Abstract:In this paper, a fast unloading transient response Buck converter using coupled-inductor auxiliary circuits based sequence switching control scheme is proposed, so as to improve the unloading transient response of the time-optimal control (TOC) scheme. The proposed auxiliary coupled inductor circuit is controlled to connect in parallel with the input voltage source, so as to increase the inductor-current slew rate during an unloading transient. Furthermore, an ‘n+1’ sequence switching strategy is proposed to control the auxiliary coupled inductor. With the proposed control strategy the load transient event is divided into n+1 sub-periods, and in each sub-period, the capacitor-charge balance principle is used to determine the switching time sequence. In addition, the system voltage overshoot is determined by the maximum voltage overshoot in each of n+1 periods, and the settling time is shortened to the moment that the inductor current reached the output current firstly. Moreover, a 12V/3.3V synchronous Buck converter has been built to verify the feasibility of the proposed scheme.
赵朝阳, 卢伟国, 胡志凌, 马俊文, 周雒维. 耦合电感序列切换的快速卸载瞬态响应Buck变换器[J]. 电工技术学报, 2020, 35(zk1): 28-36.
Zhao Zhaoyang, Lu Weiguo, Hu Zhiling, Ma Junwen, Zhou Luowei. Fast Unloading Transient Response Buck Converter Using Coupled Inductor Based on Sequence Switching Control. Transactions of China Electrotechnical Society, 2020, 35(zk1): 28-36.
[1] 张希, 沙金, 徐杨军, 等. 恒定导通时间电容电流控制Buck变换器研究[J]. 电工技术学报, 2015, 30(23): 18-23. Zhang Xi, Sha Jin, Xu Yangjun, et al.Research on the constant on-time capacitor current control of Buck converters[J]. Transactions of China Electro- technical Society, 2015, 30(23): 18-23. [2] 高峡, 冯全源. 一种适用于基于纹波的恒定导通时间架构Buck变换器片内纹波补偿方案[J]. 电工技术学报, 2018, 33(4): 892-899. Gao Xia, Feng Quanyuan.An on-chip ripple com- pensation scheme for ripple-based constant on-time architecture Buck converter[J]. Transactions of China Electrotechnical Society, 2018, 33(4): 892-899. [3] 崔恒丰, 周国华, 陈兴. 伪连续导电模式Buck变换器的动态参考电流控制策略[J]. 电工技术学报, 2017, 32(2): 246-254. Cui Hengfeng, Zhou Guohua, Chen Xing.Dynamic- reference-current control strategy for Buck converter in pesudo continuous conduction mode[J]. Transa- ctions of China Electrotechnical Society, 2017, 32(2): 246-254. [4] 徐杨, 钱挺. 恒定导通时间控制Buck变换器的间隔周期斜率补偿方案[J]. 电工技术学报, 2017, 32(4): 58-65. Xu Yang, Qian Ting.Every other cycle ramp com- pensation for Buck converters with constant on-time control[J]. Transactions of China Electrotechnical Society, 2017, 32(4): 58-65. [5] 魏业文, 李应智, 曹斌, 等. 含Buck电路的锂电池低功耗电量均衡技术研究[J]. 电工技术学报, 2018, 33(11): 2575-2583. Wei Yewen, Li Yingzhi, Cao Bin, et al.Research on power equalization of lithium-ion batteries with less-loss Buck chopper[J]. Transactions of China Electrotechnical Society, 2018, 33(11): 2575-2583. [6] 周国华, 许建平. 开关变换器调制与控制技术综述[J]. 中国电机工程学报, 2014, 34(6): 815-831. Zhou Guohua, Xu Jianping.A review of modulation and control techniques for switching converters[J]. Proceedings of the CSEE, 2014, 34(6): 815-831. [7] 章伟, 周国华, 刘啸天, 等. 具有快速负载瞬态响应的开关变换器数字均值电压控制方法[J]. 电工技术学报, 2018, 33(4): 856-864. Zhang Wei, Zhou Guohua, Liu Xiaotian, et al.Digital average voltage control technique for switching converter with fast load transient response[J]. Transa- ctions of China Electrotechnical Society, 2018, 33(4): 856-864. [8] 张凯暾, 周国华, 周述晗, 等. 峰值I2C控制Buck型LED驱动电源稳定性分析[J]. 电工技术学报, 2018, 33(8): 1793-1801. Zhang Kaitun, Zhou Guohua, Zhou Shuhan, et al.Stability analysis of peak I2C controlled LED power driver based on Buck converter[J]. Transactions of China Electrotechnical Society, 2018, 33(8): 1793-1801. [9] 卢伟国, 栗安鑫, 周雒维, 等. 零扰动补偿控制电流模式Buck变换器[J]. 电工技术学报, 2014, 29(8): 90-96. Lu Weiguo, Li Anxin, Zhou Luowei, et al.Zero- perturbation compensation control of current-mode Buck converter[J]. Transactions of China Electro- technical Society, 2014, 29(8): 90-96. [10] Huerta S C, Alou P, Oliver J Á, et al.Nonlinear control for DC-DC converters based on hysteresis of the cout current with a frequency loop to operate at constant frequency[J]. IEEE Transactions on Indu- strial Electronics, 2011, 58(3): 1036-1043. [11] 倪雨, 许建平, 王金平, 等. 滞环调制全局滑模控制Buck变换器设计[J]. 中国电机工程学报, 2010, 30(21): 1-6. Ni Yu, Xu Jianping, Wang Jinping, et al.Design of global sliding mode control Buck converter with hysteresis modulation[J]. Proceedings of the CSEE, 2010, 30(21): 1-6. [12] 刘晓东, 蒋昌虎, 邱亚杰, 等. Buck变换器动态过程电容充放电平衡控制策略[J]. 电机与控制学报, 2010, 14(6): 77-82. Liu Xiaodong,Jiang Changhu,Qiu Yajie,et al.A control algorithm based on capacitor charge balance during transient for Buck converter[J]. Electric Machines and Control, 2010, 14(6): 77-82. [13] Meyer E, Zhang Zhiliang, Liu Yanfei.An optimal control method for Buck converters using a practical capacitor charge balance technique[J]. IEEE Transa- ctions on Power Electronics, 2008, 23(4): 1802-1812. [14] 赵晋斌, 戴剑丰, 屈克庆. 基于电容电荷平衡的滞环控制策略[J]. 电工技术学报, 2015, 30(16): 63-69. Zhao Jinbin, Dai Jianfeng, Qu Keqing.A hysteresis control strategy based on capacitor charge balance[J]. Transactions of China Electrotechnical Society, 2015, 30(16): 63-69. [15] Singh R P, Khambadkone A M.A Buck-derived topology with improved step-down transient perfor- mance[J]. IEEE Transactions on Power Electronics, 2008, 23(6): 2855-2866. [16] Gu Yu, Zhang Donglai.Voltage regulator buck converter with a tapped inductor for fast transient response application[J]. IEEE Transactions on Power Electronics, 2014, 29(12): 6249-6254. [17] Ahsanuzzaman S M, Parayandeh A, Prodić A, et al.Load-interactive steered-inductor DC-DC converter with minimized output filter capacitance[C]//Applied Power Electronics Conference and Exposition, Palm Springs, CA, 2010: 980-985. [18] Kapat S, Shenoy P S, Krein P T.Near-null response to large-signal transients in an augmented Buck converter: a geometric approach[J]. IEEE Transa- ctions on Power Electronics, 2012, 27(7): 3319-3329. [19] Šviković V, Cortés J J, Alou P, et al.Multiphase current-controlled Buck converter with energy recycling output impedance correction circuit (OICC)[J]. IEEE Transactions on Power Electronics, 2015, 30(9): 5207-5222.