Analytical Modeling and Analysis of Disk Type Permanent Magnet Eddy-Current Driver
Shi Tongyu1, Wang Dazhi1, Shi Songning1, Zhang Guangru2
1. School of Information Science & Engineering Northeastern University Shenyang 110004 China ; 2. State Grid Gansu Electric Power Research Institute Lanzhou 730050 China
Abstract:Analytical models are widely used in analysis and designing of many permanent magnet or eddy-current-based appliances by providing more mechanistic solutions. According to the equivalent magnetic circuit method, this paper established the analytical model of the disk type eddy-current driver. Magnetic flux leakage and magnetic conductivity of each part of disk type eddy-current driver were calculated firstly. Then the transmit torque was calculated, and the relationship between the torque and the parameters was carried out. The results after 3D corrections were compared with the results of finite element method and experimental data. FE results and experimental results verify the analytical model. It is meaningful for the modeling and its optimization of the disk type eddy-current driver.
时统宇, 王大志, 石松宁, 张光儒. 盘式永磁涡流驱动器解析建模和分析[J]. 电工技术学报, 2017, 32(2): 153-160.
Shi Tongyu, Wang Dazhi, Shi Songning, Zhang Guangru. Analytical Modeling and Analysis of Disk Type Permanent Magnet Eddy-Current Driver. Transactions of China Electrotechnical Society, 2017, 32(2): 153-160.
[1] Wallace A, Von Jouanne A. Industrial speed control: are PM couplings an alternative to VFDs?[J]. IEEE Industry Applications Magazine, 2001, 7(5): 57-63. [2] 叶乐志, 李德胜. 基于有限元法的永磁缓速器涡流场分析[J]. 北京工业大学学报, 2011, 36(12): 1613-1617. Ye Lezhi, Li Desheng. Eddy current field analysis in permanent magnet retarder based on finite element method[J]. Journal of Beijing University of Tech- nology, 2011, 36(12): 1613-1617. [3] 王旭, 王大志. 永磁调速器的磁路结构设计[J]. 电气传动, 2011, 41(10): 55-58. Wang Xu, Wang Dazhi. Magnetic circuit structural design of permanent magnetic driver[J]. Electric Drive, 2011, 41(10): 55-58. [4] 秦伟, 范瑜, 马育华, 等. 盘式永磁Halbach悬浮装置的磁场和力特性分析[J]. 电机与控制学报, 2012, 16(6): 57-62. Qin Wei, Fan Yu, Ma Yuhua, et al. Characteristic and magnetic field analysis of disc Halbach permanent magnets maglev device[J]. Electric Machines & Control, 2012, 16(6): 57-62. [5] Shin H J, Choi J Y, Cho H W, et al. Analytical torque calculations and experimental testing of permanent magnet axial eddy current brake[J]. IEEE Transa- ctions on Magnetics, 2013, 49(7): 4152-4155. [6] Salon S J, Tukenmez-Ergene L, Wendling P F. 3D transient magnetic modeling of braking torque in a rotating conducting disc[C]//International Electric Machines and Drives Conference (IEMDC), Cambridge, MA, 2001: 188-191. [7] Albertz D, Dappen S, Henneberger G. Calculation of the 3D nonlinear eddy current field in moving condu- ctors and its application to braking systems[J]. IEEE Transactions on Magnetics, 1996, 32(3): 768-771. [8] Razavi H K, Lampérth M U. Eddy-current coupling with slotted conductor disk[J]. IEEE Transactions on Magnetics, 2006, 42(3): 405-410. [9] Choi J Y, Jang S M. Analytical magnetic torque calculations and experimental testing of radial flux permanent magnet-type eddy current brakes[J]. Journal of Applied Physics, 2012, 111(7): 335-345. [10] Amati N, Tonoli A, Canova A, et al. Dynamic behavior of torsional eddy-current dampers: sensiti- vity of the design parameters[J]. IEEE Transactions on Magnetics, 2007, 43(7): 3266-3277. [11] Wang J, Lin H, Fang S, et al. A general analytical model of permanent magnet eddy current couplings[J]. IEEE Transactions on Magnetics, 2014, 50(1): 1-9. [12] Mohammadi S, Mirsalim M, Vaez-Zadeh S. Non- linear modeling of eddy-current couplers[J]. IEEE Transactions on Energy Conversion, 2014, 29(1): 224-231. [13] 薛毓强, 吴金龙. 基于分布参数磁路模型的永磁接触器吸力特性[J]. 电工技术学报, 2014, 29(7): 222-228. Xue Yuqiang, Wu Jinlong. Study of attractive force characteristics based on magnetic distributed para- meter circuit model of permanent magnet con- tactors[J]. Transactions of China Electrotechnical Society, 2014, 29(7): 222-228. [14] 罗战强, 梁得亮. 新型双余度永磁无刷电机稳态特性的等效磁路模型[J]. 电工技术学报, 2014, 29(5): 84-92. Luo Zhanqiang, Liang Deliang. Equivalent magnetic circuit analysis model of the steady state characteri- stics for the novel dual-redundancy permanent magnet brushless machine[J]. Transactions of China Electrotechnical Society, 2014, 29(5): 84-92. [15] 陈浈斐, 夏长亮, 王慧敏. 考虑齿槽效应的表贴式永磁电机空载磁场建模[J]. 电工技术学报, 2014, 29(5): 9-16. Chen Zhenfei, Xia Changliang, Wang Huimin. Modeling for open circuit magnetic field prediction in slotted surface-mounted permanent-magnet machine[J]. Transactions of China Electrotechnical Society, 2014, 29(5): 9-16. [16] Qu R, Lipo T A. Analysis and modeling of air-gap and zigzag leakage fluxes in a surface-mounted permanent-magnet machine[J]. IEEE Transactions on Industry Applications, 2004, 40(1): 121-127. [17] 宫晓, 徐衍亮. 轴向磁场盘式永磁电机等效磁路网络及气隙漏磁的分析计算[J]. 电机与控制学报, 2013, 17(10): 59-64. Gong Xiao, Xu Yanliang. Lumped parameter magnetic circuit analysis of axial flux permanent magnet motor and its analytical calculation of air gap leakage[J]. Electric Machines and Control, 2013, 17(10): 59-64. [18] Mohammadi S, Mirsalim M, Vaez-Zadeh S, et al. Analytical modeling and analysis of axial-flux interior permanent-magnet couplers[J]. IEEE Transactions on Industrial Electronics, 2014, 61(11): 5940-5947. [19] Lequesne B, Liu B, Nehl T W. Eddy-current machines with permanent magnets and solid rotors[J]. IEEE Transactions on Industry Applications, 1997, 33(5): 1289-1294. [20] 张青山, 段建东, 叶兵, 等. 基于电接触元件暂态热路建模的接触电阻测量研究[J]. 电力系统保护与控制, 2014, 42(15): 27-33. Zhang Qingshan, Duan Jiandong, Ye Bing, et al. Research of measuring contact resistance based on the electrical contact transient thermal circuit model[J]. Power System Protection and Control, 2014, 42(15): 27-33. [21] 褚建峰, 孟向军. 直流SMC铁心高温超导故障限流器的研究[J]. 电力系统保护与控制, 2014, 42(13): 59-63. Chu Jianfeng, Meng Xiangjun. Study of DC high temperature superconducting fault current limiter using soft magnetic composites[J]. Power System Protection and Control, 2014, 42(13): 59-63. [22] Canova A, Vusini B. Design of axial eddy-current couplers[J]. IEEE Transactions on Industry App- lications, 2003, 39(3): 725-733.