一种具有无损钳位电路的三绕组全桥变换器

Abstract
Figure/Table
References
Related Citation (15)

Download: PDF (1012 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract For high output voltage and high power full bridge converter with wide range of input voltage, the secondary rectifier diodes in a traditional clamp circuit suffer from too high voltage stress. A three windings full bridge converter with a lossless clamp circuit is proposed in this paper. The converter achieves that the upper limit of input voltage is more than twice as high as the lower limit, and the voltage stress of the rectifier diodes is effectively clamped to the output voltage. Firstly, the calculation formula of rectifier diode voltage stress is derived. Secondly, the problems in the present clamp circuit are analyzed. The working principle of the proposed clamp circuit is elaborated in detail. Theoretical analysis is carried out to optimize the secondary windings’ turn ratio to achieve the wide range of input voltage. A 300W prototype is developed to verify the validity of the theoretical analysis. Finally, the PSPICE simulation results show the proposed three windings full bridge converter is suitable for the high voltage and high power applications.

Key words： Lossless clamp circuit full bridge converter three windings converter wide range of input voltage winding turn ratio

Received: 09 December 2010 Published: 27 June 2014

PACS:

TM46

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	Yuan Dengke
	Zhan Lingwei
	Wang Xing
	Zhang Yicheng

Cite this article:

Yuan Dengke,Zhan Lingwei,Wang Xing等. A Three Windings Full Bridge Converter with a Lossless Clamp Circuit[J]. Transactions of China Electrotechnical Society, 2014, 29(4): 19-26.

URL:

http://dgjsxb.ces-transaction.com/EN/ OR http://dgjsxb.ces-transaction.com/EN/Y2014/V29/I4/19

[1] Sabate J A, Vlatkovic V, Ridley R B, et al. Design considerations for high-voltage high-power full- bridge zero voltage-switched PWM converter[C]. IEEE Applied Power Electronics Conference, 1990: 275-284.
[2] Mweene L H, Wright C A, Schlecht M F. A 1 kW 500 kHz front-end converter for a distributed power supply system[J]. IEEE Transactions on Power Electronics, 1991, 6(3): 398-407.
[3] Lin S, Chen C. Analysis and design for RCD clamped snubber used in output rectifier of phase-shift full bridge-bridge ZVS converters[J]. IEEE Transactions on Industrial Electronics, 1998, 45(2): 358-359.
[4] Sabate J A, Vlatkovic V, Ridley R B, et al. High- voltage, high-power, ZVS, full-bridge PWM converter employing an active snubber[C]. IEEE Applied Power Electronics Conference, 1991: 158-163.
[5] Cho J G, Rim G H, Lee F C. Zero voltage and zero current switching full bridge PWM converter using secondary active clamp[C]. IEEE Power Electronics Specialist Conference, 1996: 657-663.
[6] Dudrik J, Spánik P, Trip N D. Zero-voltage and zero-current switching full-bridge DC-DC converter with auxiliary transformer[J]. IEEE Transactions on Power Electronics, 2006, 21(5): 1328-1335.
[7] Chen T F, Cheng S. A novel zero-voltage zero-current switching full-bridge PWM converter using improved secondary active clamp[C]. IEEE International Symposium on Industrial Electronics, 2006: 1683-1687.
[8] 孙铁成, 郭建辉, 王宏佳, 等. 改进型具有电压钳位的全桥ZVZCS PWM DC/DC变换器. 电工技术学报, 2007, 22(7): 47-51.
Sun T C, Guo J H, Wang H J, et al. Improved full-bridge ZVZCS PWM DC/DC converter using voltage clamping[J]. Transactions of China Electrote- chnical Society, 2007, 22(7): 47-51.
[9] Dudrik J, Spánik P, Trip N D. Soft-Switching PS-PWM DC-DC converter for full-load range applications[J]. IEEE Transactions on Power Electronics, 2010, 57(8): 2807-2814.
[10] Kim E S, Joe K Y, Kye M H, et al. An improved soft switching PWM FB DC/DC converter for reducing conduction losses[J]. IEEE Transactions on Power Electronics, 1999, 14(2): 258-264.
[11] Park K B, Kim C E, Moon G W, et al. Voltage oscillation reduction techniques for phase-shift full- bridge converter[J]. IEEE Transactions on Industrial Electronics, 2007, 54(5): 2779-2790.
[12] 陈武, 阮新波, 张容荣. 加复位绕组的零电压开关PWM全桥变换器[J]. 电工技术学报, 2007, 22(11): 117-124.
Chen Wu, Ruan X B, Zhang R R. ZVS PWM full-bridge converter with reset winding[J], Transac- tions of China Electrotechnical Society, 2007, 22(11): 117-124.
[13] 孙铁成, 王宏佳, 张学广, 等. 一种采用无源箝位电路的新型零电压零电流开关变换器[J]. 中国电机工程学报, 2006, 26(17): 72-76.
Sun T C, Wang H J, Zhang X G, et al. A novel ZVZCS converter using passive clamp circuit[J], Proceedings of the CSEE, 2006, 26(17): 72-76
[14] Ting S T, Nianci H. A novel zero voltage and zero current switching full bridge PWM converter[C]. IEEE Applied Power Electronics Conference, 2003: 1088-1092.
[15] Song T T, Huang N. A novel zero-voltage and zero current switching full-bridge PWM converter[J]. IEEE Transactions on Power Electronics, 2005, 20(2): 286-291.
[16] Song T T, Huang N C, Ioinovici A. A family of zero-voltage and zero-current-switching three-level DC-DC converters with secondary-assisted regen- erative passive snubber[J]. IEEE Transactions on Circuits and Systems, 2005, 52(11): 2473-2481.
[17] Wu X, Xie X, Zhang J, et al. Soft switched full bridge DC-DC converter with reduced circulating loss and filter requirement[J]. IEEE Transactions on Power Electronics, 2007, 22(5): 1949-1955.
[18] Wu X, Xie X, Zhao C, et al. Low voltage and current stress ZVZCS full bridge DC-DC converter using center tapped rectifier reset[J]. IEEE Transactions on Industrial Electronics, 2008, 55(3): 1470-1477.
[19] Cho J G, Baek J W, Jeong C Y, et al. Novel zero-voltage and zero-current-switching full-bridge PWM converter using a simple auxiliary circuit[J]. IEEE Transactions on Industrial Applications, 1999, 35(1): 15-20.
[20] Bendre A, Norris S, Divan D, et al. New high power DC-DC converter with loss limited switching and lossless secondary clamp[J]. IEEE Transactions on Power Electronics, 2003, 18(4): 1020-1027.
[21] Bendre A, Wallace I, Luckjiff G A, et al. Design considerations for a soft-switched modular 2. 4-MVA medium-voltage drive[J]. IEEE Transactions on Power Electronics, 2002, 38(5): 1400-1411.
[22] Bendre A, Venkataramanan G, Divan D. Dynamic analysis of loss-limited switching full-bridge DC-DC converter with multimodal control[J]. IEEE Transa- ctions on Power Electronics, 2003, 39(3): 854-863.
[23] Cha H Y, Chen L H, Ding R J, et al. An alternative energy recovery clamp circuit for full-bridge PWM converters with wide ranges of input voltage[J]. IEEE Transactions on Power Electronics, 2008, 23(6): 2828-2837.