Abstract Wireless power transfer (WPT) has been widely applied in various charging fields due to its non-contact and high-efficiency transmission of high-power electric energy over medium and long distances. In contrast to the traditional plug-in charging, WPT has the advantages of misalignment adaptation and easy maintenance, also can effectively avoid the plug wear, wire aging, and contact electrical sparks. However, because of its characteristics of non-contact between primary side and secondary side, foreign object could easily enter the coupling charging area. The eddy effect caused by the high power alternating magnetic field will lead to fire and ignition. As for the foreign metal objects with small size or located in the corner area relative to detection coil, the detection sensitivity of existing common detection methods is not high enough to detect them accurately. The blind detection area will cause the safety hazards. Thus, a high-order composite resonant topology to improve the detection sensitivity of foreign object detection system was proposed in this paper, which solves the problems of low detection sensitivity and blind area of traditional detection coil. Firstly, the mutual inductance coupling model between metal foreign object and detection coil was established, and the amplifying effect of resonance topology on the impedance variation of detection coil was interpreted. Secondly, the feasibility of improving the detection sensitivity of composite resonant topology under reasonable designed parameters was analyzed. Then a high-order composite resonant topology was designed according to the amplification characteristics of the resonant topology. Also, the device parameter optimization of the proposed high-order composite resonant topology is analyzed in detail. Finally, the sensitivity of the proposed topology and its realization circuit were simulated and verified by experiments. In the WPT experiment, the proposed detection coil array and FOD system did not affect the output power and efficiency due to its decoupling characteristic with magnetic coupler. Also, the parameters of detection coils were basically not affected by the offset of magnetic coupler, which can avoid the misjudgment effectively. In the FOD experiment, the aluminum cylinder with diameter 20mm is placed at the corresponding corner positions of the detection coil, the detection sensitivity of two situations above are 62.31% and 275.68%, respectively. When the aluminum cylinder was located in the center area of the detection coil, the detection sensitivity is 187.69%. As for the foreign object with small size, such as paper clips, the detection sensitivity can reach 119.23%. The experimental results above demonstrate that the proposed topology has high enough detection sensitivity to eliminate the detection blind area completely even if the metal foreign object has a small influence on the detection coil impedance. A high-order composite resonant topology to improve the detection sensitivity of foreign object detection system was proposed in this paper. Compared with the traditional series and parallel resonant topology of detection circuit, the proposed topology is more sensitive for the impedance changes of detection coils caused by metal foreign objects. The following conclusions can be drawn from the analysis and experiment results: (1) The measured detection sensitivity of the FOD system is basically consistent with the theoretical analysis. And the detection signal has a high SNR and has no influence on the output power and efficiency of the wireless charging system. (2) The proposed high-order composite resonant topology owns the high detection sensitivity. As for the paper clips and foreign objects which located at the ultimate corner of the detection coil, the detection sensitivity can be up to 62.31% and 119.23%, respectively. (3) The existence of foreign objects can be determined accurately by combining the detection results of multiple adjacent coils comprehensively. Thus, the blind detection areas and other safety risks can be eliminated completely.
Sun Ying,Zhou Tian,Song Kai等. Design of High-Order Composite Resonant Topology for Improving the Sensitivity of Foreign Object Detection System[J]. Transactions of China Electrotechnical Society, 2023, 38(6): 1541-1552.
[1] 赵争鸣, 张艺明, 陈凯楠. 磁耦合谐振式无线电能传输技术新进展[J]. 中国电机工程学报, 2013, 33(3): 1-13, 21. Zhao Zhengming, Zhang Yiming, Chen Kainan.New progress of magnetically-coupled resonant wireless power transfer technology[J]. Proceedings of the CSEE, 2013, 33(3): 1-13, 21. [2] 赵争鸣, 刘方, 陈凯楠. 电动汽车无线充电技术研究综述[J]. 电工技术学报, 2016, 31(20): 30-40. Zhao Zhengming, Liu Fang, Chen Kainan.New progress of wireless charging technology for electric vehicles[J]. Transactions of China Electrotechnical Society, 2016, 31(20): 30-40. [3] 黄学良, 谭林林, 陈中, 等. 无线电能传输技术研究与应用综述[J]. 电工技术学报, 2013, 28(10): 1-11. Huang Xueliang, Tan Linlin, Chen Zhong, et al.Review and research progress on wireless power transfer technology[J]. Transactions of China Electrotechnical Society, 2013, 28(10): 1-11. [4] 吴理豪, 张波. 电动汽车静态无线充电技术研究综述(上篇)[J]. 电工技术学报, 2020, 35(6): 1153-1165. Wu Lihao, Zhang Bo.Overview of static wireless charging technology for electric vehicles: part I[J]. Transactions of China Electrotechnical Society, 2020, 35(6): 1153-1165. [5] 吴理豪, 张波. 电动汽车静态无线充电技术研究综述(下篇)[J]. 电工技术学报, 2020, 35(8): 1662-1678. Wu Lihao, Zhang Bo.Overview of static wireless charging technology for electric vehicles: part Ⅱ[J]. Transactions of China Electrotechnical Society, 2020, 35(8): 1662-1678 [6] 薛明, 杨庆新, 章鹏程, 等. 无线电能传输技术应用研究现状与关键问题[J]. 电工技术学报, 2021, 36(8): 1547-1568. Xue Ming, Yang Qingxin, Zhang Pengcheng, et al.Application status and key issues of wireless power transmission technology[J]. Transactions of China Electrotechnical Society, 2021, 36(8): 1547-1568. [7] 廖志娟, 孙跃, 叶兆虹, 等. 无线电能传输系统共振机理及共振点分布特性研究[J]. 电工技术学报, 2020, 35(2): 215-224. Liao Zhijuan, Sun Yue, Ye Zhaohong, et al.Research on resonance mechanism and resonant point distribution characteristic of magnetic coupling wireless power transfer systems[J]. Transactions of China Electrotechnical Society, 2020, 35(2): 215-224. [8] 张献, 王朝晖, 魏斌, 等. 电动汽车无线充电系统中电屏蔽对空间磁场的影响分析[J]. 电工技术学报, 2019, 34(8): 1580-1588. Zhang Xian, Wang Zhaohui, Wei Bin, et al.Analysis of the influence of electric shield on space magnetic field in electric vehicle wireless charging system[J]. Transactions of China Electrotechnical Society, 2019, 34(8): 1580-1588. [9] 陈琛, 黄学良, 孙文慧, 等. 金属障碍物对磁耦合谐振无线电能传输系统的影响[J]. 电工技术学报, 2014, 29(9): 22-26. Chen Chen, Huang Xueliang, Sun Wenhui, et al.Impact of metal obstacles on wireless power transmission system based coupled resonance[J]. Transactions of China Electrotechnical Society, 2014, 29(9): 22-26. [10] 陈琛, 黄学良, 谭林林, 等. 电动汽车无线充电时的电磁环境及安全评估[J]. 电工技术学报, 2015, 30(19): 61-67. Chen Chen, Huang Xueliang, Tan Linlin.et al.Electromagnetic environment and security evaluation for wireless charging of electric vehicles[J]. Transactions of China Electrotechnical Society, 2015, 30(19): 61-67. [11] 马中原, 廖承林, 王丽芳. 金属异物对电动汽车无线充电系统影响分析[J]. 电工电能新技术, 2017, 36(2): 14-20. Ma Zhongyuan, Liao Chenglin, Wang Lifang.Analysis of metal foreign object setting on electric vehicle wireless power transfer system[J]. Advanced Technology of Electrical Engineering and Energy, 2017, 36(2): 14-20. [12] SAEJ2954_201904 Wireless power transfer for light-duty plug-in/electric vehicles and alignment methodology wireless power transfer for light-duty plug-in/electric vehicles and alignment methodology[S]. 2019. [13] IEC 61980-1: 2015/COR1: 2017 corrigendum 1-electric vehicle wireless power transfer (WPT) systems-part 1: general requirements[S]. 2017. [14] Jeong S Y, Kwak. H G, Jang G C, et al. Dual-purpose nonoverlapping coil sets as metal object and vehicle position detections for wireless stationary EV chargers[J]. IEEE Transactions on Power Electronics 2018, 33(9): 7387-7397. [15] Jang G C, Jeong S Y, Kwak H G, et al.Metal object detection circuit with non-overlapped coils for wireless EV chargers[C]//2016 IEEE 2nd Annual Southern Power Electronics Conference (SPEC), Auckland, 2016: 1-6. [16] Meichle D P, Atnafu N E, et al. Foreign object detection in wireless energy transfer systems. US:2017 WO2017/0700227A1[P]. 2017-4-27. [17] Widmer H, Sieber L, Daetwyler A, et al. Systems, methods,apparatus for radar-based detection of objects in a predetermined space: US, 977240125[P].2017-9-26. [18] Jeong S Y, Thai V X, Park J H, et al.Self-inductance based metal object detection with mistuned resonant circuits and nullifying induced voltage for wireless EV chargers[J]. IEEE Transactions on Power Electronics, 2019, 34(1): 748-758. [19] Jeong S Y, Thai V X, Park J H, et al.Metal object detection system with parallel-mistuned resonant circuits and nullifying induced voltage for wireless EV chargers[C]//2018 International Power Electronics Conference (IPEC), Niigata, 2018: 2564-2568. [20] 张献, 邢子瑶, 薛明, 等. 无线电能传输系统异物检测技术研究综述[J]. 电工技术学报, 2022, 37(4): 793-807. Zhang Xian, Xing Ziyao, Xue Ming, et al.Overview of foreign object detection in wireless power transfer system[J]. Transactions of China Electrotechnical Society, 2022, 37(4): 793-807. [21] 张献, 付志远, 薛明, 等. 无线电能传输阵列式差分线圈金属异物检测方法[J]. 电工电能新技术, 2020, 39(11): 9-17. Zhang Xian, Fu Zhiyuan, Xue Ming, et al.Method for detecting metal foreign object by array differential coil in wireless power transfer system[J]. Advanced Technology of Electrical Engineering and Energy, 2020, 39(11): 9-17. [22] Xiang Lijuan, Zhu Ze, Tian Jindong, et al.Foreign object detection in a wireless power transfer system using symmetrical coil sets[J]. IEEE Access, 2019, 7 44622-44631. [23] Thai V X, Jang G C, Jeong S Y, et al.Symmetric sensing coil design for the blind-zone free metal object detection of a stationary wireless electric vehicles charger[J]. IEEE Transactions on Power Electronics, 2020, 35(4): 3466-3477.
2023, Vol. 38 
