带E类功放的磁耦合谐振无线输电系统源线圈优化

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (12864 KB)
输出: BibTeX | EndNote (RIS)

摘要首先为磁耦合谐振式无线输电系统设计了一款E类功放作为系统输入端电源。鉴于E类功放性能易受负载参数影响,通过优化无线输电系统源线圈结构来降低因E类功放特性造成的系统性能下降。提出了三类源线圈结构,在多负载情况下分别测试负载两端电压变化情况,对比研究各结构下负载间耦合情况对负载电压的影响和各结构下系统的传输效率。研究发现多源线圈单谐振结构能通过利用负载间的耦合来降低由磁场分布引起的负载电压变化。而在E类功放下,串联型分立的多源线圈多谐振结构易造成系统性能下降,负载间耦合对负载影响也十分明显。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	闫卓
	王天风
	张晓晨

关键词 ：磁耦合, 无线输电, E类功放, 源线圈优化

Abstract：At first, a class E power amplifier is designed for magnetic coupling resonant wireless power transmission system as the system power. Given that the class E power amplifier performance will be influenced by the load parameters, an optimization of the source coil structure of wireless transmission system is applied to reduce the drop of the system performance caused by class E power amplifier characteristics. Three kinds of the source coil structure are put forward and tested the change of voltage across the load in multiple load cases. The comparative study involves the structures’ influence on the load voltage and the transmission efficiency of the systems under the load coupled condition. The study found that the structure of multiple source coils and single resonance coil can decrease the load voltage variation, caused by the magnetic field distribution, by using the coupling between loads. And under the class E power amplifier, the structure of series of multiple source coils and resonance coils will cause the drop of system performance easily, and the effects on the loads caused by the coupling are very obvious.

Key words： Magnetic coupling resonance wireless power transmission class E power amplifier source coil optimization

收稿日期: 2016-12-30 出版日期: 2017-05-26

PACS:

TM72

基金资助:国家自然科学基金资助项目（51307007,51577133,51677177）

通讯作者: 张晓晨女,1983年生,实验师,主要研究方向为电子电路、嵌入式控制系统应用。E-mail: zhangxiaochenhbu@163.com

作者简介: 闫卓男,1981年生,博士,副教授,主要研究方向为无线电能传输技术、工程电磁场应用与多物理场耦合。E-mail: yanzhuo_mail@163.com

引用本文:

闫卓, 王天风, 张晓晨. 带E类功放的磁耦合谐振无线输电系统源线圈优化[J]. 电工技术学报, 2017, 32(10): 162-167. Yan Zhuo, Wang Tianfeng, Zhang Xiaochen. Optimization of the Source Coil of Magnetic Coupling Resonant Wireless Power Transmission System with Class E Power Amplifier. Transactions of China Electrotechnical Society, 2017, 32(10): 162-167.

链接本文:

https://dgjsxb.ces-transaction.com/CN/Y2017/V32/I10/162

[1] André Kurs, Aristeidis Karalis, Marin Soljacˇic´, et al. Wireless power transfer via stronglycoupled magnetic resonances[J]. Science, 2007, 317(83): 83-86.
[2] 李阳, 杨庆新, 闫卓, 等. 磁耦合谐振式无线电能传输方向性分析与验证[J]. 电工技术学报, 2014, 29(2): 197-203.
Li Yang, Yang Qingxin, Yan Zhuo, et al. Analysis and validation on characteristic of orientation in wireless power transfer system via coupled magnetic resonances[J]. Transactions of China Electrotechnical Society, 2014, 29(2): 197-203.
[3] 李阳, 杨庆新, 闫卓, 等. 无线电能有效传输距离及其影响因素分析[J]. 电工技术学报, 2013, 28(1): 106-112.
Li Yang, Yang Qingxin, Yan Zhuo, et al. Analysis on effective range of wireless power transfer and its impact factors[J]. Transactions of China Electrotechnical Society, 2013, 28(1): 106-112.
[4] Rizal Johari, James V Krogmeier, David J Love. Analysis and practical considerations in imple- menting multiple transmitters for wireless power transfer via coupled magnetic resonance[J]. IEEE Transactions on Industrial Electronics, 2014, 61(4): 1774-1783.
[5] Bilel Kallel, Olfa Kanoun1, Thomas Keutel, et al. Improvement of the efficiency of MISO configuration in inductive power transmission in case of coils misalignment[C]//Proceedings of IEEE International Instrumentation and Measurement Technology Conference (I2MTC), 2014: 856-861.
[6] Kisong Lee, Dong-Ho Cho. Diversity analysis of multiple transmitters in wireless power transfer system[J]. IEEE Transactions on Magnetics, 2013, 49(6): 2946-2952.
[7] Dukju Ahn, Songcheol Hong. Effect of coupling between multiple transmitters or multiple receivers on wireless power transfer[J]. IEEE Transactions onIndustrial Electronics, 2012, 60(7): 2602-2613 .
[8] Fu Minfan, Zhang Tong, Ma Chengbin, et al. Efficiency and optimal loads analysis for multiple- receiver wireless power transfer systems[J]. IEEE Transactions on Microwave Theory and Techniques, 2015, 63(3): 801-812
[9] Zhang Tong, Fu Minfan, Ma Chengbin, et al. Optimal load analysis for a two-receiver wireless power transfer system[C]//2014 IEEE Wireless Power Transfer Conference (WPTC), 2014: 84-87.
[10] 李阳, 张雅希, 闫卓, 等. 磁耦合谐振式无线电能传输系统阻抗分析与匹配电路设计方法[J]. 电工技术学报, 2016, 31(22): 12-18.
Li Yang, Zhang Yaxi, Yan Zhuo, et al. Impedance analysis and design of matching circuit in wireless power transfer system via coupled magnetic resonances[J]. Transactions of China Electrotechnical Society, 2016, 31(22): 12-18.
[11] 毛世通, 朱春波, 宋凯, 等. 基于端口阻抗的磁耦合谐振式无线电能传输特征参数仿真方法研究[J]. 电工技术学报, 2015, 30(19): 95-102.
Mao Shitong, Zhu Chunbo, Song Kai, et al. Characteristic parameter simulation method for magnetic coupling resonance wireless power transfer based on port impedance[J]. Transactions of China Electrotechnical Society, 2015, 30(19): 95-102.
[12] Raab F H. Idealized operation of the class E tuned power amplifier[J]. IEEE Transactions on Circuits and Systems, 1977, 24(12): 725-735.
[13] 薛明, 杨庆新, 李阳, 等. 磁耦合谐振式无线电能传输系统负载特性研究[J]. 电工技术学报, 2013, 28(2): 28-34.
Xue Ming, Yang Qingxin, Li Yang, et al. The study of load characteristic inwireless energy transfer system based on EM coupling resonance[J]. Transactions of China Electrotechnical Society, 2013, 28(2): 28-34.
[14] Casanova J J, Zhen Ninglow, Lin Jenshan, et al. A loosely coupled planar wireless power system for multiple receivers[J]. IEEE Transactions on Industrial Electronics, 2009, 56(8): 3060-3068.