电工技术学报  2024, Vol. 39 Issue (6): 1725-1736    DOI: 10.19595/j.cnki.1000-6753.tces.230008
电机及其系统 |
基于回馈升压逆变器的无刷直流电机宽速度范围转矩脉动抑制
李珍国, 韩启萌, 贾益丞, 常梦婷
燕山大学电力电子节能与传动控制河北省重点实验室 秦皇岛 066004
Torque Ripple Suppression in Wide Speed Range of Brushless DC Motor Based on Regenerative Boost Inverter
Li Zhenguo, Han Qimeng, Jia Yicheng, Chang Mengting
Key Lab of Power Electronics for Energy Conservation and Motor Drive of Hebei Province Yanshan University Qinhuangdao 066004 China
全文: PDF (2481 KB)   HTML
输出: BibTeX | EndNote (RIS)      
摘要 无刷直流电机固有的转矩脉动问题严重限制了其在诸多高精尖场合的应用,为此该文提出一种适用于宽速度范围转矩脉动抑制的回馈升压逆变器拓扑及控制策略。在正常导通期间通过保持非换相相电流的恒定以减小转矩脉动。当电机运行在低速区间时,由于换相时所需的母线电压小于直流侧电源电压,因此通过脉宽调制便足以实现电机的平滑换相;而在更高速的情况下为实现快速换相并有效抑制换相转矩脉动,可在换相期间利用所提拓扑提升母线电压,其中额外补偿的能量均来自非换相期间电机的回馈。最后通过相应的Matlab仿真和DSP驱动实验验证了所提控制技术的可行性和有效性。
服务
把本文推荐给朋友
加入我的书架
加入引用管理器
E-mail Alert
RSS
作者相关文章
李珍国
韩启萌
贾益丞
常梦婷
关键词 无刷直流电机转矩脉动回馈升压宽速度范围    
Abstract:Brushless DC motors are favored in aerospace, industrial automation, and household appliances because of their high power density, high efficiency, simple structure, and small size. However, the torque ripple inherent in the brushless DC motor limits its use in high-stability, high-precision applications. The torque ripple caused by commutation is the largest and can be up to 50% of the average torque. Therefore, many scholars have researched commutation torque ripple suppression from various perspectives, such as modulation, direct torque control, and control circuit topology. Among them, changing modulation methods and direct torque control often prolong the commutation time during high-speed motor operation. In order to achieve fast phase commutation while effectively suppressing commutation torque ripple, this paper proposes a regenerative boost inverter topology and control strategy for torque ripple suppression of wide-speed range.
Firstly, the causes of commutation torque ripple are analyzed in terms of the PWM_ON modulation method generally used for two-phase conduction. Commutation torque ripple can be suppressed by increasing the average value of the bus voltage during commutation to twice that of the previous non-commutation period. Secondly, the relation curve between commutation torque ripple and angular speed shows that the bus voltage cannot be increased further due to the limitation of the power supply voltage. Thus, it cannot effectively suppress the commutation torque ripple when the motor runs at high speed. Therefore, the paper proposes a regenerative boost inverter topology consisting of a switching tube, a diode, an electrolytic capacitor, and a three-phase bridge inverter circuit. When the motor runs in the low-speed range, a smooth motor commutation through pulse width modulation is sufficient. As the bus voltage required for commutation is less than the power supply voltage on the DC side, no electrolytic capacitor is needed to assist in the boost. In this case, the expected value of the electrolytic capacitor voltage should be zero. However, to prevent negative charging of the electrolytic capacitor, the expected voltage value is set to a positive value, smaller than the DC bus voltage. Hysteresis band track control is used for this electrolytic capacitor voltage. When the deviation between the desired and actual value of the electrolytic capacitor exceeds a given positive threshold, consider discharging the electrolytic capacitor. When it is below a given negative threshold, consider charging the electrolytic capacitor. Under higher speeds, the DC power supply needs to be connected in series with the electrolytic capacitor to raise the bus voltage during commutation when the desired value of the electrolytic capacitor is the difference between the four times back-EMF amplitude and the power supply voltage. All the energy of the electrolytic capacitor comes from the regenerative feedback of the motor during non-commutation periods. Finally, the variation of the electrolytic capacitor voltage during a single switching cycle is quantified, and a capacitor selection method is given.
The feasibility and effectiveness of the proposed control strategy are verified by Matlab simulations and DSP drive experiments. According to the experimental results, the commutation torque ripple is 8.6% at 500 r/min and 10.3% when the speed is increased to 2 000 r/min. The results show that the proposed control scheme can provide the higher bus voltage required for the commutation of the motor and thus achieve a fast and smooth commutation over a wide speed range.
Key wordsBrushless DC motor (BLDCM)    torque ripple    regenerative boost    wide speed range   
收稿日期: 2023-01-04     
PACS: TM351  
基金资助:国家自然科学基金资助项目(61873226)
通讯作者: 李珍国 男,1973年生,博士,副教授,研究方向为电力电子与电力传动。E-mail: lzg@ysu.edu.cn   
作者简介: 韩启萌 男,2000年生,硕士研究生,研究方向为电力电子与电力传动。E-mail: 2639892433@qq.com
引用本文:   
李珍国, 韩启萌, 贾益丞, 常梦婷. 基于回馈升压逆变器的无刷直流电机宽速度范围转矩脉动抑制[J]. 电工技术学报, 2024, 39(6): 1725-1736. Li Zhenguo, Han Qimeng, Jia Yicheng, Chang Mengting. Torque Ripple Suppression in Wide Speed Range of Brushless DC Motor Based on Regenerative Boost Inverter. Transactions of China Electrotechnical Society, 2024, 39(6): 1725-1736.
链接本文:  
https://dgjsxb.ces-transaction.com/CN/10.19595/j.cnki.1000-6753.tces.230008          https://dgjsxb.ces-transaction.com/CN/Y2024/V39/I6/1725