Abstract：This paper proposes a finite-control-set model predictive current control for permanent magnet synchronous motor (PMSM) based on dynamic cost function using fuzzy method. The performance of current control is analyzed in different weighting factors of dq current and switching times in cost function. The current item in cost function was not optimized in traditional finite- control-set model predictive current control. Thus, the deviation of speed and its rate of change are used for adjusting weighting factors in cost function dynamically through fuzzy method. The domain of fuzzy control and its reasoning rule are built. The proposed method can improve the response of current, and optimize the switching frequency at the same time. The constraint between dynamic response and stability margin is improved. Both simulation and experiment verify the proposed method.
涂文聪, 骆光照, 刘卫国. 基于模糊动态代价函数的永磁同步电机有限控制集模型预测电流控制[J]. 电工技术学报, 2017, 32(16): 89-97.
Tu Wencong, Luo Guangzhao, Liu Weiguo. Finite-Control-Set Model Predictive Current Control for Permanent Magnet Synchronous Motor Based on Dynamic Cost Function Using Fuzzy Method. Transactions of China Electrotechnical Society, 2017, 32(16): 89-97.
[1] 吕帅帅, 林辉, 马冬麒. 基于最优占空比调制的永磁同步电机直接转矩控制[J]. 电工技术学报, 2015, 30(1): 35-42. Lü Shuaishuai, Lin Hui, Ma Dongqi. Direct torque control for permanent magnet synchronous motor with optimal duty cycle control[J]. Transactions of China Electrotechnical Society, 2015, 30(1): 35-42. [2] 左月飞, 刘闯, 张捷, 等. 永磁同步电动机转速伺服系统PI控制器的一种新设计方法[J]. 电工技术学报, 2016, 31(13): 180-188. Zuo Yuefei, Liu Chuang, Zhang Jie, et al. A novel design method of PI controller for permanent magnetic synchronous motor speed servo system[J]. Transactions of China Electrotechnical Society, 2016, 31(13): 180-188. [3] 高雅, 刘卫国, 骆光照. 牵引机车用永磁同步电机断电-重投控制系统研究[J]. 电工技术学报, 2016, 31(6): 100-107, 117. Gao Ya, Liu Weiguo, Luo Guangzhao. Research of power down-rejoining on control system for per- manent magnet synchronous motor used in traction engines[J]. Transactions of China Electrotechnical Society, 2016, 31(6): 100-107, 117. [4] 王伟华, 肖曦, 丁有爽. 永磁同步电机改进电流预测控制[J]. 电工技术学报, 2013, 28(3): 50-55. Wang Weihua, Xiao Xi, Ding Youshuang. An improved predictive current control method for per- manent magnet synchronous motors[J]. Transactions of China Electrotechnical Society, 2013, 28(3): 50-55. [5] Ma Zhixun, Saeidi S, Kennel R. FPGA implementation of model predictive control with constant switching frequency for PMSM drives[J]. IEEE Transactions on Industrial Informatics, 2014, 10(4): 2055-2063. [6] 张永昌, 杨海涛, 魏香龙. 基于快速矢量选择的永磁同步电机模型预测控制[J]. 电工技术学报, 2016, 31(6): 66-73. Zhang Yongchang, Yang Haitao, Wei Xianglong. Model predictive control of permanent magnet synchronous motors based on fast vector selection[J]. Transactions of China Electrotechnical Society, 2016, 31(6): 66-73. [7] Xie Wei, Wang Xiaocan, Wang Fengxiang, et al. Finite-control-set model predictive torque control with a deadbeat solution for PMSM drives[J]. IEEE Transactions on Industrial Electronics, 2015, 62(9): 5402-5410. [8] Young H A, Perez M A, Rodriguez J, et al. Assessing finite-control-set model predictive control: a com- parison with a linear current controller in two-level voltage source inverters[J]. IEEE Industrial Electronics Magazine, 2014, 8(1): 44-52. [9] Geyer T. Computationally efficient model predictive direct torque control[C]//IEEE International Con- ference on Energy Conversion Congress and Expo- sition, Atlanta Georgia, 2010: 12-16. [10] Cortes P, Kazmierkowski M P, Kennel R M, et al. Predictive control in power electronics and drives[J]. IEEE Transactions on Industrial Electronics, 2008, 55(12): 4312-4324. [11] Ammann U, Vargas R, Roth-Stielow J. Investigation of the average switching frequency of direct model predictive control converters[C]//IEEE International Conference on Industrial Technology, Vina del Mar, 2010: 1800-1807. [12] Matsutani S, Zanma T, Sumiyoshi Y, et al. Optimal control of PMSMs using model predictive control with integrator[C]//ICROS-SICE International Joint Conference, Fukuoka, 2009: 4847-4852. [13] Morel F, Lin-Shi X, Retif J M, et al. A comparative study of predictive current control schemes for a permanent-magnet synchronous machine drive[J]. IEEE Transactions on Industrial Electronics, 2009, 56(7): 2715-2728. [14] Bolognani S, Bolognani S, Peretti L, et al. Design and implementation of model predictive control for electrical motor drives[J]. IEEE Transactions on Industrial Electronics, 2009, 56(6): 1925-1936. [15] 王艳松, 孙桂龙, 曹明志. 基于动态规划法的配电网联络线优化规划研究[J]. 电力系统保护与控制, 2016, 44(10): 30-36. Wang Yansong, Sun Guilong, Cao Mingzhi. Research on the optimization of the tie lines based on dynamic programming for distribution network[J]. Power System Protection and Control, 2016, 44(10): 30-36. [16] 丁冬, 刘宗歧, 杨水丽, 等. 基于模糊控制的电池储能系统辅助AGC调频方法[J]. 电力系统保护与控制, 2015, 43(8): 81-87. Ding Dong, Liu Zongqi, Yang Shuili, et al. Battery energy storage aid automatic generation control for load frequency control based on fuzzy control[J]. Power System Protection and Control, 2015, 43(8): 81-87. [17] 孙元岗, 李宏, 石文龙. 基于模糊滞环空间矢量的变换器控制策略[J]. 电力系统保护与控制, 2015, 43(8): 69-73. Sun Yuangang, Li Hong, Shi Wenlong. Fuzzy hysteresis space vector based control scheme for converters[J]. Power System Protection and Control, 2015, 43(8): 69-73.
2017, Vol. 32 
