电工技术学报  2020, Vol. 35 Issue (18): 3917-3926    DOI: 10.19595/j.cnki.1000-6753.tces.190751
电力电子 |
自阻自均压模块化多电平换流器子模块拓扑及控制
张建坡1, 崔涤穹1, 田新成2, 赵成勇1
1.新能源电力系统国家重点实验室(华北电力大学) 保定 071001;
2.国网唐山供电公司 唐山 063000
Self-Block and Voltage Balance Modular Multilevel Converter Sub Module Topology and Control
Zhang Jianpo1, Cui Diqiong1, Tian Xincheng2, Zhao Chengyong1
1. State Key Laboratory of Alternate Electrical Power System with Renewable Energy Sources North China Electric Power University Baoding 071001 China;
2. State Grid Tangshan Power Corporation Tangshan 063000 China
全文: PDF (46026 KB)   HTML
输出: BibTeX | EndNote (RIS)      
摘要 基于模块化多电平换流器的高压直流输电需应对直流线路可能短路故障和子模块数量过多带来的电容电压均衡问题。为保证模块之间独立工作为约束条件,该文首先分析全桥拓扑故障抑制机理。然后基于故障钳位电路和开关电容多电平思想,设计一种具有直流故障电流阻断和内部电容电压均衡能力的自阻自均压型子模块拓扑,不仅能满足直流故障电流阻断要求,还将参与排序均衡的电容数量减少一倍。同时研究自阻、自均压拓扑两种不同闭锁模式下直流故障抑制特性、电平输出优先的自均压控制策略以及非闭锁直流故障抑制策略。最后通过PSCAD- EMTDC仿真模型验证该文所提自阻自均压拓扑直流故障抑制及控制策略的有效性。
服务
把本文推荐给朋友
加入我的书架
加入引用管理器
E-mail Alert
RSS
作者相关文章
张建坡
崔涤穹
田新成
赵成勇
关键词 模块化多电平换流器直流故障抑制自阻自均压子模块拓扑非闭锁抑制    
Abstract:High-voltage DC transmission based on modular multilevel converters (MMC) needs to deal with possible short-circuit faults on the DC line and the capacitor voltage balance problem caused by too many sub modules. To ensure sub modules working independently as a constraint, the paper first analyzes the full bridge topology fault suppression mechanism. Then a sub module topology with DC link fault blocking and internal capacitor balance ability is designed based on the fault clamp circuit and switch capacitor multilevel ideas. Thus, it will not only meet the self-suppression requirement but also reduce the number of capacitors participating in the sort balancing algorithm to half. What is more, for the self blocking and voltage balance topology, the DC link fault suppression characteristics under two different blocking modes, i.e. self-balancing control strategy based on the voltage level output priority and the unblocking DC link fault suppression strategy, are also studied. Finally, a PSCAD-EMTDC simulation model is used to verify the effectiveness of the proposed topology of DC link fault suppression and control strategy.
Key wordsModular multilevel converter    DC fault suppression    self-block and balance sub module topology    unblocking suppression   
收稿日期: 2019-06-21     
PACS: TM46  
基金资助:河北省自然科学基金资助项目(E2019502123)
通讯作者: 张建坡 男,1973年生,博士,讲师,主要研究方向为高压直流输电与柔性输配电技术。E-mail: zhangjianpo@126.com   
作者简介: 崔涤穹 男,1997年生,硕士研究生,研究方向为高压直流输电与柔性输配电技术。E-mail: 18730293867@163.com
引用本文:   
张建坡, 崔涤穹, 田新成, 赵成勇. 自阻自均压模块化多电平换流器子模块拓扑及控制[J]. 电工技术学报, 2020, 35(18): 3917-3926. Zhang Jianpo, Cui Diqiong, Tian Xincheng, Zhao Chengyong. Self-Block and Voltage Balance Modular Multilevel Converter Sub Module Topology and Control. Transactions of China Electrotechnical Society, 2020, 35(18): 3917-3926.
链接本文:  
https://dgjsxb.ces-transaction.com/CN/10.19595/j.cnki.1000-6753.tces.190751          https://dgjsxb.ces-transaction.com/CN/Y2020/V35/I18/3917