SiC逆变器驱动感应电机的高频脉振注入无速度传感器控制

doi:10.19595/j.cnki.1000-6753.tces.250178

Abstract
Figure/Table
References
Related Citation (15)

Download: PDF (10183 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract The salient-pole characteristics and rotor position estimation error pose challenges in the sensor less control system of induction motors (IMs) based on the high-frequency pulsating injection (HFPI) method at low speeds, ultimately compromising the reliability and stability of motor operation. Based on the high switching frequency characteristic of the silicon carbide (SiC) inverter, increasing the frequency of the injection voltage thus enhances the saturated salient pole of the IM. To mitigate the rotor position estimation error caused by the deadtime of the inverter, this paper leverages the high switching speed of SiC devices and a harmonic suppression method based on a second-order generalized integrator (SOGI) to improve the accuracy of rotor position estimation.
According to the skin effect, the influence of different injection frequencies of the SiC inverter on the rotor bar of the IM is analyzed, where the high-frequency inductance varies with the injection frequency due to changes in the distribution of magnetic lines within the rotor bar. Then, based on this, the relationship between the high-frequency inductances of the d-q coordinate axis and different injection frequencies in the field-oriented control system of the IM is constructed by the finite element method. Finally, based on the improved measurement method of high-frequency inductance in the d-q coordinate axis, it effectively verified that the high injection frequency can enhance the saturated salient pole of the IM.
By the traditional method for extracting rotor position information, the relationship between the dead time and the rotor position estimation error is derived. Based on the high switching speed of the SiC inverter, setting a short dead time can reduce the 6k th harmonic in rotor position estimation. To mitigate the influence of the 6th harmonic, a specific harmonic elimination scheme based on SOGI is proposed toenhance theaccuracy of rotor position estimation. Additionally, to prevent the influence of SOGI parameter mismatch on the suppression effect, the parameter k needs to be selected reasonably to improve the low-speed performance under both dynamic and static conditions.
To validate the effectiveness of sensorless control using the HFPI method for IMs at low speeds based on SiC inverters, a 7.5 kW SiC inverter-based IM test platform was set up. Experimental results demonstrate that the HFPI method, implemented with SiC inverters, enhances the low-speed operational performance of the IM. The saturated salient-pole measurement tests were conducted to verify the effectiveness of high injection frequency in enhancing the saturated salient pole of the IM. As observed in the current spectrum, the main salient pole of the injection frequency of 1 600 Hz exhibits a 37.67% greater amplitude compared to that of 500 Hz. Additionally, to verify the impact of high switching speed on the rotor estimation error, the dead time of the SiC inverter was adjusted to test the accuracy of rotor position estimation. Analysis of the speed spectrum at a 16 kHz switching frequency reveals that a 0.5 μs dead time reduces the 6th harmonic component by 25% compared to a 2 μs dead time. Combining the specific harmonic suppression algorithm based on SOGI can further reduce the speed estimation error. These experimental results have confirmed that in the HFPI method, the IM driven by the SiC inverter can enhance the reliability and accuracy of rotor position estimation at low speeds.

Key words： Silicon carbide (SiC) induction motor (IM) saturated salient pole high-frequency pulsating injection rotor position estimation

Received: 31 January 2025

PACS:	TM46
	TM34

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	Bian Xiaoliang
	Yuan Xibo
	Chen Shuo
	Wang Kai
	Zhao Chuanjie

Cite this article:

Bian Xiaoliang,Yuan Xibo,Chen Shuo等. Sensorless Control of SiC Inverter-Driven Induction Motors Using High-Frequency Pulsating Injection Method[J]. Transactions of China Electrotechnical Society, 2025, 40(22): 7289-7300.

URL:

https://dgjsxb.ces-transaction.com/EN/10.19595/j.cnki.1000-6753.tces.250178 OR https://dgjsxb.ces-transaction.com/EN/Y2025/V40/I22/7289

[1] 杨凯, 王雨洁, 罗成, 等. 基于特征值分布的无传感器感应电机低速发电区域稳定性提升策略[J]. 电工技术学报, 2025, 40(18): 5907-5917.
Yang Kai, Wang Yujie, Luo Cheng, et al.Eigenvalue-distribution-based stability enhancement strategy of speed-sensorless induction motor in low-speed regenerating region[J]. Transactions of China Electrotechnical Society, 2025, 40(18): 5907-5917.
[2] 赵琨, 宋宝, 唐小琦, 等. 基于扩张滑模-锁相环的感应电机无速度传感器矢量控制[J]. 中国电机工程学报, 2024, 44(20): 8270-8279.
Zhao Kun, Song Bao, Tang Xiaoqi, et al.Senseless vector control method for induction motor based on extended sliding mode and phase locked loop[J]. Proceedings of the CSEE, 2024, 44(20): 8270-8279.
[3] 左运, 葛兴来, 李松涛, 等. 基于改进型q-PLL的牵引电机无速度传感器控制[J]. 中国电机工程学报, 2021, 41(1): 383-392, 427.
Zuo Yun, Ge Xinglai, Li Songtao, et al.Speed sensorless control of traction motor based on the improved q-PLL[J]. Proceedings of the CSEE, 2021, 41(1): 383-392, 427.
[4] 杨凯, 李孺涵, 罗成, 等. 负载变化下无传感器感应电机主动零频穿越及脉动抑制策略[J]. 电工技术学报, 2023, 38(18): 4910-4920.
Yang Kai, Li Ruhan, Luo Cheng, et al.Proactive low-frequency ride-through method and its ripple reduction for sensorless induction motor drives under load variations[J]. Transactions of China Electro-technical Society, 2023, 38(18): 4910-4920.
[5] 王建渊, 李英杰, 景航辉, 等. 基于静止轴系改进高频方波注入同步磁阻电机无传感器控制[J]. 电工技术学报, 2024, 39(12): 3658-3669.
Wang Jianyuan, Li Yingjie, Jing Hanghui, et al.Sensorless control of high frequency square wave injection synchronous reluctance motor based on static axis system improvement[J]. Transactions of China Electrotechnical Society, 2024, 39(12): 3658-3669.
[6] Jansen P L, Lorenz R D.Transducerless field orientation concepts employing saturation-induced saliencies in induction machines[J]. IEEE Transa-ctions on Industry Applications, 1996, 32(6): 1380-1393.
[7] Mingardi D, Bianchi N, Alberti L, et al.Analysis and test of the sensorless capability of induction motors with created saliency[J]. IEEE Transactions on Industry Applications, 2016, 52(3): 2186-2193.
[8] Lee J H, Kwon Y C, Sul S K.Skin effect of squirrel cage induction motor under high-frequency signal injection[C]//2021 IEEE Energy Conversion Congress and Exposition (ECCE), Vancouver, BC, Canada, 2021: 4737-4742.
[9] Zatocil H.Physical understanding of multiple saliencies in induction motors and their impact on sensorless control[C]//2008 International Symposium on Power Electronics, Electrical Drives, Automation and Motion, Ischia, Italy, 2008: 1503-1508.
[10] 刘海东, 周波, 郭鸿浩, 等. 脉振高频信号注入法误差分析[J]. 电工技术学报, 2015, 30(6): 38-44.
Liu Haidong, Zhou Bo, Guo Honghao, et al.Error analysis of high frequency pulsating signal injection method[J]. Transactions of China Electrotechnical Society, 2015, 30(6): 38-44.
[11] 魏海峰, 韦汉培, 张懿. 考虑逆变器输出谐波的永磁同步电机转子位置估计误差分析[J]. 电工技术学报, 2018, 33(4): 900-909.
Wei Haifeng, Wei Hanpei, Zhang Yi.Error analysis of rotor position estimation for permanent magnet synchronous motor considering output harmonics of inverter[J]. Transactions of China Electrotechnical Society, 2018, 33(4): 900-909.
[12] 刘计龙, 付康壮, 麦志勤, 等. 基于双频陷波器的改进型高频脉振电压注入无位置传感器控制策略[J]. 中国电机工程学报, 2021, 41(2): 749-759.
Liu Jilong, Fu Kangzhuang, Mai Zhiqin, et al.Sensorless control strategy of improved HF pulsating voltage injection based on dual frequency notch filter[J]. Proceedings of the CSEE, 2021, 41(2): 749-759.
[13] 郑丹, 温旭辉, 范涛, 等. 高环境温度高功率密度SiC电机驱动控制器设计与实现[J]. 电工技术学报, 2025, 40(15): 4889-4904.
Zheng Dan, Wen Xuhui, Fan Tao, et al.Design and implementation of SiC motor drive controller with high environmental temperature and high power density[J]. Transactions of China Electrotechnical Society, 2025, 40(15): 4889-4904.
[14] Lopez O, Guo Zhehui, Ordonez J, et al.A high power density SiC motor drive for a 6-phase PMSM[C]//2023 IEEE Applied Power Electronics Conference and Exposition (APEC), Orlando, FL, USA, 2023: 3182-3187.
[15] 张少昆, 孙微, 范涛, 等. 基于分立器件并联的高功率密度碳化硅电机控制器研究[J]. 电工技术学报, 2023, 38(22): 5999-6014.
Zhang Shaokun, Sun Wei, Fan Tao, et al.Research on high power density silicon carbide motor controller based on parallel connection of discrete devices[J]. Transactions of China Electrotechnical Society, 2023, 38(22): 5999-6014.
[16] 王震宇, 孙伟, 蒋栋. 基于虚拟电压注入的闭环磁链观测器的感应电机无速度传感器矢量控制系统[J]. 电工技术学报, 2022, 37(2): 332-343.
Wang Zhenyu, Sun Wei, Jiang Dong.Induction motor speed sensorless vector control system based on closed-loop flux observer with virtual voltage injection[J]. Transactions of China Electrotechnical Society, 2022, 37(2): 332-343.
[17] Boglietti A, Cavagnino A, Lazzari M.Computational algorithms for induction motor equivalent circuit parameter determination: part II: skin effect and magnetizing characteristics[J]. IEEE Transactions on Industrial Electronics, 2010, 58(9): 3734-3740.
[18] 李浩源, 张兴, 杨淑英, 等. 基于高频信号注入的永磁同步电机无传感器控制技术综述[J]. 电工技术学报, 2018, 33(12): 2653-2664.
Li Haoyuan, Zhang Xing, Yang Shuying, et al.Review on sensorless control of permanent magnet synchronous motor based on high-frequency signal injection[J]. Transactions of China Electrotechnical Society, 2018, 33(12): 2653-2664.
[19] Seung-Ki Sul.Control of Electric Machine Drive System[M]. lst ed. Hoboken, USA: Wiley Press, 2011.
[20] 麦志勤, 肖飞, 刘计龙, 等. 一种永磁同步电机凸极信号测量方法[J]. 电机与控制学报, 2022, 26(9): 18-29.
Mai Zhiqin, Xiao Fei, Liu Jilong, et al.Measurement method for PMSM saliency signal[J]. Electric Machines and Control, 2022, 26(9): 18-29.
[21] Wang Gaolin, Ding Li, Li Zhuomin, et al.Enhanced position observer using second-order generalized integrator for sensorless interior permanent magnet synchronous motor drives[J]. IEEE Transactions on Energy Conversion, 2014, 29(2): 486-495.
[22] Bolognani S, Zigliotto M.Self-commissioning compensation of inverter non-idealities for sensorless AC drives applications[C]//2002 International Conference on Power Electronics, Machines and Drives (Conf. Publ. No. 487), Sante Fe, NM, USA, 2002: 30-37.
[23] Bolognani S, Peretti L, Zigliotto M.Repetitive-control-based self-commissioning procedure for inverter nonidealities compensation[J]. IEEE Transactions on Industry Applications, 2008, 44(5): 1587-1596.