用于高效冶炼氧化镁的双电极直流电弧炉的仿真与实验

摘要
图/表
参考文献
相关文章 (2)

全文: PDF (20769 KB)
输出: BibTeX | EndNote (RIS)

摘要将一台3 000kV∙A的三相交流氧化镁冶炼电弧炉改造成相同容量的双电极直流电弧炉。揭示了在不同冶炼电流下,输出电压与最大弧长之间的关系。同时,采用三维有限元法对氧化镁熔池的温度场分布进行仿真分析,得出熔池温度场的分布规律。利用改造后的电弧炉制得高纯度的氧化镁晶体,且冶炼得到的氧化镁熔坨的形貌近似椭圆形横截面的拉伸体,与仿真结果一致。最后,比较采用直流电弧炉和交流电弧炉冶炼氧化镁的生产数据,结果表明双电极直流电弧炉冶炼氧化镁的工艺,在单吨能耗、电极损耗以及晶体纯度等方面,均优于传统的三相交流电弧炉。本文工作为采用双电极直流电弧炉生产氧化镁提供了理论指导和依据。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	付友
	王振
	王宁会

关键词 ：直流电弧炉, 氧化镁, 单吨能耗, 电极损耗

Abstract：A 3 000kV·A three-phase AC arc furnace for MgO production has been elaborately refitted into a dual-electrode DC arc furnace with the same capacity. The relationship between the output voltage and the maximum arc length in different smelting currents has been studied. Meanwhile, the molten bath temperature field distribution was calculated by three-dimensional finite element simulation analysis method. High purity MgO crystals could be produced with the converted arc furnace. Additionally, the morphology of the molten MgO lump was similar to a tensile body with an elliptical cross section, which is consistent with the simulation results. Finally, the MgO smelting production data of DC arc furnace were compared with the data of AC arc furnace. The comparison results indicated that the dual-electrode DC arc furnace for smelting MgO has obvious advantages over the traditional three-phase AC arc furnace, from the views of energy consumption per ton, electrode loss as well as crystal purity. This paper has provided theoretical guidance and basis for the production of MgO with dual-electrode DC arc furnace.

Key words： DC arc furnace, magnesium oxide, energy consumption per ton, electrode loss

收稿日期: 2016-03-10 出版日期: 2017-01-03

PACS:

TM924

基金资助:国家国际科技合作专项（2014DFR50880）,中央高校基本科研业务费专项资金（DUT12RC（3）82、DUT16QY35）和国家自然科学基金（51604059）资助项目

作者简介: 付友男,1988年生,博士研究生,研究方向为电工新技术、电弧炉数学建模与控制技术。E-mail: benjamin85100@126.com;王宁会男,1954年生,教授,博士生导师,研究方向为电工新技术与功率变换技术。E-mail: ninghuiw@263.net（通信作者）

引用本文:

付友, 王振, 王宁会. 用于高效冶炼氧化镁的双电极直流电弧炉的仿真与实验[J]. 电工技术学报, 2016, 31(24): 79-87. Fu You, Wang Zhen, Wang Ninghui. 1.Simulation and Experiment Investigation on a Dual-Electrode DC Arc Furnace with High Smelting Efficiency for MgO Production. Transactions of China Electrotechnical Society, 2016, 31(24): 79-87.

链接本文:

https://dgjsxb.ces-transaction.com/CN/Y2016/V31/I24/79

[1] 张克从. 晶体生长[M]. 北京: 科学出版社, 1981.
[2] 彭卉, 邹舒, 付永生, 等. 冲击负荷接入电网的电能质量分析与治理方案研究[J]. 电力系统保护与控制, 2014, 42(1): 54-61.
Peng Hui, Zou Shu, Fu Yongsheng, et al. Research of the power quality problem and treatment scheme for impact loads connected into power system[J]. Power System Protection and Control, 2014, 42(1): 54-61.
[3] 张峰, 何新, 杨丽君. 用于电能质量分析的电弧炉仿真模型[J]. 电气技术, 2013, 14(7): 34-38.
Zhang Feng, He Xin, Yang Lijun. The simulation models of electric arc furnace for analysis on quality of electric power[J]. Electrical Engineering, 2013, 14(7): 34-38.
[4] 段晓波, 朱明星, 胡文平, 等. 交流电弧炉SVC装置2次滤波支路设计校核新方法[J]. 电力系统保护与控制, 2014, 42(1): 126-133.
Duan Xiaobo, Zhu Mingxing, Hu Wenping, et al. Research on the design and check method of the secondary filter branch for SVC device of the AC arc furnace[J]. Power System Protection and Control, 2014, 42(1): 126-133.
[5] 付友, 王宁会, 王志强, 等. 基于噪声信号的电弧炉冶炼氧化镁运行状态分析[J]. 电工技术学报, 2015, 30(5): 15-22.
Fu You, Wang Ninghui, Wang Zhiqiang, et al. Running state analysis of the electric arc furnace smelting magnesium oxide based on the noise signal[J]. Transactions of China Electrotechnical Society, 2015, 30(5): 15-22.
[6] Reynolds Q G. The dual-electrode DC arc furnace- modeling insights[J]. Journal of the Southern African Institute of Mining and Metallurgy, 2011, 111(10): 697-703.
[7] Kotze I J. Pilot plant production of ferronickel from nickel oxide ores and dusts in a DC arc furnace[J]. Minerals Engineering, 2002, 15(11): 1017-1022.
[8] 秦勤, 岳强, 顾根华, 等. 双电极直流电熔镁埋弧电弧炉[J]. 东北大学学报, 2003, 24(7): 685-688.
Qin Qin, Yue Qiang, Gu Genhua, et al. DC submerged-arc furnace with twin electrodes for the fused magnesia production[J]. Journal of Northeastern University, 2003, 24(7): 685-688.
[9] Schoukens A, Abdellatif M, Freeman M. Techno- logical breakthrough of the Mintek thermal magne- sium process[J]. Journal of the South African Institute of Mining & Metallurgy, 2006, 106(1): 25.
[10] 佟玉鹏, 张雄, 张化光. 交流三相电熔镁炉的最佳运行分析[J]. 控制工程, 2007, 14(2): 205-208.
Tong Yupeng, Zhang Xiong, Zhang Huaguang. Analysis of optimal operation about purifying magne- sium oxide with three-phase AC electric smelting furnace[J]. Control Engineering of China, 2007, 14(2): 205-208.
[11] 司鹏, 张卫军, 池中源, 等. 基于极心圆直径算法的电熔镁炉研究[J]. 冶金能源, 2015, 34(2): 16-19.
Si Peng, Zhang Weijun, Chi Zhongyuan, et al. Research of fused magnesia furnace based on electrode circle diameter algorithm[J]. Energy for Metallurgical Industry, 2015, 34(2): 16-19.
[12] 齐国超, 张卫军, 仝永娟, 等. 电熔镁电弧炉炉体优化设计[J]. 冶金能源, 2010, 29(4): 34-36.
Qi Guochao, Zhang Weijun, Tong Yongjuan, et al. Geometry size optimizing of fused magnesia arc furnace[J]. Energy for Metallurgical Industry, 2010, 29(4): 34-36.
[13] 吴志伟, 柴天佑, 付俊, 等. 电熔镁炉熔炼过程的智能设定值控制[J]. 控制与决策, 2011, 26(9): 1417-1420.
Wu Zhiwei, Chai Tianyou, Fu Jun, et al. Intelligent setpoints control of smelting process of fused magnesium furnace[J]. Control and Decision, 2011, 26(9): 1417-1420.
[14] 胡田, 唐任远, 李岩, 等. 永磁风力发电机三维温度场计算及分析[J]. 电工技术学报, 2013, 28(3): 122-126.
Hu Tian, Tang Renyuan, Li Yan, et al. Thermal analysis and calculation of permanent magnet wind generators[J]. Transactions of China Electrotechnical Society, 2013, 28(3): 122-126.
[15] 陈益广, 郑军, 魏娟, 等. 舵机用永磁同步电机的设计与温度场分析[J]. 电工技术学报, 2015, 30(14): 94-99.
Chen Yiguang, Zheng Jun, Wei Juan, et al. Design of PMSM for actuator and its temperature field analysis[J]. Transactions of China Electrotechnical Society, 2015, 30(14): 94-99.
[16] 吕安强, 李永倩, 李静, 等. 光电复合海缆中光纤与导体温度关系的有限元分析方法[J]. 电工技术学报, 2014, 29(4): 91-96.
Lü Anqiang, Li Yongqian, Li Jing, et al. Finite element analysis method for temperature relationship between conductor and optical fiber in optic-electric composite submarine cable[J]. Transactions of China Electrotechnical Society, 2014, 29(4): 91-96.
[17] Reynolds Q G, Jones R J, Reddy B D. Mathematical and computational modelling of the dynamic behaviour of direct current plasma arcs[J]. Journal of the South African Institute of Mining & Metallurgy, 2010, 110(12): 733-742.
[18] Reynolds Q G, Jones R T. Twin-electrode DC smelting furnaces-theory and photographic test work[J]. Minerals Engineering, 2006, 19(3): 325-333.
[19] Wang Zhen, Wang Ninghui, Li Tie. Computational analysis of a twin-electrode DC submerged arc furnace for MgO crystal production[J]. Journal of Materials Processing Technology, 2011, 211(3): 388-395.
[20] Li Tie, Wang Zhen, Wang Ninghui. Temperature field analysis and adaptive neuro-fuzzy inference system for MgO single crystal production[J]. Journal of Wuhan University of Technology, 2012, 27(6): 162-169.
[21] Jones R T, Reynolds Q G, Alport M J. DC arc photography and modeling[J]. Minerals Engineering, 2002, 15(11): 985-991.
[22] Bowman B, Jordan G R, Fitzgerald F. The physics of high-current arcs[J]. Journal of the Iron and Steel Institute, 1969, 207(6): 798-805.
[23] Wang Zhen, Fu You, Wang Ninghui, et al. 3D numerical simulation of electrical arc furnaces for the MgO production[J]. Journal of Materials Processing Technology, 2014, 214(11): 2284-2291.
[24] Leu A, Ma S, Eyring H. Properties of molten magnesium oxide[J]. Proceedings of the National Academy of Sciences of the United States of America, 1975, 72(3): 1026-1030.
[25] 刘刚. 电熔氧化镁炉弧压系数与弧流系数的测定[J]. 工业加热, 2002, 31(4): 39-42.
Liu Gang. Determination of arc voltage and arc current coefficients of MgO smelting[J]. Industrial Heating, 2002, 31(4): 39-42.