Transactions of China Electrotechnical Society  2023, Vol. 38 Issue (7): 1910-1920    DOI: 10.19595/j.cnki.1000-6753.tces.211741
Current Issue| Next Issue| Archive| Adv Search |
Research on Model Predictive Control of ANPC-5L Permanent Magnet Synchronous Motor Based on Feedforward Decoupling
Song Lin, Nie Ziling, Ye Weiwei, Xu Jie
National Key Laboratory of Science and Technology on Vessel Integrated Power System Naval University of Engineering Wuhan 430033 China

Download: PDF (4418 KB)   HTML (1 KB) 
Export: BibTeX | EndNote (RIS)      
Abstract  High voltage and large capacity power converter is an important part of power system. However, due to the current voltage level of power devices, the traditional three-level Neutral point clamped topology (NPC) is difficult to apply to high voltage converters above 6kV. In recent years, Active Neutral Point Clamped five-Level (ANPC-5L) has received extensive attention at home and abroad. It has the advantages of few power components, high system efficiency and the ability to achieve capacitive voltage balance control in the full power factor range. In order to solve the problem that the SVPWM algorithm of ANPC-5L topology is too complex and difficult to realize capacitor voltage decoupling control, an organic combination of feedforward decoupling control and model predictive control algorithm is presented in this paper to realize multi-objective control of motor. The effectiveness of the proposed algorithm is verified by simulation and experimental comparison.
Firstly, the equivalent SVPWM algorithm of ANPC-5L topology is realized by using single vector MPC and carrier phase shift. To reduce the computational load of MPC, the optimization method of vector selection is designed. Some voltage vectors that do not meet the constraint conditions are eliminated to reduce the number of scrolling optimizations. Therefore, the constraint conditions for the selection of the output voltage vector of the converter are set as follows: the maximum single-phase level hop variable is 1, cross-level hop is not allowed. Thus, the voltage vectors involved in the calculation of a single control period are reduced from 125 to 27. Therefore, the calculation amount of the algorithm is reduced and the operation efficiency of the algorithm is improved.
In order to achieve the balance between the bus capacitor voltage and the suspended capacitor voltage, the duty ratio of the switching function is controlled by double modulated signals respectively. The decoupling control of midpoint current and suspension capacitance current is realized by feedforward compensation. In each control period, 27 possible discrete modulation signal combinations are substituted into the current prediction equation to calculate the variable predicted value of the next period. Simulation and experimental results show that the proposed model predictive control algorithm can realize the multi-objective optimization control of motor drive and multilevel voltage balancing. Therefore, the drive performance of the motor is ensured and the capacitor voltage is equalized effectively.
Key wordsActive neutral point clamped five level(ANPC-5L)      feedforward decoupling control      optimization algorithm of model predictive control      permanent magnet synchronous motor(PMSM)     
Received: 30 October 2021     
PACS: TM464  
Service
E-mail this article
Add to my bookshelf
Add to citation manager
E-mail Alert
RSS
Articles by authors
Song Lin
Nie Ziling
Ye Weiwei
Xu Jie
Cite this article:   
Song Lin,Nie Ziling,Ye Weiwei等. Research on Model Predictive Control of ANPC-5L Permanent Magnet Synchronous Motor Based on Feedforward Decoupling[J]. Transactions of China Electrotechnical Society, 2023, 38(7): 1910-1920.
URL:  
https://dgjsxb.ces-transaction.com/EN/10.19595/j.cnki.1000-6753.tces.211741     OR     https://dgjsxb.ces-transaction.com/EN/Y2023/V38/I7/1910
Copyright © Transactions of China Electrotechnical Society
Supported by: Beijing Magtech