|
|
|
| Evaluation Methods of Creep Corrosion onImmersion Silver Finished Printed Circuit Boards |
| Zhou Yilin1, Michael Pecht2 |
| 1. Beijing University of Posts and Telecommunications Beijing 100876 China 2. CALCE Electronic Products and Systems Center University of Maryland College Park 20742 USA |
|
|
|
|
Abstract This paper discusses failure issues of immersion silver (ImAg) finished printed circuit boards (PCBs) under high-sulfur environments with a focus on creep corrosion. It is found that the coverage extent of ImAg finish on pads is dependent on the relative location of the pad edges and the solder mask, which causes the different formation extent, the creep distance and the compositions of the corrosion products with dendrite shape. The simulation approach is studied by adapting clays containing sulfur as the source to drive creep corrosion on ImAg finished PCBs. Weibull distribution with two parameters is used to analyze the length of creep corrosion products, and the creep corrosion resistance of ImAg finished PCBs is quantitatively evaluated by the mean length. The effects of the corrosion time, the times of heating the clays and increasing relative humidity on the simulation tests are studied. Both the evaluation method for the creep corrosion resistance of ImAg finished PCBs by sulfur contained clays and the simulation method for the harsh industrial environments are proposed.
|
|
Received: 20 February 2010
Published: 07 March 2014
|
|
|
|
|
|
[1] Directive 2002/95/EC of the European Parliament and of the Council of 27 January 2003, The restriction of the use of certain hazardous substances in electrical and electronic equipment[S].
[2] Cullen D, Kline B, Moderhock G, et al. Effects of surface finish on high frequency signal loss using various substrate materials[C]. Proceedings of IPC Expo, Anaheim, CA, USA, 2001.
[3] Barbetta M. The search for the universal surface finish[J]. Printed Circuit Design & Manufacture, 2004, 21(2): 34-38.
[4] United States Environmental Protection Agency. EPA-744-R-01-001, alternative technologies for surface finishing: cleaner technologies for printed wiring board manufacturers[S]. 2001: 1-42.
[5] Mazurkiewicz P. Accelerated corrosion of printed circuit boards due to high levels of reduced sulfur gasses in industrial environments[C]. Proceedings of the 32nd International Symposium for Testing and Failure Analysis, Austin, TX, USA, 2006: 469-473.
[6] Cullen D. Surface tarnish and creeping corrosion on Pb-free circuit board surface finishes[C]. IPC Works, Las Vegas, USA, 2005.
[7] Xu C, Flemming D, Demerkin K. Corrosion resistance of PWB surface finishes[C]. Alcatel-Lucent, Apex, Los Angeles, CA, USA, 2007.
[8] Schueller R. Creep corrosion on lead-free printed circuit boards in high sulfur environments[C]. SMTA International Conference, Orlando, Fl, USA, 2007:643-654.
[9] Bagotzky V S. Fundamentals of electrochemistry[M]. New York and London：Plenum Press, 1993.
[10] Zhao P, Pecht M. Field failure due to creep corrosion on components with palladium preplated leadfra- mes[J]. Microeletronics Reliability, 2003, 43(5): 775-783. |
|
|
|
2011, Vol. 26 
