimization are obtained.Then,a multi-objective optimization function is determined with given weight coefficients to optimize control parameters.Finally,experimental results show that the optimal control parameters obtained by the proposed optimization method can improve the performance of switched reluctance generators at medium and low speeds.
颜爽,陈昊,王青,杨明扬. 开关磁阻发电机控制参数多目标优化研究[J]. 电工技术学报, 2017, 32(15): 66-75.
Yan Shuang, Chen Hao, Wang Qing, Yang Mingyang. Research on Multi-Objective Optimization of Control Parameters for Switched Reluctance Generators. Transactions of China Electrotechnical Society, 2017, 32(15): 66-75.
[1] Shen Lei,Wu Jianhua,Yang Shiyou,et al.Fast flux linkage measurement for switched reluctance motors excluding rotor clamping devices and position sensors[J].Instrumentation and Measurement,2013,62(1):185-191. [2] 蒯松岩,汤锐智,马金洋,等.基于电感模型的开关磁阻电机参数优化[J].电工技术学报,2015,30(7):97-104. Kuai Songyan,Tang Ruizhi,Ma Jinyang,et al.Parameter optimization of the switched reluctance motor based on the inductance model[J].Transactions of China Electrotechnical Society,2015,30(7):97-104. [3] 昝小舒,陈昊.基于自抗扰控制的开关磁阻电机转速闭环性能[J].电工技术学报,2012,27(7):17-25. Zan Xiaoshu,Chen Hao.Rotating speed closed loop study of switched reluctance motor based on auto disturbance rejection control[J].Transactions of China Electrotechnical Society,2012,27(7):17-25. [4] Choi D W,Byun S I,Cho Y H.A study on the maximum power control method of switched reluctance generator for wind turbine[J].IEEE Transactions on Magnetics,2014,50(1):1-4. [5] 王喜莲,王旭东.开关磁阻电机角度最优控制[J].电机与控制学报,2006,10(6):588-591. Wang Xilian,Wang Xudong.Angles optimal control of switched reluctance motor[J].Electric Machines and Control,2006,10(6):588-591. [6] 熊立新,高厚磊,徐丙垠.开关磁阻发电机最大输出功率的控制原则[J].电机与控制学报,2009,13(2):250-254. Xiong Lixin,Gao Houlei,Xu Binggen.Control principles of switched reluctance generator for maximum output power[J].Electric Machines and Control,2009,13(2):250-254. [7] 朱学忠,刘闯,刘迪吉.开关磁阻电机发电运行的角度位置控制[J].南京航空航天大学学报,2001,33(1):64-67. Zhu Xuezhong,Liu Chuang,Liu Diji.Angle position control of switched reluctance generator[J].Journal of Nanjing University of Aeronautics & Astronautics,2001,33(1):64-67. [8] Brauer H J,Hennen M D,De Doncker R W.Control for polyphase switched reluctance machines to minimize torque ripple and decrease ohmic machine losses[J].IEEE Transactions on Power Electronics,2012,27(1):370-378. [9] 王宏华.开关磁阻电动机调速控制技术[M].北京:机械工业出版社,2002. [10]陈昊,谢桂林.开关磁阻发电机系统研究[J].电工技术学报,2001,16(6):7-12. Chen Hao,Xie Guilin.Research on the switched reluctance generator system[J].Transactions of China Electrotechnical Society,2001,16(6):7-12. [11]陈昊.开关磁阻调速电动机的原理设计应用[M].徐州:中国矿业大学出版社,2000. [12]卢胜利,陈昊,昝小舒.开关磁阻电机功率变换器的故障诊断与容错策略[J].电工技术学报,2009,24(11):199-206. Lu Shengli,Chen Hao,Zan Xiaoshu.Fault diagnosis and fault-Tolerant control strategy for power converter of switched reluctance motor[J].Transactions of China Electrotechnical Society,2009,24(11):199-206. [13]窦宇宇,杨明扬,赵仁明,等.开关磁阻风力发电系统最大功率追踪方法研究[J].电气传动,2016,46(5):38-43. Dou Yuyu,Yang Mingyang,Zhao Renming,et al.Study on control mode of maximum power point track for wind power generating system using switched reluctance generator[J].Electric Drive,2016,46(5):38-43. [14]Xue X D,Cheng K W E,Lin J K,et al.Optimal control method of motoring operation for SRM drives in electric vehicles[J].IEEE Transactions on Vehicular Technology,2010,59(3):1191-1204. [15]朱曰莹,赵桂范,杨娜.电动汽车用开关磁阻电机驱动系统设计及优化[J].电工技术学报,2014,29(11):88-98. Zhu Yueying,Zhao Guifan,Yang Na.Design and optimization for switched reluctance motor drive system in electric vehicles[J].Transactions of China Electrotechnical Society,2014,29(11):88-98.