Abstract：An output voltage vector with adjustable amplitude has been synthesized with the selected voltage vector of effectiveness and a zero by calculating the duty cycle in the two-vector model prediction torque control, effectively reducing the actual and design value error. Due to the limited selection range, there are still some defects. Thus, some three-vector improvement measures have been proposed with different selection methods. Based on the new two-vector model prediction torque control, a torque control strategy for three-vector model prediction is proposed based on the fast selection table. A synthetic voltage vector with adjustable amplitude and range is obtained by increasing the effective voltage vector, and a fast selection table is proposed to reduce the computation of the effective voltage vector selection. Firstly, by analyzing the influence of the voltage vectors on the slope of torque and stator flux, it can be known that the zero-voltage vector mainly affects the torque ripples, and the influence on the stator flux is almost negligible. Therefore, the slope of stator flux under zero voltage vector can be neglected in the operation time allocation. Secondly, the fast selection table is constructed according to the effect of the effective voltage vector on torque and stator flux. Thus, the prediction times can be greatly reduced while selecting the effective voltage vector. Then, the sector judgment is made according to the position of stator flux at the current time, and the effective voltage vector is selected quickly according to the error of actual and designed torque values and the value of sectors in the fast selection table. Finally, the operating time of voltage vectors is calculated by the principle of deadbeat control. The simulation test mainly verifies the transient experiment. Firstly, the motor speed is set at 1 500 r/min and started in a no-load state. Then, when the motor runs stably to 1 500 r/min, the simulation test condition of load torque is suddenly added to 3 N·m at 0.1 s. Simulation waveform shows that this strategy can effectively reduce flux fluctuation and torque ripples on the virtual platform and reduce the current harmonics from 13.27% to 6.77%. In order to further verify the feasibility of the algorithm, a relevant experimental platform is built, which is mainly divided into two parts: steady-state experiment and transient experiment verification. The steady-state experiment mainly verifies the motor operation condition under low speed without load and high speed with load. The torque ripples and flux fluctuation can be effectively improved to a certain extent under both conditions, and the current harmonics under high speed with load are reduced from 32.37% to 25.68%. The transient experiment is to add load to the motor under stable operation suddenly. Both experiments show that the control strategy in this paper can reduce current harmonics, and the steady-state performance is better than before. In addition, when the torque changes, although the speed will be affected to some extent, the results will be less affected, and the dynamic response can be maintained quickly.
兰志勇, 罗杰, 李延昊, 李超, 李福. 基于快速选择表的永磁同步电机模型预测转矩控制[J]. 电工技术学报, 2023, 38(21): 5749-5757.
Lan Zhiyong, Luo Jie, Li Yanhao, Li Chao, Li Fu. Model Prediction Torque Control for Permanent Magnet Synchronous Motor Based on the Fast Selection Table. Transactions of China Electrotechnical Society, 2023, 38(21): 5749-5757.
[1] 宋文祥, 任航, 杨煜, 等. 双三相永磁同步电机的双矢量模型预测转矩控制[J]. 电机与控制学报, 2022, 26(9): 97-107. Song Wenxiang, Ren Hang, Yang Yu, et al.Dual three phase permanent synchronous magnet machines model predictive torque control harmonic current suppression two voltage vectors operating time of vector[J]. Electric Machines and Control, 2022, 22(9): 97-107. [2] 姚绪梁, 黄乘齐, 王景芳, 等. 两相静止坐标系下的永磁同步电动机模型预测功率控制[J]. 电工技术学报, 2021, 36(1): 60-67. Yao Xuliang, Huang Shengqi, Wang Jingfang, et al.Model predictive power control of permanent magnet synchronous motor in two-phase static coordinate system[J]. Transactions of China Electrotechnical Society, 2021, 36(1): 60-67. [3] 章回炫, 范涛, 边元均, 等. 永磁同步电机高性能电流预测控制[J]. 电工技术学报, 2022, 37(17): 4335-4345. Zhang Huixuan, Fan Tao, Bian Yuanjun, et al.Predictive current control strategy of permanent magnet synchronous motors with high performance[J]. Transactions of China Electrotechnical Society, 2022, 37(17): 4335-4345. [4] 史婷娜, 张维, 肖萌, 等. 基于矢量作用时间的永磁同步电机预测电流控制[J]. 电工技术学报, 2017, 32(19): 1-10. Shi Tingna, Zhang Wei, Xiao Meng, et al.Predictive current control for permanent magnet synchronous motor based on operating time of vector[J]. Transactions of China Electrotechnical Society, 2017, 32(19): 1-10. [5] 周湛清, 夏长亮, 陈炜, 等. 具有参数鲁棒性的永磁同步电机改进型预测转矩控制[J]. 电工技术学报, 2018, 33(5): 965-972. Zhou Zhanqing, Xia Changliang, Chen Wei, et al.Modified predictive torque control for PMSM drives with parameter robustness[J]. Transactions of China Electrotechnical Society, 2018, 33(5): 965-972. [6] Zhang Yongchang, Zhu Jianguo.A novel duty cycle control strategy to reduce both torque and flux ripples for DTC of permanent magnet synchronous motor drives with switching frequency reduction[J]. IEEE Transactions on Power Electronics, 2011, 26(10): 3055-3067. [7] 刘珅, 高琳. 永磁同步电机的改进模型预测直接转矩控制[J]. 电机与控制学报, 2020, 24(1): 10-17. Liu Shen, Gao Lin.Improved model of predictive direct torque control for permanent magnet syn- chronous motor[J]. Electric Machines and Control, 2020, 24(1): 10-17. [8] Niu Feng, Li Kui, Wang Bingsen, et al.Comparative evaluation of direct torque control strategies for permanent magnet synchronous machines[C]//2014 IEEE Applied Power Electronics Conference and Exposition-APEC, Fort Worth, TX, USA, 2014: 2438-2445. [9] 牛峰, 李奎, 王尧. 基于占空比调制的永磁同步电机直接转矩控制[J]. 电工技术学报, 2014, 29(11): 20-29. Niu Feng, Li Kui, Wang Yao.Model predictive direct torque control for permanent magnet synchronous machines based on duty ratio modulation[J]. Transa- ctions of China Electrotechnical Society, 2014, 29(11): 20-29. [10] Wang Fengxiang, Li Shihua, Mei Xuezhu, et al.Model-based predictive direct control strategies for electrical drives: an experimental evaluation of PTC and PCC methods[J]. IEEE Transactions on Industrial Informatics, 2015, 11(3): 671-681. [11] Zhang Yongchang, Yang Haitao.Model predictive torque control of induction motor drives with optimal duty cycle control[J]. IEEE Transactions on Power Electronics, 2014, 29(12): 6593-6603. [12] 廖晓钟, 邵立伟. 直接转矩控制的十二区段控制方法[J]. 中国电机工程学报, 2006, 26(6): 167-173. Liao Xiaozhong, Shao Liwei.The twelve-section control methods of direct torque control[J]. Pro- ceedings of the CSEE, 2006, 26(6): 167-173. [13] 吕帅帅, 林辉, 李兵强, 等. 一种改进的PMSM模型预测直接转矩控制方法[J]. 电机与控制学报, 2020, 24(7): 102-111. Lü Shuaishuai, Lin Hui, Li Bingqiang, et al.Improved model predictive direct torque control for permanent magnet synchronous motor[J]. Electric Machines and Control, 2020, 24(7): 102-111. [14] Wu Minkai, Sun Xiaodong, Zhu Jianguo, et al.Improved model predictive torque control for PMSM drives based on duty cycle optimization[J]. IEEE Transactions on Magnetics, 2021, 57(2): 1-5. [15] 徐艳平, 李园园, 周钦, 等. 矢量双选取的永磁同步电动机直接转矩控制策略[J]. 中国电机工程学报, 2018, 38(17): 5211-5218, 5318. Xu Yanping, Li Yuanyuan, Zhou Qin, et al.A double vectors selection direct torque control strategy of permanent magnet synchronous motor[J]. Proceedings of the CSEE, 2018, 38(17): 5211-5218, 5318. [16] 夏长亮, 仇旭东, 王志强, 等. 基于矢量作用时间的新型预测转矩控制[J]. 中国电机工程学报, 2016, 36(11): 3045-3053. Xia Changliang, Qiu Xudong, Wang Zhiqiang, et al.Predictive torque control based on optimal operating time of vector[J]. Proceedings of the CSEE, 2016, 36(11): 3045-3053. [17] Nikzad M R, Asaei B, Ahmadi S O.Discrete duty- cycle-control method for direct torque control of induction motor drives with model predictive solution[J]. IEEE Transactions on Power Electronics, 2018, 33(3): 2317-2329. [18] Zhang Yongchang, Zhu Jianguo.Direct torque control of permanent magnet synchronous motor with reduced torque ripple and commutation frequency[J]. IEEE Transactions on Power Electronics, 2011, 26(1): 235-248. [19] 徐艳平, 李园园, 张保程, 等. 一种消除权重系数三矢量模型预测转矩控制[J]. 电工技术学报, 2018, 33(16): 3925-3934. Xu Yanping, Li Yuanyuan, Zhang Baocheng, et al.Three-vector based model predictive torque control of eliminating weighting factor[J]. Transactions of China Electrotechnical Society, 2018, 33(16): 3925-3934. [20] 陈炜, 曾思坷, 张国政, 等. 永磁同步电机改进型三矢量模型预测转矩控制[J]. 电工技术学报, 2018, 33(增刊2): 420-426. Chen Wei, Zeng Sike, Zhang Guozheng, et al.Improved three-vector model predictive torque control of permanent magnet synchronous motor[J]. Transactions of China Electrotechnical Society, 2018, 33(S2): 420-426.
2023, Vol. 38 
