Abstract：Sensorless control of 12/10 flux-switching permanent magnet(FSPM) motor with high-frequency pulsating sinusoidal signal injection was carried out on the basis of salient pole verification. The traditional signal modulation method was analyzed, and then a direct signal process method was proposed. The idea of the proposed method was that q-axis current signal of the estimated synchronous rotating reference frame processed through the band pass filter(BPF) directly multiplied by the square wave signal to get the position error signal, which could eliminate the low-pass filter to make the signal process simple. Lastly through experiment, the traditional signal process method and direct signal process method with high-frequency pulsating sinusoidal signal injection were compared to verify the validity of theory analysis on FSPM motor.
许培林, 邓智泉, 王宇, 熊树. 基于脉振高频正弦信号注入的12/10极永磁磁通切换电机无位置传感器技术[J]. 电工技术学报, 2013, 28(1增): 307-313.
Xu Peilin, Deng Zhiquan, Wang Yu, Xiong Shu. Sensorless Drive of 12/10 Flux-Switching Permanent Magnet Motor with High-Frequency Pulsating Sinusoidal Signal Injection. Transactions of China Electrotechnical Society, 2013, 28(1增): 307-313.
[1] Zhu Z Q, Pang Y, Howe D, et al. Analysis of electromagnetic performance of flux-switching permanent magnet machines by non-linear adaptive lumped parameter magnetic circuit model[J]. IEEE Transactions On Magnetics, 2005, 41(11): 4277-4287. [2] Zhu Z Q, Chen J T. Advanced flux-switching permanent magnet brushless machines[J]. IEEE Transactions on Magnetics, 2010, 46(6): 1447-1453. [3] Chen J T, Zhu Z Q. Winding configurations and optimal stator and rotor pole combination of flux-switching PM brushless AC machines[J]. IEEE Transactions on Energy Conversion, 2010, 25(2): 293-302. [4] Cheng Ming, Chau K T, Chan C C. Static characteristics of a new doubly salient permanent magnet machine[J]. IEEE Transactions on Energy Conversion, 2001, 16(1): 20-25. [5] Wu R, Slemon G R. A permanent magnet motor drive without a shaft sensor[J]. IEEE Transactions on Industry Application, 1991, 27(5): 1005-1011. [6] Shen J X, Zhu Z Q, Howe D. Sensorless flux- weakening control of permanent-magnet brushless machines using third harmonic back EMF[J]. IEEE Transactions on Industry Application, 2004, 40(6): 1629-1636. [7] Genduso F, Miceli R, Rando C, et al. Back EMF sensorless-control algorithm for high-dynamic performance PMSM[J]. IEEE Transactions Industry Electronics, 2010, 57(6): 2092-2100. [8] Jansen P L, Lorenz R D. Transducerless position and velocity estimation in induction and salient AC machines[J]. IEEE Transactions on Industry Application, 1995, 31(2): 240-247. [9] Bianchi N, Bolognami S, Jang J H, et al. Comparison of PM motor structures and sensorless control techniques for zero-speed rotor position detection[J]. IEEE Transactions on Power Electron., 2007, 22(6): 2466-2475. [10] Zhu Z Q, Gong L M. Investigation of effectiveness of sensorless operation in carrier signal injection based sensorless-control methods[J]. IEEE Transactions Industry Electronics, 2011, 58(8): 3431-3439. [11] Jeong Y, Lorenz R D, Jahns T M, et al．Initial rotor position estimation of an interior permanent-magnet synchronous machine using carrier-frequency injection methods[J]. IEEE Transactions on Industry Applications, 2005, 41(1): 38-45. [12] Jang J H, Sul S K, Ha J I, et al. Sensorless drive of surface mounted permanent magnet motor by high- frequency signal injection based on magnetic saliency[J]. IEEE Transactions on Industry Applications, 2003, 39(4): 1031-1039. [13] Jang Ji Hoon, Ha Jung Ik, Motomichi Ohto, et al. Analysis of permanent magnet machine for sensorless control based on high- frequency signal injection[J]. IEEE Transactions on Industry Applications, 2004, 40(6): 1595-1604. [14] Li Y, Zhu Z Q, Howe D, et al. Improved rotor position estimation by signal injection in brushless AC motors, accounting for cross-coupling magnetic saturation[J]. IEEE Transactions on Industry Applications, 2009, 45(5): 1843-1849. [15] Yoon Y D, Sul S K, Morimoto S, et al. High bandwidth sensorless algorithm for AC machines based on square-wave type voltage injection[C]. Conference Recorder of IEEE ECCE, 2009, 20-24, 2123-2130. [16] Wang K, Shen J X, Dong S Z, et al. Sensorless control and initial position estimation of permanent magnet flux switching motor[C]. Proceeding of the International Conference on Electrical Machines and Systems, Seoul, Korea, 2007. [17] 胡寿松. 自动控制原理[M]. 5版. 北京: 科学出版社,2007.
2013, Vol. 28 
