基于电化学阻抗谱的锂离子电池电滥用失效预警研究

doi:10.19595/j.cnki.1000-6753.tces.240602

Abstract
Figure/Table
References
Related Citation (15)

Download: PDF (5978 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract Lithium-ion batteries are booming in new energy generation and electric vehicles, but poor safety is a key constraint to their development.Severe electrical abuse can induce battery failure or thermal runaway, which will affect the lifetime and safety of the energy storage system. Batteries that are not equipped with protection devices usually experience thermal runaway under electrical abuse. Batteries equipped with protection devices (safety valve, current interrupt device (CID)) can provide protection in the electrical abuse, but the irrecoverability of the device will lead to battery failure. It is difficult to achieve fast and reliable failure warning based on voltage and temperature. Electrochemical impedance spectroscopy (EIS) is a non-invasive method for characterizing internal information, and shows obvious advantages in safety warning. In this paper, battery failures caused by severe overcharging or overdischarging are investigated, and the corresponding early warning strategy based on EIS is proposed.The experimental results show that the method has good rapidity and reliability.It can avoid battery failure caused by electrical abuse and guarantee the safe operation of the energy storage system.
Firstly, EIS scanning experiments were carried out at different temperature and state of charge (SOC). The impedance data were analyzed from multiple perspectives, including real part, imaginary part and distribution of relaxation time (DRT).And the characteristic impedance suitable for electrical abuse warning was extracted. The special impedance can reflect abnormal SOC of the battery.Secondly, the evolution rules of voltage, temperature and impedance during abuse were analyzed, and suitable failure warning criteria was extracted. The slope of the characteristic impedance turned from negative to positive before the battery failure.In order to minimize the interference of noisy data and improve the diagnosis, impedance curvature was used for safety warning. Finally, a clustering-based battery failure warning method was proposed. The method can adaptively adjust the parameters according to the working conditions, which in turn is applicable to different charging and discharging currents. Its effectiveness for warning was verified by conducting failure experiments under different working conditions. The algorithm can give an early warning at least 313 s before overcharge failures and at least 114 s before overdischarge failures.
The following conclusions can be drawn from the experimental analysis: (1)The impedance real part in the low and middle frequency bands is strongly correlated with the SOC. For the characteristic impedance (real part at 10 Hz),it will show a local minimum point before both overcharge failure and overdischarge failure. Based on this law, it is feasible to achieve safety warning for battery failure. (2) Compared to the raw data of characteristic impedance, the impedance curvature is a more appropriate warning parameter. The impedance curvature can filter out noise points and amplify the difference of the required minima, which reduces the diagnostic difficulty of the warning algorithm. (3) The density-based spatial clustering of applications with noise (DBSCAN) algorithm shows good performance in battery failure warning. Compared to the traditional threshold discrimination method, the proposed method adjusts the model parameters according to the current magnitude and EIS data, which enhances the model's ability to meet different operating conditions.

Key words： Lithium-ion battery electrochemical impedance spectroscopy (EIS) failure early warning overcharge abuse overdischarge abuse clustering algorithm

Received: 17 April 2024

PACS:

TM911

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	Yuan Aote
	Cai Tao
	Liu Zhengchen
	Luo Hangyu

Cite this article:

Yuan Aote,Cai Tao,Liu Zhengchen等. Study of Electrical Abuse Failure Early Warning of Lithium-Ion Batteries Based on Electrochemical Impedance Spectroscopy[J]. Transactions of China Electrotechnical Society, 2025, 40(7): 2306-2321.

URL:

https://dgjsxb.ces-transaction.com/EN/10.19595/j.cnki.1000-6753.tces.240602 OR https://dgjsxb.ces-transaction.com/EN/Y2025/V40/I7/2306

[1] 张闯, 王泽山, 刘素贞, 等. 基于电化学阻抗谱的锂离子电池过放电诱发内短路的检测方法[J]. 电工技术学报, 2023, 38(23): 6279-6291, 6344.
Zhang Chuang, Wang Zeshan, Liu Suzhen, et al.Detection method of overdischarge-induced internal short circuit in lithium-ion batteries based on electrochemical impedance spectroscopy[J]. Transactions of China Electrotechnical Society, 2023, 38(23): 6279-6291, 6344.
[2] 杨梦洁, 杨爱军, 叶奕君, 等. 基于气体分析的锂离子电池热失控早期预警研究进展[J]. 电工技术学报, 2023, 38(17): 4507-4538.
Yang Mengjie, Yang Aijun, Ye Yijun, et al.Research progress on early warning of thermal runaway of Li-ion batteries based on gas analysis[J]. Transactions of China Electrotechnical Society, 2023, 38(17): 4507-4538.
[3] 王森, 马力群, 侯文杰, 等. 水合盐基无机复合相变材料及其在电池热管理中的应用研究进展[J]. 发电技术, 2025, 46(1): 42-57.
Wang Sen, Ma Liqun, Hou Wenjie, et al.Research progress on hydrated salt-based inorganic composite phase change materials and their applications in battery thermal management[J]. Power Generation Technology, 2025, 46(1): 42-57.
[4] 宿磊, 余嘉川, 杨帆, 等. 磷酸铁锂储能电池过充热失效特征参量研究[J]. 电工技术学报, 2023, 38(21): 5913-5922.
Su Lei, Yu Jiachuan, Yang Fan, et al.Study on characteristic parameters of LFP battery under the condition of overcharge thermal failure[J]. Transactions of China Electrotechnical Society, 2023, 38(21): 5913-5922.
[5] Grandjean T, Barai A, Hosseinzadeh E, et al.Large format lithium ion pouch cell full thermal characterisation for improved electric vehicle thermal management[J]. Journal of Power Sources, 2017, 359: 215-225.
[6] Jin Yang, Zheng Zhikun, Wei Donghui, et al.Detection of micro-scale Li dendrite via H₂ gas capture for early safety warning[J]. Joule, 2020, 4(8): 1714-1729.
[7] 王兵. 车用锂离子动力电池及模组热失控的实验与仿真研究[D]. 北京: 北京工业大学, 2018.
Wang Bing.Study on thermal runaway of lithium-ion power battery or module for electric vehicle through experiment and simulation[D]. Beijing: Beijing University of Technology, 2018.
[8] Zhu Xiaoqing, Wang Zhenpo, Wang Yituo, et al.Overcharge investigation of large format lithium-ion pouch cells with Li(Ni_0.6Co_0.2Mn_0.2)O₂ cathode for electric vehicles: Thermal runaway features and safety management method[J]. Energy, 2019, 169: 868-880.
[9] Guo Zhechen, Xu Jun, Xu Ziming, et al.A three-heat-source electro-thermal coupled model for fast estimation of the temperature distribution of a lithium-ion battery cell[J]. IEEE Transactions on Transportation Electrification, 2022, 8(1): 288-297.
[10] Hussein A A, Fardoun A A.An adaptive sensorless measurement technique for internal temperature of Li-ion batteries using impedance phase spectroscopy[J]. IEEE Transactions on Industry Applications, 2020, 56(3): 3043-3051.
[11] Mc Carthy K, Gullapalli H, Kennedy T.Real-time internal temperature estimation of commercial Li-ion batteries using online impedance measurements[J]. Journal of Power Sources, 2022, 519: 230786.
[12] Su Tonglun, Lyu Nawei, Zhao Zhixing, et al.Safety warning of lithium-ion battery energy storage station via venting acoustic signal detection for grid appli-cation[J]. Journal of Energy Storage, 2021, 38: 102498.
[13] Wu Yi, Wang Youren, Yung W K C, et al. Ultrasonic health monitoring of lithium-ion batteries[J]. Electronics, 2019, 8(7): 751.
[14] 王铭民, 孙磊, 郭鹏宇, 等. 基于气体在线监测的磷酸铁锂储能电池模组过充热失控特性[J]. 高电压技术, 2021, 47(1): 279-286.
Wang Mingmin, Sun Lei, Guo Pengyu, et al.Overcharge and thermal runaway characteristics of lithium iron phosphate energy storage battery modules based on gas online monitoring[J]. High Voltage Engineering, 2021, 47(1): 279-286.
[15] Chen Siqi, Wei Xuezhe, Zhang Guangxu, et al.Mechanical strain signal based early warning for failure of different prismatic lithium-ion batteries[J]. Journal of Power Sources, 2023, 580: 233397.
[16] Mei Wenxin, Liu Zhi, Wang Chengdong, et al.operando monitoring of thermal runaway in commercial lithium-ion cells via advanced lab-on-fiber technologies[J]. Nature Communications, 2023, 14(1): 5251.
[17] Mei Wenxin, Zhang Lin, Sun Jinhua, et al.Experimental and numerical methods to investigate the overcharge caused lithium plating for lithium ion battery[J]. Energy Storage Materials, 2020, 32: 91-104.
[18] Srinivasan R, Demirev P A, Carkhuff B G.Rapid monitoring of impedance phase shifts in lithium-ion batteries for hazard prevention[J]. Journal of Power Sources, 2018, 405: 30-36.
[19] Lyu Nawei, Jin Yang, Xiong Rui, et al.Real-time overcharge warning and early thermal runaway prediction of Li-ion battery by online impedance measurement[J]. IEEE Transactions on Industrial Electronics, 2022, 69(2): 1929-1936.
[20] Menale C, Constà S, Sglavo V, et al.Experimental investigation of overdischarge effects on commercial Li-ion cells[J]. Energies, 2022, 15(22): 8440.
[21] Gan Naifeng, Sun Zhenyu, Zhang Zhaosheng, et al.Data-driven fault diagnosis of lithium-ion battery overdischarge in electric vehicles[J]. IEEE Transactions on Power Electronics, 2022, 37(4): 4575-4588.
[22] Li Bing, Jones C M, Tomar V.Overdischarge detection and prevention with temperature monitoring of Li-ion batteries and linear regression-based machine learning[J]. Journal of Electrochemical Energy Conversion and Storage, 2021, 18(4): 040905.
[23] 张闯, 杨浩, 刘素贞, 等. 基于阻抗在线测量的锂离子电池过放电诱发内短路识别研究[J]. 电工技术学报, 2024, 39(6): 1656-1670.
Zhang Chuang, Yang Hao, Liu Suzhen, et al.Research on overdischarge-induced internal short circuit identification of lithium-ion battery based on impedance online measurement[J]. Transactions of China Electrotechnical Society, 2024, 39(6): 1656-1670.
[24] Zhao Xiaoxiao, Xiong Qing, Huang Xiujun, et al.An overdischarge fault detection method for lithium-ion battery module based on vibration characteristics[C]// 2023 IEEE 6th International Electrical and Energy Conference (CIEEC), Hefei, China, 2023: 4124-4128.
[25] Xu Bin, Kong Lingxi, Wen Guangrui, et al.Protection devices in commercial 18650 lithium-ion batteries[J]. IEEE Access, 2021, 9: 66687-66695.
[26] Wan Ting Hei, Saccoccio M, Chen Chi, et al.Influence of the discretization methods on the distribution of relaxation times deconvolution: implementing radial basis functions with DRT tools[J]. Electrochimica Acta, 2015, 184: 483-499.
[27] 庄全超, 杨梓, 张蕾, 等. 锂离子电池的电化学阻抗谱分析研究进展[J]. 化学进展, 2020, 32(6): 761-791.
Zhuang Quanchao, Yang Zi, Zhang Lei, et al.Research progress on diagnosis of electrochemical impedance spectroscopy in lithium ion batteries[J]. Progress in Chemistry, 2020, 32(6): 761-791.
[28] Itagaki M, Honda K, Hoshi Y, et al.In-situ EIS to determine impedance spectra of lithium-ion rechargeable batteries during charge and discharge cycle[J]. Journal of Electroanalytical Chemistry, 2015, 737: 78-84.
[29] Mc Carthy K, Gullapalli H, Ryan K M, et al.Electrochemical impedance correlation analysis for the estimation of Li-ion battery state of charge, state of health and internal temperature[J]. Journal of Energy Storage, 2022, 50: 104608.
[30] Fear C, Juarez-Robles D, Jeevarajan J A, et al.Elucidating copper dissolution phenomenon in Li-ion cells under overdischarge extremes[J]. Journal of the Electrochemical Society, 2018, 165(9): A1639-A1647.
[31] Lee J, Kwon D, Pecht M G.Reduction of Li-ion battery qualification time based on prognostics and health management[J]. IEEE Transactions on Industrial Electronics, 2019, 66(9): 7310-7315.