Abstract：The converters are widely used in distributed power generation systems. The input & output impedance and control loop designs of all levels converter should be considered together for the dynamic and static characteristics both of converters and system integration. As one kind of the Buck mode converters, the phase-shift full bridge DC-DC converters are widely used in high frequency and high power field. Compared with voltage control mode, the average current control mode could make the converters get better dynamic and static characteristics. Based on average current control mode phase-shift full bridge DC-DC converter as an example, the relationship between the closed-loop output impedance and control loop parameters is revealed in the paper, the current and voltage loop compensation network parameters design rules also are discussed. In condition of the dynamic and static characteristics of the single stage converter, closed-loop output impedance rush of converter is also constraint to ensure stable and reliable work after system integration. System simulation and experimental results verified the theoretical analysis.
陈轶涵, 韦徵, 龚春英. 平均电流控制型移相全桥DC-DC变换器输出阻抗及控制环路优化设计[J]. 电工技术学报, 2013, 28(4): 43-49.
Chen Yihan, Wei Zheng, Gong Chunying. Study of Output Impedance and Control Loop Optimization for Average Current Mode Control Phase-Shift Full Bridge DC-DC Converter. Transactions of China Electrotechnical Society, 2013, 28(4): 43-49.
[1] 朱成花, 石健将, 严仰光. 带有前级DC/DC变换器与逆变器相互作用分析[J]. 南京航空航天大学学报, 2004, (36)5: 574-578. [2] 王勇, 谢小高. 燃料电池电力变换器的低频纹波电流抑制策略[J]. 电力系统自动化, 2008, (32)23: 86-89. [3] Changrong Liu, Jihsheng Lai. Low frequency current ripple reduction technique with active control in a fuel cell power system with inverter load[J]. IEEE Transactions on Industry electronics, 2007, (22)4: 1429-1436. [4] 高军, 赵向华, 王兆安. DC/DC变换器与DC/AC逆变器连接问题的研究[J]. 电源技术应用, 2001, (8)24: 40-42. [5] Schenck M, Stanton K, Lai J S.Fuel cell and power conditioning system interactions[C]. IEEE Applied Power Electronics Conference, Austin, TX, 2005, 114-120. [6] Fontes G, Turpin C, Saisset R, et al. Interactions between fuel cells and power converters influence of current harmonics on a fuel cell stack[C]. IEEE Power Electronics Specialists Conference, Aachen, Germany, 2004, 4729-4735. [7] Middlebrook R D. Input filter considerations in design and application of switching regulators[C]. IEEE Institute for Advanced Studies Annual Meeting, Chicago, 1976: 336-382. [8] Ruan X, Yan Y.A novel zero-voltage and zero-current-switching PWM full bridge converter using two diodes in series with the lagging leg[J]. IEEE Transactions on Industry electronics. 2001, (48)4: 177-785. [9] Ruan X, Yan Y. Soft-switching techniques for PWM full bridge converter[C]. IEEE Power Electronics Specialist Conference, 2000: 634-639. [10] 王建华, 张方华, 龚春英. 电压控制型Buck DC/DC变换器输出阻抗优化设计研究[J]. 电工技术学报, 2007, (1)19: 85-90. [11] 陈乾宏, 殷兰兰, 王健, 等. 二极管加电流互感器箝位的移相全桥DC/DC变换器[J]. 中国电机工程学报, 2008, (28)15: 23-32. [12] Ridley R B, Cho B H, Lee F C. Analysis and interpretation of loop gains of multiloop-controlled switching regulators[J]. IEEE Transactions on Power Electronics, 1988, 3(4): 489-498. [13] Ridley R B. A new continuous-time model for current-mode control[J]. IEEE Transactions on Power Electronics, 1991, 6(2): 271-280. [14] Tang W, Lee F C, Ridley R B. Small-signal modeling of average current-mode control[J]. IEEE Transactions on Power Electronics, 1993, 8(2): 112-119.
2013, Vol. 28 
