Calculation Method of Wind Turbine Output Power under Clean and Icing Conditions Verified by Field Tests
Shu Lichun1, Yu Zhou1, Li Hantao2, Hu Qin1, Jiang Xingliang1
1. Xuefeng Mountain Energy Equipment Safety National Observation and Research Station of Chongqing University Chongqing 400044 China; 2. China Electric Power Research Institute Beijing 100192 China
Abstract:Wind energy resources are abundant in high-altitude areas, but wind turbines built here suffer serious icing problems. The accumulated ice will destroy the original aerodynamic structure of wind turbine blades, resulting in output power loss, which has bad influences on the power supply quality. Understanding the influences of different icing cases on the output power is helpful for the power department to carry out reasonable power dispatching during icing season. Therefore, a method for calculating the output power of wind turbine under clean and icing conditions was proposed. The proposed method is based on the Blade Element Momentum (BEM) theory and this theory ignores the variation of flow field along the wind turbine blades, which could increase efficiency by reducing computation time. To improve the calculation accuracy and make the calculation results more fit the actual condition, empirical formulas were introduced to correct the axial inducing factor, the tangential inducing factor, and attack angle. Because the accumulated ice changes the original aerodynamic structure of the wind turbine blades, the 2D CFD simulation based on commercial software Fluent was introduced to obtain the lift and drag coefficients of iced blade elements. Considering the influences of wind turbine structural parameters, different coordinate systems were established to correct the relative wind velocity working on the blade rotation plan. Because the contribution of one-third length blade near tip to output power reaches 90%, the proposed calculation method ignores the contribution of blade root on output power to save the computation time. To verify the accuracy and feasibility of the calculation method, field tests of the NREL S819 type wind turbine under clean and icing conditions were carried out in Xuefeng Mountain Energy Equipment Safety National Observation and Research Station. Under the icing condition, the uniform and streamline ice was chosen as the research object. Comparing the calculated results and test measured results, it is found that: (1) When the wind velocity is less than 11 m/s under clean or icing condition, the calculation method can accurately calculate the output power of wind turbine, which is in good agreement with the test measured results. (2) When the wind velocity exceeds 11 m/s, the differences between calculated results and test measured results increase gradually, and this is because the wind speed fluctuates fast and the fluctuation range is large during the field test. The maximum relative errors between two of them under clean and icing conditions are 10% and 14.1% respectively, which meet the engineering application error requirements. Based on this method, the key aerodynamic parameters along wingspan direction under different wind velocity were calculated. Results showed that: (1) The ice on wind turbine blades will decrease the axial and tangential inducing factor, which indicates that it could reduce the rotational torque of blades. (2) Icing could reduce the tangential and normal force, and the effects of icing become more pronounced as wind velocity increases. (3) The attenuation of tangential and normal force is obvious near the blade tip, which indicates that the ice will reduce the utilization of wind energy near blade tip more easily.
舒立春, 于周, 李瀚涛, 胡琴, 蒋兴良. 洁净与覆冰条件下风力发电机输出功率计算方法及现场试验验证[J]. 电工技术学报, 2023, 38(11): 3041-3051.
Shu Lichun, Yu Zhou, Li Hantao, Hu Qin, Jiang Xingliang. Calculation Method of Wind Turbine Output Power under Clean and Icing Conditions Verified by Field Tests. Transactions of China Electrotechnical Society, 2023, 38(11): 3041-3051.
[1] 颜湘武, 王德胜, 杨琳琳, 等. 直驱风机惯量支撑与一次调频协调控制策略[J]. 电工技术学报, 2021, 36(15): 3282-3292. Yan Xiangwu, Wang Desheng, Yang Linlin, et al.Coordinated control strategy of inertia support and primary frequency regulation of PMSG[J]. Transactions of China Electrotechnical Society, 2021, 36(15): 3282-3292. [2] 陆秋瑜, 马千里, 魏韡, 等. 基于置信容量的风场配套储能容量优化配置[J]. 电工技术学报, 2022, 37(23): 5901-5910. Lu Qiuyu, Ma Qianli, Wei Wei, et al.Optimal configuration of energy storage parameters based on confidence capacity of wind farms[J]. Transactions of China Electrotechnical Society, 2022, 37(23): 5901-5910. [3] 徐海亮, 吴瀚, 李志, 等. 低短路比电网下含负序控制双馈风机稳定性研究的几个关键问题[J]. 电工技术学报, 2021, 36(22): 4688-4702. Xu Hailiang, Wu Han, Li Zhi, et al.Several key issues on stability study of DFIG-based wind turbines with negative sequence control during low short-circuit ratio power grids[J]. Transactions of China Electrotechnical Society, 2021, 36(22): 4688-4702. [4] 朱东海, 邹旭东, 胡家兵, 等. 双馈风电机组无撬棒故障穿越技术研究综述[J]. 电工技术学报, 2022, 37(19): 4895-4910. Zhu Donghai, Zou Xudong, Hu Jiabing, et al.Review of crowbarless fault ride through technology for doubly-fed induction generator-based wind turbines[J]. Transactions of China Electrotechnical Society, 2022, 37(19): 4895-4910. [5] 符杨, 张耀楠, 刘璐洁, 等. 海上风电场维护任务动态调度策略[J]. 电力系统自动化, 2021, 45(21): 48-56. Fu Yang, Zhang Yaonan, Liu Lujie, et al.Dynamic dispatching strategy for maintenance tasks of offshore wind farm[J]. Automation of Electric Power Systems, 2021, 45(21): 48-56. [6] 胡琴, 王欢, 邱刚, 等. 风力发电机叶片覆冰量化分析及其应用[J]. 电工技术学报, 2022, 37(21): 5607-5616. Hu Qin, Wang Huan, Qiu Gang, et al.Quantitative analysis of wind turbine blade icing and its application[J]. Transactions of China Electrotechnical Society, 2022, 37(21): 5607-5616. [7] 龚妙, 李录平, 刘瑞, 等. 风力机叶片覆冰状态监测基准值与分级诊断标准研究[J]. 太阳能学报, 2021, 42(2): 172-178. Gong Miao, Li Luping, Liu Rui, et al.Research on ice accretion conditon monitoring reference value and grading diagnosis standard of wind turbine blades[J]. Acta Energiae Solaris Sinica, 2021, 42(2): 172-178. [8] Parent O, Ilinca A.Anti-icing and de-icing techniques for wind turbines: critical review[J]. Cold Regions Science and Technology, 2011, 65(1): 88-96. [9] Drapalik M, Zajicek L, Purker S.Ice aggregation and ice throw from small wind turbines[J]. Cold Regions Science and Technology, 2021, 192: 103399. [10] Dierer S, Oechslin R, Cattin R.Wind turbines in icing conditions: performance and prediction[J]. Advances in Science and Research, 2011, 6(1): 245-250. [11] Pérez J M P, Márquez F P G, Hernández D R. Economic viability analysis for icing blades detection in wind turbines[J]. Journal of Cleaner Production, 2016, 135: 1150-1160. [12] Gao Linyue, Hu Hui.Wind turbine icing characteristics and icing-induced power losses to utility-scale wind turbines[J]. Proceedings of the National Academy of Sciences of the United States of America, 2021, 118(42): e2111461118. [13] 梁健, 舒立春, 胡琴, 等. 风力机叶片雨淞覆冰的三维数值模拟及试验研究[J]. 中国电机工程学报, 2017, 37(15): 4430-4436, 4584. Liang Jian, Shu Lichun, Hu Qin, et al.3-D numerical simulations and experiments on glaze ice accretion of wind turbine blades[J]. Proceedings of the CSEE, 2017, 37(15): 4430-4436, 4584. [14] Jin J Y, Virk M S, Hu Qin, et al.Study of ice accretion on horizontal axis wind turbine blade using 2D and 3D numerical approach[J]. IEEE Access, 2020, 8: 166236-166245. [15] Shu Lichun, Li Hantao, Hu Qin, et al.3D numerical simulation of aerodynamic performance of iced contaminated wind turbine rotors[J]. Cold Regions Science and Technology, 2018, 148: 50-62. [16] Akhloufi M, Benmesbah N.Outdoor ice accretion estimation of wind turbine blades using computer vision[C]//2014 Canadian Conference on Computer and Robot Vision, Montreal, QC, Canada, 2014: 246-253. [17] Hochart C, Fortin G, Perron J, et al.Wind turbine performance under icing conditions[J]. Wind Energy, 2008, 11(4): 319-333. [18] Wilson R E, Lissaman P B S, Walker S N. Aerodynamic performance of wind turbines[R]. Energy Research and Development Administration, 1976. [19] Hansen M O L. 风力发电机空气动力学[M]. 肖劲松,译. 2版. 北京:中国电力出版社, 2009. [20] 韩巧丽, 马广兴. 风力发电原理与技术[M]. 北京: 中国轻工业出版社, 2018. [21] 李岩, 王绍龙, 冯放. 风力机结冰与防除冰技术[M]. 北京: 中国水利水电出版社, 2017. [22] 蔡新, 潘盼, 朱杰. 风力发电机叶片[M]. 北京: 中国水利水电出版社, 2014.