大容量金属氧化物限压器通风冷却结构优化设计与计算分析

Abstract
Figure/Table
References
Related Citation (15)

Download: PDF (796 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract As a key component of fault current limiter(FCL), metal oxide varistor(MOV) will absorb short-circuit energy during the short-circuit fault in power system, leading to the instantaneous increase of its temperature. The heat transfer ability of air-cooling system is of critical importance for the MOV reliability. Therefore, it is very important to reasonably optimize the ventilation structure of MOV used in power system. In this work, based on the structure design of large capacity MOV performed early and its corresponding experimental researches, two optimization designs of MOV structure(marked by MOV-1 and MOV-2, respectively) are proposed. With CFD principle and finite volume method, the fluid field velocity and temperature distribution of both basic MOV structure and the two optimized ones are systematically calculated and analyzed. It is shown that when compared to basic MOV structure, more heat can be taken away from the optimized MOVs and the decrease of the maximum temperature of the two optimized MOVs is about 35°C and 40°C, respectively, indicating their evident improvement of heat dissipation. In addition, the MOV-2 is obtained by adding the radial air-cooling hole on the basis of the MOV-1, and its heat dissipation is obviously improved, compared to the MOV-1. According to this, a practical MOV-2 was constructed and its temperature increase was experimentally determined. Good agreement between the determined temperature increase and the corresponding theoretical calculations is obtained, showing that the MOV-2 can be implemented in power system and indicating the reliability of the calculations performed in this work.

Key words： MOV air-cooling optimal structure fluid field temperature field

Received: 21 March 2012 Published: 25 March 2014

PACS:

TM502

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	Tang Zonghua
	Tan Zhenyu
	Sun Shumin
	Li Qingmin

Cite this article:

Tang Zonghua,Tan Zhenyu,Sun Shumin等. Calculation and Analysis on Ventilation Structure of Different Optimum Proposals in Large Capacity Metal Oxide Varistor[J]. Transactions of China Electrotechnical Society, 2013, 28(3): 161-170.

URL:

http://dgjsxb.ces-transaction.com/EN/ OR http://dgjsxb.ces-transaction.com/EN/Y2013/V28/I3/161

[1] 王华昕, 习贺勋, 汤广福, 等. 面向超高压电网的故障限流器的应用研究[J]. 高电压技术, 2007, 33(5): 99-113.
Wang Huaxin, Xi Hexun, Tang Guangfu, et al. Application research of fault current limiter on the EHV grid[J]. High Voltage Engineering, 2007, 33(5): 99-113.
[2] 刘洪顺, 李庆民, 徐亮, 等. 氧化锌避雷器式故障限流器对电力系统暂态稳定的影响[J]. 电力自动化设备, 2007, 27(8): 51-54.
Liu Hongshun, Li Qingmin, Xu Liang, et al. Influence of MOA-based FCL on power system transient stability[J]. Electric Power Automation Equipment, 2007, 27(8): 51-54.
[3] 刘之方. 500kV串补与可控串补中限压器（MOV）的研究[D]. 北京: 华北电力大学, 2002.
[4] 魏斌. MOV在低温环境下的电气特性及应用研究[D]. 武汉: 华中科技大学, 2007.
[5] 章梓雄, 董曾南. 粘性流体力学[M]. 北京: 清华大学出版社, 1998.
[6] 郭荣良, 郭清南, 祝世兴. 流体力学及应用[M]. 北京: 机械工业出版社, 1996.
[7] 钟声玉, 王克光. 流体力学和热工理论基础[M]. 北京: 机械工业出版社, 1980.
[8] 丁舜年. 大型电机的发热与冷却[M]. 北京: 科学出版社, 1992.
[9] 陶文铨. 数值传热学[M]. 2版. 西安: 西安交通大学出版社, 2004.
[10] 李伟力, 丁树业, 靳慧勇. 基于耦合场的大型同步发电机定子温度场的数值计算[J]. 中国电机工程学报, 2005, 25(13): 129-134.
Li Weili, Ding Shuye, Jin Huiyong. Numerical calculation of large synchronous generator stator temperature fields based on coupled fields[J]. Proceedings of the CSEE, 2005, 25(13): 129-134.
[11] 霍菲阳, 李勇, 李伟力, 等. 大型空冷汽轮发电机定子通风结构优化方案的计算与分析[J]. 中国电机工程学报, 2010, 30(6): 69-75.
Huo Feiyang, Li Yong, Li Weili, et al. Calculation and analysis on stator ventilation structure of different optimum proposal in air-cooled turbo generator[J]. Proceedings of the CSEE, 2010, 30(6): 69-75.
[12] 温惠, 谭震宇, 唐宗华, 等. 金属氧化物限压器冷却结构设计及其三维温度场仿真分析[J]. 高电压技术, 2011, 37(9): 2328-2336.
Wen Hui, Tan Zhenyu, Tang Zonghua, et al. Cooling structure design of metal oxide voltage limiter and simulation study of its three dimensional temperature field[J]. High Voltage Engineering, 2011, 37(9): 2328-2336.
[13] 王福军. 计算流体动力学分析[M]. 北京: 清华大学出版社, 2004.
[14] 刘兴发. MOA设计与热特性研究[D]. 武汉: 华中科技大学, 2007.
[15] 刘昌宇, 黄梅, 李刚. 500kV串补保护检验方法的设计[J]. 电力系统保护与控制, 2008, 36(15): 65-68.
Liu Changyu, Huang Mei, Li Gang. Design of a method for 500kV series compensation protection test[J]. Power System Protection and Control, 2008, 36(15): 65-68.
[16] 李伟力, 靳慧勇, 丁树业, 等. 大型同步发电机定子多元流场与表面散热系数数值计算与分析[J]. 中国电机工程学报, 2005, 25(23): 138-143.
Li Weili, Jin Huiyong, Ding Shuye, et al. Numerical calculation and analysis of large synchronous generator stator multidimensional fluidfields and surface heat transfer coefficients[J]. Proceedings of the CSEE, 2005, 25(23): 138-143.
[17] 路义萍, 李伟力, 马贤好, 等. 大型空冷汽轮发电机转子温度场数值模拟[J]. 中国电机工程学报, 2007, 27(12): 7-13.
Lu Yiping, Li Weili, Ma Xianhao, et al. Numerical simulation of temperature field in rotor of large turbo generator with air-coolant[J]. Proceedings of the CSEE, 2007, 27(12): 7-13.
[18] 路义萍, 阴文豪, 谈和平, 等. 汽轮发电机转子三维温度场耦合计算[J]. 工程热物理学报, 2008, 29(4): 659-661.
Lu Yiping, Yin Wenhao, Tan Heping, et al. Coupled calculation of three dimensional temperature field in rotor of turbo generator[J]. Journal of Engineering Thermo Physics, 2008, 29(4): 659-661.
[19] 李伟力, 李勇, 杨雪峰, 等. 大型空冷汽轮发电机定子端部温度场与流体场的计算与分析[J]. 中国电机工程学报, 2009, 29(36): 80-87.
Li Weili, Li Yong, Yang Xuefeng, et al. Temperature and fluid flow field calculation and analysis of stator end of air cooled turbo-generator[J]. Proceedings of the CSEE, 2009, 29(36): 80-87.
[20] 温志伟, 顾国彪, 王海峰. 浸润式与强迫内冷结合的蒸发冷却汽轮发电机定子三维温度场计算[J]. 中国电机工程学报, 2006, 26(23): 133-138.
Wen Zhiwei, Gu Guobiao, Wang Haifeng. Calculation of 3D thermal field in the stator of turbo-generator with immersion evaporative-cooling system and forced inner-cooling[J]. Proceedings of the CSEE, 2006, 26(23): 133-138.
[21] 李进良, 李承曦, 胡仁喜. 精通FLUENT6. 3流场分析[M]. 北京: 化学工业出版社, 2009.
[22] 张国智, 胡仁喜, 陈继刚. ANSYS10.0热力学有限元分析实例指导教程[M]. 北京: 机械工业出版社, 2007.
[23] 刘洪顺, 李庆民, 邹亮, 等. 安装故障限流器的输电线路潜供电弧特性与单相重合闸策略[J]. 中国电机工程学报, 2008, 28(31): 62-67.
Liu Hong shun, Li Qingmin, Zou Liang, et al. Secondary arc characteristics and single-phase autoreclosure scheme of EHV transmission line with fault current limiter[J]. Proceedings of the CSEE, 2008, 28(31): 62-67.