一种开关损耗优化的Z源逆变器调制策略

doi:10.19595/j.cnki.1000-6753.tces.221183

Abstract
Figure/Table
References
Related Citation (15)

Download: PDF (8301 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract A Z-source inverter is a topology that can replace a two-stage inverter. It can increase the voltage of the DC link by adding a Z-source network and shoot-through vector. The shoot-through current generated by the shoot-through vector is usually large, which increases the switching device losses of the Z-source inverter. In recent studies, some modulation strategies to reduce switching losses, such as DPWM, have been proposed. However, these modulation strategies seldom consider the variation of load power factor. When the load power factor changes, the current phase through the switching device changes, and the switching device losses caused by the original modulation strategy are not optimal. This paper proposes a generalized ZSVM2 modulation strategy. By moving the relative position between the shoot-through current and the AC output current of the switching device, the switching losses are optimized when the load power factor changes.
First, the current passing through the switching device using the ZSVM2 modulation strategy is analyzed. According to the phase relationship between the AC output current and the shoot-through current, the relationship between the average current of the device and the power factor is obtained. Through formula derivation, when the power factor is 1, the phase relationship between the AC output current and the shoot-through current can achieve the lowest average switching current. Secondly, an improved modulation strategy is proposed. During a switching period, the ZSVM2 strategy has a bridge arm that does not use the shoot-through vector. The proposed strategy exploits this to move the shoot-through current relative to the AC output current. When the power factor is less than 1, the AC output current lags the voltage angle φ, and at this time, the shoot-through vector follows the AC output current and also lags the angle φ. In this way, the position of the shoot-through vector can be determined according to the output current of the AC side, and the optimal effect of switching losses can be achieved. The proposed improved modulation strategy does not change parameters such as the boost factor of the original modulation strategy, so the switching losses can be compared by the average current of the device. Through the derivation of the formula, it can be known that when the power factor is lower, the switching loss optimization of the proposed modulation strategy is better. The proposed modulation strategy optimizes the average current through the device and thus reduces conduction losses. Finally, due to the redistribution of the bridge arm with the shoot-through vector, the maximum value of the inductance ripple of the proposed modulation is no longer generated at φ =π/6. However, it must be re-determined according to the actual operating power factor and modulation parameters. The improved modulation does not affect the use of the inductor ripple optimized modulation algorithm. The proposed modulation strategy can also be applied to the ZSVM1 modulation strategy.
The loss optimization effect is verified by Matlab/Simulink combined with PLECS simulation. The results show that when the power factor is 0.966 and 0.866, the proposed modulation strategy can reduce the switching losses by 3.3% and 9.7%, and the conduction losses by 1.6% and 3.2%, respectively. Simulations show that the proposed modulation strategy slightly increases the total harmonic content THD of the AC output current. A low-power test platform is built to verify the loss optimization effect. The thermal imager shows that when the power factor is 0.866, compared with the ZSVM2 modulation strategy, the proposed ZSVM2 modulation reduces the temperature of the switching device by 1-2 degrees Celsius.

Key words： Z-source inverter switching losses optimization Z-source inverter space vector modulations 2 (ZSVM2) space vector modulation

Received: 21 June 2022

PACS:

TM464

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	Jiang Yizhan
	Zhang Jingwei
	He Fengyou
	Wang Qiang
	Zhang Weifeng

Cite this article:

Jiang Yizhan,Zhang Jingwei,He Fengyou等. A Switching Loss Optimization Modulation Strategy for Z-Source Inverter[J]. Transactions of China Electrotechnical Society, 2023, 38(16): 4312-4323.

URL:

https://dgjsxb.ces-transaction.com/EN/10.19595/j.cnki.1000-6753.tces.221183 OR https://dgjsxb.ces-transaction.com/EN/Y2023/V38/I16/4312

[1] 彭方正, 房绪鹏, 顾斌, 等. Z源变换器[J]. 电工技术学报, 2004, 19(2): 47-51.
Peng Fangzheng, Fang Xupeng, Gu Bin, et al.Z- source converter[J]. Transactions of China Electro- technical Society, 2004, 19(2): 47-51.
[2] Anderson J, Peng Fangzheng.A class of quasi- Z-source inverters[C]//2008 IEEE Industry Appli- cations Society Annual Meeting, Edmonton, AB, Canada, 2008: 1-7.
[3] 丁新平, 钱照明, 崔彬, 等. 适应负载大范围变动的高性能Z源逆变器[J]. 电工技术学报, 2008, 23(2): 61-67.
Ding Xinping, Qian Zhaoming, Cui Bin, et al.A high-performance Z-source inverter operating at wide-range load[J]. Transactions of China Electro- technical Society, 2008, 23(2): 61-67.
[4] Qian Wei, Peng Fangzheng, Cha H.Trans-Z-source inverters[C]//2010 International Power Electronics Conference, Sapporo, Japan, 2010: 1874-1881.
[5] Loh P C, Li Ding, Blaabjerg F.Γ-Z-source inverters[J]. IEEE Transactions on Power Electronics, 2013, 28(11): 4880-4884.
[6] Li Linlin, Tang Yu.A high set-up quasi-Z-source inverter based on voltage-lifting unit[C]//2014 IEEE Energy Conversion Congress and Exposition, Pittsburgh, PA, USA, 2014: 1880-1886.
[7] Ahmed H F, Cha H, Kim S H, et al.Switched- coupled-inductor quasi-Z-source inverter[J]. IEEE Transactions on Power Electronics, 2016, 31(2): 1241-1254.
[8] Ding Xinping, Li Kai, Hao Yangyang, et al.Family of the coupled-inductor multiplier voltage rectifier quasi- Z-source inverters[J]. IEEE Transactions on Industrial Electronics, 2021, 68(6): 4903-4915.
[9] Peng Fangzheng, Shen Miaosen, Qian Zhaoming.Maximum Boost control of the Z-source inverter[J]. IEEE Transactions on Power Electronics, 2005, 20(4): 833-838.
[10] Shen Miaosen, Wang Jin, Joseph A, et al.Constant Boost control of the Z-source inverter to minimize current ripple and voltage stress[J]. IEEE Transa- ctions on Industry Applications, 2006, 42(3): 770-778.
[11] Ding Xinping, Qian Zhaoming, Xie Yeyuan, et al.A novel ZVS Z-source rectifier[C]//2006 Twenty-First Annual IEEE Applied Power Electronics Conference and Exposition, Dallas, USA, 2006: 1-5.
[12] Loh P C, Vilathgamuwa D M, Lai Y S, et al.Pulse- width modulation of Z-source inverters[J]. IEEE Transactions on Power Electronics, 2005, 20(6): 1346-1355.
[13] Jung J W, Keyhani A.Control of a fuel cell based Z-source converter[J]. IEEE Transactions on Energy Conversion, 2007, 22(2): 467-476.
[14] Zhang Qianfan, Na Tuopu, Song Liwei, et al.A novel modulation for soft-switching three-phase quasi-Z- source rectifier without auxiliary circuit[J]. IEEE Transactions on Industrial Electronics, 2018, 65(6): 5157-5166.
[15] Ali U S, Kamaraj V.A novel space vector PWM for Z-source inverter[C]//2011 1st International Conference on Electrical Energy Systems, Chennai, India, 2011: 82-85.
[16] Liu Yushan, Ge Baoming, Abu-Rub H, et al.Overview of space vector modulations for three- phase Z-source/quasi-Z-source inverters[J]. IEEE Transactions on Power Electronics, 2014, 29(4): 2098-2108.
[17] Mohammadi M, Moghani J S, Milimonfared J.A novel dual switching frequency modulation for Z- source and quasi-Z-source inverters[J]. IEEE Transa- ctions on Industrial Electronics, 2018, 65(6): 5167-5176.
[18] Abdelhakim A, Davari P, Blaabjerg F, et al.Switching loss reduction in the three-phase quasi-Z-source inverters utilizing modified space vector modulation strategies[J]. IEEE Transactions on Power Electronics, 2018, 33(5): 4045-4060.
[19] 董帅, 张千帆, 王睿, 等. SVPWM控制时双向Z源逆变器电容电压纹波分析[J]. 电工技术学报, 2017, 32(24): 107-114.
Dong Shuai, Zhang Qianfan, Wang Rui, et al.Analysis of capacitor voltage ripple for bi-directional Z-source inverters based on SVPWM[J]. Transactions of China Electrotechnical Society, 2017, 32(24): 107-114.
[20] He Yuyao, Xu Yuhao, Chen Jinping.New space vector modulation strategies to reduce inductor current ripple of Z-source inverter[J]. IEEE Transa- ctions on Power Electronics, 2018, 33(3): 2643-2654.
[21] Liu Wenjie, Yang Yongheng, Kerekes T, et al.Inductor current ripple analysis and reduction for quasi-Z-source inverters with an improved ZSVM6 strategy[J]. IEEE Transactions on Power Electronics, 2021, 36(7): 7693-7704.
[22] Loh P C, Lim S W, Gao Feng, et al.Three level Z-source inverters using a single LC impedance network[J]. IEEE Transactions on Power Electronics, 2007, 22(2): 706-711.
[23] Xing Xiangyang, Zhang Chenghui, Chen Alian, et al.Space-vector-modulated method for boosting and neutral voltage balancing in Z-source three-level T-type inverter[J]. IEEE Transactions on Industry Applications, 2016, 52(2): 1621-1631.
[24] Dong Shuai, Zhang Qianfan, Cheng Shukang.Analysis of critical inductance and capacitor voltage ripple for a bi-directional Z-source inverter[J]. IEEE Transactions on Power Electronics, 2015, 30(7): 4009-4015.
[25] Hava A M, Kerkman R J, Lipo T A.A high- performance generalized discontinuous PWM algri- thm[J]. IEEE Transactions on Industry Applications, 1998, 34(5): 1059-1071.