Abstract：In the model predictive control (MPC) method for the indirect matrix converter (IMC), due to the limited switching states and the fixed control frequency, the output voltage of converter in a sampling period is limited. Under the middle and low speed conditions, the difference between each finite output voltage vector and the reference value is large, resulting in rich harmonics in the input/output currents, which in turn causes the ripple of torque and flux. In order to solve this problem, an optimized model predictive control method is proposed for the induction motor drives fed by an indirect matrix converter. In this method, the grid current and the motor flux vector are considered as the control objectives. A switching state corresponding to zero voltage vector of the inverter circuit is inserted in each sampling period, and the corresponding switching state and the optimal duty cycle are obtained by using the monotonicity of the cost function with the time constraint of the switching state. As a result, the input and output performance of the indirect matrix converter is improved. In addition, the zero-current commutation for bi-directional switches can be realized. The simulation and experimental results show that the proposed method achieves good grid power quality and dynamic/steady state performances for the induction motor. Compared with the conventional MPC, the harmonics of the input and output currents of IMC have been reduced, especially under the middle and low speed conditions.
梅杨, 王梁, 黄伟超. 间接矩阵变换器-异步电机调速系统的优化模型预测控制[J]. 电工技术学报, 2019, 34(14): 2884-2893.
Mei Yang, Wang Liang, Huang Weichao. An Optimized Model Predictive Control Method for the Induction Motor Drives Fed by an Indirect Matrix Converter. Transactions of China Electrotechnical Society, 2019, 34(14): 2884-2893.
[1] Pena R, Cardenas R, Reyes E, et al.Control strategy of an indirect matrix converter with modifying DC voltage[C]//European Conference on Power Electro- nics and Applications, Barcelona, 2009: 1-8. [2] 程启明, 黄伟, 程尹曼, 等. 双级矩阵变换器驱动永磁同步电机的混合非线性控制系统[J]. 电工技术学报, 2017, 32(4): 101-111. Cheng Qiming, Huang Wei, Cheng Yiman, et al.Hybrid nonlinear control system of permanent magnet synchronous motor driven by two stage matrix converter[J]. Transactions of China Electrotechnical Society, 2017, 32(4): 101-111. [3] Bordons C, Montero C.Basic principles of MPC for power converters: bridging the gap between theory and practice[J]. IEEE Industrial on Electronics Magazine, 2015, 9(3): 31-43. [4] 沈坤, 章兢, 王玲, 等. 三相电压型逆变器模型预测控制[J]. 电工技术学报, 2013, 28(12): 283-289. Shen Kun, Zhang Jing, Wang Ling, et al.Model predictive control of three-phase voltage source inverter[J]. Transactions of China Electrotechnical Society, 2013, 28(12): 283-289. [5] 郑泽东, 王奎, 李永东, 等. 采用模型预测控制的交流电机电流控制器[J]. 电工技术学报, 2013, 28(11): 118-123. Zheng Zedong, Wang Kui, Li Yongdong, et al.Current controller for AC motors using model predictive control[J]. Transactions of China Electro- technical Society, 2013, 28(11): 118-123. [6] Rodriguez J, Kolar J, Espinoza J, et al.Predictive torque and flux control of an induction machine fed by an indirect matrix converter[C]//IEEE Inter- national Conference on Industrial Technology, Seville, 2015: 1857-1863. [7] Rivera M, Amirbande M, Vahedi A, et al.Predictive control strategies operating at fixed switching frequency for input filter resonance mitigation in an indirect matrix converter[C]//2017 IEEE Southern Power Electronics Conference (SPEC), Puerto Varas, 2017: 1-6. [8] Rivera M.Predictive control with imposed sinusoidal source and load currents of an indirect matrix converter operating at fixed switching frequency and without weighting factors[C]//2015 IEEE 5th Inter- national Conference on Power Engineering, Energy and Electrical Drives (POWERENG), Guilin, 2015: 641-647. [9] Bordons C, Montero C.Basic principles of MPC for power converters: bridging the gap between theory and practice[J]. IEEE Industrial Electronics Magazine, 2015, 9(3): 31-43. [10] Rodriguez J, Kazmierkowski M P, Espinoza J R, et al.State of the art of finite control set model predictive control in power electronics[J]. IEEE Transactions on Industrial Informatics, 2013, 9(2): 1003-1016. [11] Kouro S, Cortes P, Vargas R, et al.Model predictive control—a simple and powerful method to control power converters[J]. IEEE Transactions on Industrial Electronics, 2009, 56(6): 1826-1838. [12] Ma Xinghe, Tan Guojun, Wu Xiaohan, et al.Research on improved four-step commutation strategy of matrix converter based on two line voltage synthesis[C]//Second International Conference on Ironvative Computing, Information and Control, Kumomoto, 2007: 503. [13] 邓歆, 张广明, 王德明, 等. 基于全阶模型的异步电机磁链观测收敛性分析与对策[J]. 电工技术学报, 2015, 30(1): 61-71. Deng Xin, Zhang Guangming, Wang Deming, et al.Convergence analysis and corresponding strategy of full model based induction motor flux observation[J]. Transactions of China Electrotechnical Society, 2015, 30(1): 61-71. [14] Zhang Yongchang, Yang Haitao.Model-predictive flux control of induction motor drives with switching instant optimization[J]. IEEE Transactions on Energy Conversion, 2015, 30(3): 1113-1122. [15] 徐艳平, 张保程, 周钦. 永磁同步电机双矢量模型预测电流控制[J]. 电工技术学报, 2017, 32(20): 222-230. Xu Yanping, Zhang Baocheng, Zhou Qin.Two-vector based model predictive current control for permanent magnet synchronous motor[J]. Transactions of China Electrotechnical Society, 2017, 32(20): 222-230. [16] Mei Yang, Wang Liang.A zero current commutation model predictive control method for the induction motor drive system fed by indirect matrix con- verter[C]//International Conference on Electrical Machines and Systems, Beijing, 2016: 1-5.
2019, Vol. 34 
