电工技术学报  2023, Vol. 38 Issue (4): 945-956    DOI: 10.19595/j.cnki.1000-6753.tces.220020
电机及其系统 |
基于分段交错不等磁极的表贴式永磁电机极频振动的削弱
李泽星1, 夏加宽1, 刘铁法2, 郭志研1, 朱启升1
1.沈阳工业大学电气工程学院 沈阳 110870;
2.中国科学院沈阳自动化研究所 沈阳 110169
Reduction of Pole-Frequency Vibration of Surface-Mounted Permanent Magnet Synchronous Machines with Piecewise Stagger Unequal Poles
Li Zexing1, Xia Jiakuan1, Liu Tiefa2, Guo Zhiyan1, Zhu Qisheng1
1. School of Electrical Engineering Shenyang University of Technology Shenyang 110870 China;
2. Shenyang Institute of Automation Chinese Academy of Science Shenyang 110169 China
全文: PDF (8858 KB)   HTML
输出: BibTeX | EndNote (RIS)      
摘要 针对表贴式永磁同步电机极频振动,提出一种分段交错不等磁极的削弱方法,与传统的优化方法相比,该方法可有效保证电机的转矩密度。首先,基于麦克斯韦张量法,推导作用于定子齿部的集中力模型,并以一台10极12槽表贴式永磁电机为例,分析极频电磁力谐波的产生原因。其次,基于有限元模型,分析分段交错不等磁极对极倍频电磁力谐波的削弱机理,并对比优化前后电机的关键电磁性能以及振动频谱。结果表明,分段交错不等磁极结构可在保证转矩密度的前提下,有效削弱极频电磁力谐波及振动。最后,对优化前后的样机进行振动实验,验证了优化方案的有效性。
服务
把本文推荐给朋友
加入我的书架
加入引用管理器
E-mail Alert
RSS
作者相关文章
李泽星
夏加宽
刘铁法
郭志研
朱启升
关键词 表贴式永磁同步电机极频振动分段交错不等磁极有限元模型    
Abstract:The permanent-magnet synchronous machines (PMSMs) are the most attractive candidates used as power sources for underwater vehicles due to their inherent high efficiency and high power density. However, as essential performance for underwater vehicles, concealment is vulnerable to low-frequency vibration and noise caused by PMSMs.
In the low-frequency domain, the pole-frequency vibration plays a significant vibroacoustic role for PMSMs. The frequency is equal to the multiplication of pole number and mechanical rotation frequency and twice the source frequency. The pole-frequency radial force harmonic is the strongest component among different frequency harmonics. It is closely related to the fundamental magnetic field, which leads to the common and significant existence of pole-frequency vibration in PMSMs with different combinations of pole and slot numbers. Therefore, it is necessary to analyze and weaken the pole-frequency vibration.
This paper proposes a weakening method of the piecewise stagger unequal poles. The magnetic poles are equally divided into two sections in the axial direction, and the zero-crossing region of the two-section structures is offset in the circumferential direction.
Based on the finite element model, the radial force, tangential force, and main electromagnetic parameters of the common motor with and without an optimized structure are calculated and compared.
The radial force density curves and their FFT results of the two motors are calculated. Compared with the common motor, the fluctuation range of radial force density of the proposed motor is significantly reduced, and the amplitudes of the main harmonics of 2f, 4f, and 6f are decreased.
The radial force curves and their FFT results of the two motors are calculated. Compared with the common motor, the amplitude of the 2nd, 4th, and 6th harmonics drops by 52 %, 47 %, and 75 % for the proposed motor, respectively.
The tangential force density curves of the two motors are calculated. Compared with the common motor, the peak-to-peak value of the tangential force density is reduced by 18 % for the proposed motor.
The electromagnetic torques of the two motors are simulated and compared on load. The average torques of two motors are 4.21 N·m and 4.20 N·m, respectively, and the torque density of the proposed motor is unchanged.
The vibration acceleration spectra of the two motors at rated speeds are simulated and compared. The main frequency points include 2f, 4f, and 6f, and the amplitudes of the vibration acceleration at 2f is largest. Compared with the common motor, the acceleration amplitude of the proposed motor at 2f decreases from 0.689 m/s2 to 0.341 m/s2.
In order to verify the validity of the analysis and the simulated results, the two prototypes are manufactured, and their vibration experiments are carried out. The trends of the simulated and measured results are consistent. Compared with the common motor, the amplitudes of the vibration acceleration at 2f, 4f, and 6f are reduced significantly for the proposed motor.
The relationship between the torque and current of the two motors is measured. When the phase current reaches the rated current, the average torques of the common and proposed motors are 4.22 N·m and 4.20 N·m, respectively. Therefore, the optimized structure of the piecewise stagger unequal poles can effectively reduce the pole-frequency vibration while ensuring the torque density.
Key wordsSurface-mounted permanent magnet synchronous machines    pole-frequency vibration    piecewise stagger unequal poles    finite element model (FEM)   
收稿日期: 2021-01-05     
PACS: TM351  
基金资助:国家自然科学基金(52077142)、国家自然科学基金(52177054)和沈阳市中青年科技创新人才支持计划(RC210213)资助项目
通讯作者: 李泽星 男,1992年生,博士研究生,研究方向为永磁电机振动噪声分析及抑制。E-mail: lzxsut@qq.com   
作者简介: 夏加宽 男,1962年生,教授,博士生导师,研究方向为永磁电机设计及其控制。E-mail: sygdxjk@163.com
引用本文:   
李泽星, 夏加宽, 刘铁法, 郭志研, 朱启升. 基于分段交错不等磁极的表贴式永磁电机极频振动的削弱[J]. 电工技术学报, 2023, 38(4): 945-956. Li Zexing, Xia Jiakuan, Liu Tiefa, Guo Zhiyan, Zhu Qisheng. Reduction of Pole-Frequency Vibration of Surface-Mounted Permanent Magnet Synchronous Machines with Piecewise Stagger Unequal Poles. Transactions of China Electrotechnical Society, 2023, 38(4): 945-956.
链接本文:  
https://dgjsxb.ces-transaction.com/CN/10.19595/j.cnki.1000-6753.tces.220020          https://dgjsxb.ces-transaction.com/CN/Y2023/V38/I4/945