电压源激励下表贴式永磁同步电机退磁故障建模与分析

doi:10.19595/j.cnki.1000-6753.tces.240646

Abstract
Figure/Table
References
Related Citation (15)

Download: PDF (3516 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract The demagnetization fault of permanent magnet synchronous motors (PMSM) reduces output performance and load capacity, seriously affecting the motor’s service life. Establishing an accurate fault motor analytical model, conducting rapid electromagnetic performance analysis, and obtaining operational data such as current and torque under fault conditions are beneficial for early prediction and diagnosis of demagnetization faults.
A parameter D is introduced for the partial demagnetization fault of the surface-mounted PMSM prototype, representing the spatial angle of the demagnetized region, defined as the ratio of the spatial angle occupied by the demagnetized region to that of one pole arc. The radial and tangential component equations of the residual magnetization Fourier coefficients as a function of parameter D are derived, which reflect the influence of the spatial angle of the demagnetized region on the magnitude and the waveform of the residual magnetization. An analytical model of PMSM under partial demagnetization is established.
In addition, regarding the control system’s circuit interface in practical applications, an analytical model of demagnetization faults in a PMSM driven by a voltage source inverter with magnetic flux linkage as the intermediate variable is established. This model is applied to the vector control circuit. Thus, a co-simulation model combining the analytical model and the control circuit is created.
The load performance of the prototype is calculated under normal conditions and partial demagnetization using the co-simulation model. Compared with the simulation results from the Ansys/Simplorer time-stepping finite element method and the measured results from the prototype on the experimental platform, the conclusions are as follows. (1) The proposed partial demagnetization analytical model reflects the influence of the demagnetized region on the magnitude and the waveform of the residual magnetization. This model is more consistent with actual conditions than the method of equating partial demagnetization to an overall reduction in magnetic flux linkage. (2) The calculation results of the co-simulation model are in good agreement with the time-stepping finite element simulation results, with the relative errors for the stator flux linkage, stator current, and electromagnetic torque less than 1.5% under normal and partial demagnetization conditions. Furthermore, the computation time of the co-simulation model is only 1/20 that of the finite element model, which greatly improves the operation efficiency. (3) The current waveforms of the prototype under the same control strategy are measured on the experimental platform and subjected to spectral analysis. The results are consistent with the co-simulation results, which validate the accuracy of the co-simulation model, combining the analytical model and the control circuit.

Key words： Permanent magnet synchronous motor demagnetization fault analytical modeling

Received: 24 April 2024

PACS:

TM351

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	Shi Cenwei
	Peng Lin
	Zhang Zhen
	Shi Tingna

Cite this article:

Shi Cenwei,Peng Lin,Zhang Zhen等. Modeling and Analysis of Demagnetization Fault in Surface Mounted Permanent Magnet Synchronous Motors with Voltage Source Excitation[J]. Transactions of China Electrotechnical Society, 2025, 40(8): 2430-2440.

URL:

https://dgjsxb.ces-transaction.com/EN/10.19595/j.cnki.1000-6753.tces.240646 OR https://dgjsxb.ces-transaction.com/EN/Y2025/V40/I8/2430

[1] 章恒亮, 花为. 分布式驱动系统用轮毂电机及其技术综述[J]. 中国电机工程学报, 2024, 44(7): 2871-2886.
Zhang Hengliang, Hua Wei.Overview of in-wheel traction machine and its key techniques for distributed-driving system[J]. Proceedings of the CSEE, 2024, 44(7): 2871-2886.
[2] 张丙楠, 杜博超, 赵天旭, 等. 舰船电力推进电机研究现状与发展综述[J]. 中国电机工程学报, 2022, 42(20): 7608-7623.
Zhang Bingnan, Du Bochao, Zhao Tianxu, et al.Overview of research status and development of ship electric propulsion motors[J]. Proceedings of the CSEE, 2022, 42(20): 7608-7623.
[3] 陈少先, 丁树业, 申淑锋, 等. 船舶用表贴式永磁同步电机的电磁振动分析与抑制[J]. 电工技术学报, 2023, 38(5): 1275-1286, 1298.
Chen Shaoxian, Ding Shuye, Shen Shufeng, et al.Analysis and suppression of electromagnetic vibration of surface mounted permanent magnet synchronous motor for ships[J]. Transactions of China Electro-technical Society, 2023, 38(5): 1275-1286, 1298.
[4] 崔刚, 熊斌, 黄康杰, 等. 电动汽车用永磁电机的失磁空间分布特性及影响因素[J]. 电工技术学报, 2023, 38(22): 5959-5974.
Cui Gang, Xiong Bin, Huang Kangjie, et al.Spatial distribution characteristics and influencing factors of demagnetization of permanent magnet motor for electric vehicle[J]. Transactions of China Electro-technical Society, 2023, 38(22): 5959-5974.
[5] 谢颖, 姜佳宁, 蔡蔚, 等. 表贴式高速永磁同步电机失磁故障及磁体选区渗重稀土研究[J]. 电机与控制学报, 2024, 28(2): 44-53.
Xie Ying, Jiang Jianing, Cai Wei, et al.Demag-netization failure of surface mount high speed permanent magnet synchronous motor and local infiltration of heavy rare earth[J]. Electric Machines and Control, 2024, 28(2): 44-53.
[6] 张丹, 赵吉文, 董菲, 等. 基于概率神经网络算法的永磁同步直线电机局部退磁故障诊断研究[J]. 中国电机工程学报, 2019, 39(1): 296-306, 344.
Zhang Dan, Zhao Jiwen, Dong Fei, et al.Partial demagnetization fault diagnosis research of per-manent magnet synchronous motors based on the PNN algorithm[J]. Proceedings of the CSEE, 2019, 39(1): 296-306, 344.
[7] 张建军, 岳啸鸣, 赵克斌, 等. 一起330MW汽轮发电机转子绕组短路故障分析及处理[J]. 电气技术, 2023, 24(3): 69-72.
Zhang Jianjun, Yue Xiaoming, Zhao Kebin, et al.Analysis and treatment of a 330MW turbine-generator rotor winding short circuit fault[J]. Electrical Engin-eering, 2023, 24(3): 69-72.
[8] 许小伟, 李随, 杨炎, 等. 基于数值计算的电机耦合故障特征提取[J]. 智能计算机与应用, 2021, 11(10): 43-49, 54.
Xu Xiaowei, Li Sui, Yang Yan, et al.Motor coupling fault feature extraction based on numerical calcu-lation[J]. Intelligent Computer and Applications, 2021, 11(10): 43-49, 54.
[9] 邱建琪, 沈佳晨, 史涔溦, 等. 基于残差卷积网络的多传感器融合永磁同步电机故障诊断[J]. 电机与控制学报, 2024, 28(7): 24-33, 42.
Qiu Jianqi, Shen Jiachen, Shi Cenwei, et al.Fault diagnosis of multi-sensor fusion permanent magnet synchronous motor based on residual convolutional neural network[J]. Electric Machines and Control, 2024, 28(7): 24-33, 42.
[10] 黄建, 尹佐生, 王天乙, 等. 基于容错齿磁通的五相永磁电机匝间短路故障诊断[J]. 电工技术学报, 2023, 38(14): 3733-3744.
Huang Jian, Yin Zuosheng, Wang Tianyi, et al.Diagnosis of inter-turn short-circuit fault for five-phase permanent magnet machine based on fault-tolerant tooth flux[J]. Transactions of China Electro-technical Society, 2023, 38(14): 3733-3744.
[11] 高彩霞, 苗壮, 陈昊, 等. 基于线圈子单元的永磁同步电机健康与定子绕组短路故障数学模型[J]. 电工技术学报, 2023, 38(4): 957-969.
Gao Caixia, Miao Zhuang, Chen Hao, et al.A mathematical model based on coil sub-element for permanent magnet synchronous motor with health and stator winding short-circuit fault[J]. Transactions of China Electrotechnical Society, 2023, 38(4): 957-969.
[12] Zeng Chong, Huang Song, Lei Jiayin, et al.Online rotor fault diagnosis of permanent magnet syn-chronous motors based on stator tooth flux[J]. IEEE Transactions on Industry Applications, 2021, 57(3): 2366-2377.
[13] Ullah Z, Lee S T, Hur J.A torque angle-based fault detection and identification technique for IPMSM[J]. IEEE Transactions on Industry Applications, 2020, 56(1): 170-182.
[14] Usman A, Rajpurohit B S.Modeling and classification of stator inter-turn fault and demagnetization effects in BLDC motor using rotor back-EMF and radial magnetic flux analysis[J]. IEEE Access, 2020, 8: 118030-118049.
[15] Xu Qi, Liu Xuyang, Miao Wenchao, et al.Online detecting magnet defect fault in PMSG with magnetic sensing[J]. IEEE Transactions on Transportation Electrification, 2021, 7(4): 2775-2786.
[16] Li Zhaokai, Huang Xiaoyan, Yu Yelong, et al.Nonlinear analytical modelling for surface-mounted permanent magnet motors with magnet defect fault[J]. IEEE Transactions on Energy Conversion, 2022, 37(3): 1955-1964.
[17] De Bisschop J, Sergeant P, Dupré L.Demagnetization fault detection in axial flux PM machines by using sensing coils and an analytical model[J]. IEEE Transactions on Magnetics, 2017, 53(6): 8203404-8203407.
[18] De Bisschop J, Sergeant P, Hemeida A, et al.Analytical model for combined study of magnet demagnetization and eccentricity defects in axial flux permanent magnet synchronous machines[J]. IEEE Transactions on Magnetics, 2017, 53(9): 8107712.
[19] Verkroost L, De Bisschop J, Vansompel H, et al.Active demagnetization fault compensation for axial flux permanent-magnet synchronous machines using an analytical inverse model[J]. IEEE Transactions on Energy Conversion, 2020, 35(2): 591-599.
[20] Quintal-Palomo R E, Flota-Bañuelos M, Bassam A, et al. Post-fault demagnetization of a PMSG under field oriented control operation[J]. IEEE Access, 2021, 9: 53838-53848.
[21] Shi Cenwei, Peng Lin, Zhang Zhen, et al.Analytical modeling and analysis of permanent-magnet motor with demagnetization fault[J]. Sensors (Basel, Switzerland), 2022, 22(23): 9440.
[22] Wu L J, Zhu Z Q, Staton D, et al.Analytical prediction of electromagnetic performance of surface-mounted PM machines based on subdomain model accounting for tooth-tips[J]. IET Electric Power Applications, 2011, 5(7): 597-609.
[23] Zheng Bining, Zhang Zhen, Yan Dong, et al.A direct field-circuit coupled analytical modelling method for permanent magnet motor operation performance analysis[J]. IET Electric Power Applications, 2023, 17(2): 149-160.
[24] Zafarani M, Goktas T, Akin B.A comprehensive analysis of magnet defect faults in permanent magnet synchronous motors[C]//2015 IEEE Applied Power Electronics Conference and Exposition (APEC), Charlotte, NC, USA, 2015: 2779-2783.