|
|
|
| Research on Discharge Characteristics of AC Excited Metal Needle-Water Electrode at Atmospheric Pressure |
| Xiao Yue1, Yu Zhe1,2, Wang Diya1, Zhang Tengyu1, Song Chunlian2 |
1. School of Science Dalian Maritime University Dalian 116026 China;
2. Heilongjiang Provincial Key Laboratory of Plasma Biomass Materials Research and Testing Heilongjiang Institute of Technology Jixi 158100 China |
|
|
|
Abstract This reserach based on the atmospheric pressure alternating current (AC) metal needle-water electrode discharge device. And the influences of needle-water distance and supply powers on the discharge characteristics of metal needle-water electrode have been studied.
The experimental results showed that the discharge of modes a and b occurred when the supply powers were small, and the discharge modes of them were unstable. The differences were that the discharge mode a was more like corona discharge, and the water surface under the needle electrode would be sunken. The discharge mode b was similar to spark discharge, and the discharge channel in the discharge gap was tortuous. Mode c only existed in the negative half cycle of discharge, and had an axisymmetric structure. Continuing to increase the supply powers, mode c switched to discharge mode d, which not only had the disk structure of mode c, but also had some bright filamentous discharge.
The spatial-temporal evolution process of mode d discharge had been studied. It was found from the ICCD discharge images that the discharge morphology in the positive half cycle extended from the metal needle electrode to the water surface, and diffused into many filaments around the water surface. These discharge filaments had multiple contact points with the water surface, and the contact points moved continuously on the water surface during the discharge process. The negative half-cycle discharge morphology was axisymmetric as a whole, showing different layered structural characteristics. This structure was consistent with the glow discharge form or the Trichel pulse discharge structure.
The experimental results showed that when the metal needle electrode was a positive high voltage electrode, the breakdown voltage dropped from 2.3 kV to 2.0 kV with the increase of supply powers, and the discharge start time in the cycle was advanced from 16 μs to 9 μs, while the maintenance voltage and discharge termination time had little change. When the metal needle electrode was a negative high voltage electrode, the breakdown voltage dropped from 1.4 kV to 1.0 kV as the supply powers increased. the peak current (about 40.0 mA) and peak power (about 50.0 W) of discharge were roughly equal. However, the peak values of the three were all less than the corresponding peak values of the positive half cycle. And the discharge energy of the positive half cycle was always greater than that of the negative half cycle.
The influences of discharge gaps on the discharge characteristics of mode d have been studied. The results showed that when the metal needle electrode was a positive high voltage electrode, as the discharge gap increased from 1.0 mm to 5.0 mm, the breakdown voltage increased from 1.2 kV to 3.2 kV, the current peak value increased from 56.4 mA to 392.1 mA, and the power peak value increased from 68.9 W to 992.2 W, but the discharge start time in the cycle delayed from 6 μs to 16 μs, while the maintenance voltage and discharge termination time had little change. With a 6.0 mm discharge gap, there was no plasma generated in the first half cycle. When the metal needle electrode was a negative high voltage electrode, as the discharge gaps increased, the breakdown voltage increased from 1.0 kV to 1.9 kV, and the peak current and the peak power were approximately equal. There was no positive or negative correlation between the amount of conductive charge and the size of the discharge gaps. The conductive charge in the positive half cycle was basically maintained at 1.2×10-6 C. The discharge energy in the positive half cycle was always greater than that in the negative half cycle.
|
|
Received: 07 April 2023
|
|
|
|
|
|
[1] Raji A, Pandiyaraj K N, Vasu D, et al.Non-equilibrium atmospheric pressure plasma assisted degradation of the pharmaceutical drug valsartan: influence of catalyst and degradation environment[J]. RSC Advances, 2020, 10(59): 35709-35717.
[2] 周子凯, 卢旭, 王森, 等. 含二氧化钛的脉冲气液放电特性及降解四环素研究[J]. 电工技术学报, 2022, 37(22): 5862-5871, 5885.
Zhou Zikai, Lu Xu, Wang Sen, et al.Characteristics of pulse gas-liquid discharge and tetracycline degradation with the addition of TiO2[J]. Transactions of China Electrotechnical Society, 2022, 37(22): 5862-5871, 5885.
[3] 陈慧敏, 段戈辉, 梅丹华, 等. 气体添加对水电极同轴介质阻挡放电直接分解CO2的影响[J]. 电工技术学报, 2023, 38(1): 270-280.
Chen Huimin, Duan Gehui, Mei Danhua, et al.Effect of gas addition on CO2 decomposition in a coaxial dielectric barrier discharge reactor with water electrode[J]. Transactions of China Electrotechnical Society, 2023, 38(1): 270-280.
[4] 杨国清, 邵朱夏, 曹一崧, 等. NaOH气液两相滑动弧放电处理含硫废气的研究[J]. 电工技术学报, 2017, 32(8): 114-120, 137.
Yang Guoqing, Shao Zhuxia, Cao Yisong, et al.Treatment of flue gas containing sulfur by gas-liquid phase gliding arc discharge combined with NaOH[J]. Transactions of China Electrotechnical Society, 2017, 32(8): 114-120, 137.
[5] 李向荣, 王飞鹏, 黄正勇, 等. 光电离对天然酯绝缘油流注放电影响规律研究[J]. 电工技术学报, 2023, 38(12): 3350-3365.
Li Xiangrong, Wang Feipeng, Huang Zhengyong, et al.Impact of photoionization on streamer discharge in natural ester insulating oil[J]. Transactions of China Electrotechnical Society, 2023, 38(12): 3350-3365.
[6] Kozyrev A V, Kokovin A O, Kozhevnikov V Y, et al.Change in mechanism of corona discharge formation in atmospheric air with a negative tip[J]. Russian Physics Journal, 2023, 65(10): 1758-1761.
[7] 邬登金, 梅红伟, 孟晓波, 等. 温度对棒-板间隙正流注电晕放电特性的影响研究[J]. 高压电器, 2022, 58(2): 50-59.
Wu Dengjin, Mei Hongwei, Meng Xiaobo, et al.Research on influences of temperature on positive streamer corona discharge characteristic of rod-plane gap[J]. High Voltage Apparatus, 2022, 58(2): 50-59.
[8] 孙昊, 张帅, 韩伟, 等. 纳秒脉冲火花放电高效转化甲烷的实验研究[J]. 电工技术学报, 2019, 34(4): 880-888.
Sun Hao, Zhang Shuai, Han Wei, et al.An experimental investigation of nanosecond pulsed spark discharge for high-efficient methane conversion[J]. Transactions of China Electrotechnical Society, 2019, 34(4): 880-888.
[9] Ju Yiguang, Sun Wenting.Plasma assisted combustion: dynamics and chemistry[J]. Progress in Energy and Combustion Science, 2015, 48: 21-83.
[10] Bystritskii V, Grigorev S, Kharlov A, et al.Material surface treatment using microsecond plasma opening switch[J]. Theoretical and Applied Fracture Mechanics, 1997, 26(2): 151-154.
[11] Yemeli G B N, Janda M, Machala Z. Non-thermal plasma as a priming tool to improve the yield of pea in outdoor conditions[J]. Plasma Chemistry and Plasma Processing, 2022, 42(5): 1143-1168.
[12] Han L, Boehm D, Amias E, et al.Atmospheric cold plasma interactions with modified atmosphere packaging inducer gases for safe food preservation[J]. Innovative Food Science & Emerging Technologies, 2016, 38: 384-392.
[13] 田一平, 周新颖, 袁晓莉, 等. 强电离放电等离子体在应急净化饮用水中的应用[J]. 高电压技术, 2017, 43(6): 1792-1799.
Tian Yiping, Zhou Xinying, Yuan Xiaoli, et al.Application on strong ionized discharge plasma to emergency drinking water disinfection[J]. High Voltage Engineering, 2017, 43(6): 1792-1799.
[14] 卢洪伟, 倪志娇, 查学军. 不同电极结构对DBD降解亚甲基蓝废水的影响[J]. 高压电器, 2023, 59(4): 62-69.
Lu Hongwei, Ni Zhijiao, Zha Xuejun.Effect of different electrode structures on degradation of methylene blue wastewater by DBD plasma[J]. High Voltage Apparatus, 2023, 59(4): 62-69.
[15] Kuroki T, Nomura S, Yamasaki H, et al.Performance of a wet-type nonthermal plasma reactor for NOx, SOx, and wastewater treatment[J]. IEEE Transactions on Industry Applications, 2020, 56(6): 6978-6982.
[16] Hoeben W F L M, Ooij P P, Schram D C, et al. On the possibilities of straightforward characterization of plasma activated water[J]. Plasma Chemistry and Plasma Processing, 2019, 39(3): 597-626.
[17] Tendero C, Tixier C, Tristant P, et al.Atmospheric pressure plasmas: a review[J]. Spectrochimica Acta Part B: Atomic Spectroscopy, 2006, 61(1): 2-30.
[18] Anpilov A M, Barkhudarov E M, Bark Y B, et al.Electric discharge in water as a source of UV radiation, ozone and hydrogen peroxide[J]. Journal of Physics D: Applied Physics, 2001, 34(6): 993-999.
[19] Yao Kangning, Chi Yong, Wang Fei, et al.The effect of microbubbles on gas-liquid mass transfer coefficient and degradation rate of COD in wastewater treatment[J]. Water Science and Technology, 2016, 73(8): 1969-1977.
[20] 高明. 基于气液等离子体的柔性材料表界面设计与功能化构筑[D]. 深圳: 中国科学院大学(中国科学院深圳先进技术研究院), 2022.
Gao Ming.Interface design and surface functionalization of flexible materials by gas-liquid plasma[D]. Shenzhen: Shenzhen Institute of Advanced Technology, Chinese Academy of Sciences, 2022.
[21] Locke B R, Sato M, Sunka P, et al.Electrohydraulic discharge and nonthermal plasma for water treatment[J]. Industrial & Engineering Chemistry Research, 2006, 45(3): 882-905.
[22] Bruggeman P, Leys C.Non-thermal plasmas in and in contact with liquids[J]. Journal of Physics D: Applied Physics, 2009, 42(5): 053001.
[23] 刘亚韪, 周子凯, 王森, 等. 大气压空气针-水结构脉冲气-液放电特性研究[J]. 强激光与粒子束, 2021, 33(6): 74-81.
Liu Yawei, Zhou Zikai, Wang Sen, et al.Research on the characteristics of atmospheric pressure air pulse gas-liquid discharge using a needle-water electrode[J]. High Power Laser and Particle Beams, 2021, 33(6): 74-81.
[24] Kawamoto H, Umezu S.Electrohydrodynamic deformation of water surface in a metal pin to water plate corona discharge system[J]. Journal of Physics D: Applied Physics, 2005, 38(6): 887-894.
[25] Liu Jingjing, Hu Xiao.Contrasting behaviours of AC and DC excited plasmas in contact with liquid[J]. Plasma Science and Technology, 2013, 15(8): 768-775.
[26] Miao Shuyi, Ren Chunsheng, Wang Dezhen, et al.Conical DC discharge in ambient air using water as an electrode[J]. IEEE Transactions on Plasma Science, 2008, 36(1): 126-130.
[27] Shirai N, Uchida S, Tochikubo F.Influence of oxygen gas on characteristics of self-organized luminous pattern formation observed in an atmospheric dc glow discharge using a liquid electrode[J]. Plasma Sources Science and Technology, 2014, 23(5): 054010.
[28] Bruggeman P, Liu Jingjing, Degroote J, et al.DC excited glow discharges in atmospheric pressure air in pin-to-water electrode systems[J]. Journal of Physics D: Applied Physics, 2008, 41(21): 215201.
[29] Thagard S M, Takashima K, Mizuno A.Chemistry of the positive and negative electrical discharges formed in liquid water and above a gas-liquid surface[J]. Plasma Chemistry and Plasma Processing, 2009, 29(6): 455-473. |
|
|
|
2024, Vol. 39 
