|
|
|
| IGBT Open-Circuit Fault Diagnosis of Modular Multilevel Converter Sub-Module Based on Short-Time Fourier Transform and Deep Networks |
| Zhu Qinyue, Yu Yichen, Zhan Yanwen, Li Jie, Hua Runkai |
| School of Electrical and Information Engineering Tongji University Shanghai 201804 China |
|
|
|
Abstract The modular multilevel converter (MMC) is a new type of multilevel converter that features low switch frequency, high output waveform quality, and low consistency requirements for power electronic device switching. Therefore, it has been widely applied in various fields such as flexible DC transmission, power electronic transmission, and rail transit traction control. However, the increase in the number of sub-modules also means an increase in potential failure points. To meet the growing demands for system safety and reliability, timely and effective diagnosis needs to be carried out after system failures. Existing MMC fault diagnosis methods mainly fall into two categories: additional hardware circuit-based and software algorithm-based. Among them, the hardware-based method exhibits excellent diagnostic accuracy and short diagnostic time but may incur additional hardware costs and wiring complexity, while the software-based method does not require additional hardware circuitry and is relatively simple and convenient to implement. However, existing software-based method often heavily depends on the capacitance voltage information of sub-modules during the diagnosis process. The excessive number of voltage sensors not only increases the complexity of system wiring but also adds to the potential failure points of the system.
To this end, a deep learning-based IGBT open-circuit fault diagnosis method for MMC sub-modules using a minimum number of voltage sensors is proposed, which only requires two arm voltage sensors for each phase. Based on the analysis of open-circuit fault characteristics of MMC sub-module IGBTs, the bridge arm voltage is selected as the required electrical parameter for fault diagnosis. The short-time Fourier transform (STFT) is utilized to extract harmonic component information from the bridge arm voltage signal. By arranging frequency domain information at different sampling times, the matrix containing time-frequency domain information is constructed as the diagnostic sample. By combining with the deep belief network (DBN), an IGBT open-circuit fault detection method based on STFT-DBN is proposed, which realizes the rapid diagnosis of the fault type. Meanwhile, to address the problem of relatively low location accuracy of the DBN, a convolutional neural network (CNN) based faulty sub-module location network is established for each fault type after the fault type is identified by the fault detection network. Combining these two methods allows for rapid fault type detection and high-accuracy faulty sub-module location.
A 129-level MMC simulation model was established using Matlab/Simulink, and arm voltage information was collected under normal operation and various fault conditions. By applying the proposed method for data preprocessing, input samples were constructed, and the dataset was divided. Then the fault diagnosis networks were trained and tested separately, and the effectiveness of the proposed method was verified based on simulation data. Finally, the hardware and software of an MMC experimental system were designed in the laboratory environment, and an experimental system with reduced power levels was constructed. The control unit was implemented by a combination of DSP TMS320F28335 and FPGA, and various fault conditions were simulated by changing the drive signals. Arm voltage sensors were used to collect data from the experimental system under different fault conditions. The experimental results show that the proposed method can achieve high-precision and short-time fault diagnosis by using only arm voltage information.
|
|
Received: 18 May 2023
|
|
|
|
|
|
[1] 盛景, 陈聪, 向鑫, 等. 模块化多电平谐振变换器多自由度调压控制及子模块电容均压方法[J]. 电工技术学报, 2022, 37(24): 6216-6229.
Sheng Jing, Chen Cong, Xiang Xin, et al.Multiple- degree-of-freedom control and capacitor voltage balancing method of modular multilevel resonant converter[J]. Transactions of China Electrotechnical Society, 2022, 37(24): 6216-6229.
[2] 罗丹, 陈民铀, 赖伟, 等.基于Haar小波变换重构开关序列的MMC子模块电容值在线监测方法[J]. 电工技术学报, 2022, 37(20): 5278-5289.
Luo Dan, Chen Minyou, Lai Wei, et al.Online monitoring method for sub-module capacitance in modular multilevel converter based on Haar wavelet transform reconstruction switch sequence[J]. Tran- sactions of China Electrotechnical Society, 2022, 37(20): 5278-5289.
[3] 刘座辰, 林磊, 殷天翔, 等. 一种模块化多电平换流器子模块开路故障的快速检测与诊断方法[J]. 电工技术学报, 2022, 37(19): 4883-4894.
Liu Zuochen, Lin Lei, Yin Tianxiang, et al.A fast open-circuit fault detection and diagnosis method for sub-modules of modular multilevel converters[J]. Transactions of China Electrotechnical Society, 2022, 37(19): 4883-4894.
[4] 和敬涵, 张佳宝, 李猛, 等. 基于孪生模型的模块化多电平换流器保护[J]. 电力系统自动化, 2023, 47(21): 119-126.
He Jinghan, Zhang Jiabao, Li Meng, et al.Protection for modular multilevel converter based on twin model[J]. Automation of Electric Power Systems, 2023, 47(21): 119-126.
[5] 杨贺雅, 邢纹硕, 向鑫, 等. 基于多元高斯分布异常检测模型的MMC子模块开路故障诊断方法[J]. 电工技术学报, 2023, 38(10): 2744-2756.
Yang Heya, Xing Wenshuo, Xiang Xin, et al.A sub- module open-circuit fault detection and location strategy for modular multilevel converters based on multivariate gaussian distribution[J]. Transactions of China Electrotechnical Society, 2023, 38(10): 2744-2756.
[6] 武鸿, 王跃, 刘熠, 等. 基于广义电容电压不平衡度的MMC子模块开路故障诊断策略[J]. 电工技术学报, 2023, 38(14): 3909-3922.
Wu Hong, Wang Yue, Liu Yi, et al.Open circuit fault diagnosis strategy of MMC sub-module based on generalized capacitor voltage unbalance[J]. Transac- tions of China Electrotechnical Society, 2023, 38(14): 3909-3922.
[7] 孙冠群, 尹项根, 赖锦木, 等. 模块化多电平直流变压器容错控制策略[J]. 电工技术学报, 2022, 37(增刊1): 246-256, 287.
Sun Guanqun, Yin Xianggen, Lai Jinmu, et al.Fault-tolerant control strategy of modular multilevel DC transformer[J]. Transactions of China Electro- technical Society, 2022, 37(S1): 246-256, 287.
[8] Ronanki D, Williamson S S.Modular multilevel converters for transportation electrification: challenges and opportunities[J]. IEEE Transactions on Transpor- tation Electrification, 2018, 4(2): 399-407.
[9] Liu Zhijie, Li Kejun, WangJinyu, et al. General model of modular multilevel converter for analyzing the steady-state performance optimization[J]. IEEE Transactions on Industrial Electronics, 2021, 68(2): 925-937.
[10] Zhou Dehong, Yang Shunfeng, Tang Yi.A voltage- based open-circuit fault detection and isolation approach for modular multilevel converters with model-predictive control[J]. IEEE Transactions on Power Electronics, 2018, 33(11): 9866-9874.
[11] Wang Jun, Ma Hao, Bai Zhihong.A submodule fault ride-through strategy for modular multilevel converters with nearest level modulation[J]. IEEE Transactions on Power Electronics, 2018, 33(2): 1597-1608.
[12] Yang Shunfeng, Tang Yi, Wang Peng.Seamless fault-tolerant operation of a modular multilevel converter with switch open-circuit fault diagnosis in a distributed control architecture[J]. IEEE Transactions on Power Electronics, 2018, 33(8): 7058-7070.
[13] Zhang Jianzhong, Hu Xing, Xu Shuai, et al.Fault diagnosis and monitoring of modular multilevel converter with fast response of voltage sensors[J]. IEEE Transactions on Industrial Electronics, 2020, 67(6): 5071-5080.
[14] Wang Songda, Dragicevic T, Gao Yuan, et al.Neural network-based model predictive controllers for modular multilevel converters[J]. IEEE Transactions on Energy Conversion, 2021, 36(2): 1562-1571.
[15] 李宝琴, 吴俊勇, 李栌苏, 等. 基于主动迁移学习的电力系统暂态稳定自适应评估[J]. 电力系统自动化, 2023, 47(4): 121-132.
Li Baoqin, Wu Junyong, Li Lusu, et al.Adaptive assessment of power system transient stability based on active transfer learning[J]. Automation of Electric Power Systems, 2023, 47(4): 121-132.
[16] 叶鑫杰, 兰生, 肖思捷, 等. 基于小波包能量熵和DBN的MMC-HVDC输电线路单极接地故障定位方法[J]. 南方电网技术, 2021, 15(2): 82-91.
Ye Xinjie, Lan Sheng, Xiao Sijie, et al.Single pole grounding fault location method of MMC-HVDC transmissionline based on wavelet packet energy entropy and DBN[J]. Southern Power System Tech- nology, 2021,15(2): 82-91.
[17] 杨彦杰, 董哲, 姚芳, 等. 基于1D-CNN-LSTM混合神经网络模型的双桥并联励磁功率单元故障诊断[J]. 电网技术, 2021, 45(5): 2025-2032.
Yang Yanjie, Dong Zhe, Yao Fang, et al.Fault diagnosis of double bridge parallel excitation power unit based on 1D-CNN-LSTM hybrid neural network model[J]. Power System Technology, 2021, 45(5): 2025-2032.
[18] Xue Z Y, Xiahou K S, Li M S, et al.Diagnosis of multiple open-circuit switch faults based on long short-term memory network for DFIG-based wind turbine systems[J]. IEEE Journal of Emerging and Selected Topics in Power Electronics, 2020, 8(3): 2600-2610.
[19] Kiranyaz S, Gastli A, Ben-Brahim L, et al.Real-time fault detection and identification for MMC using 1-D convolutional neural networks[J]. IEEE Transactions on Industrial Electronics, 2019, 66(11): 8760-8771.
[20] Gong Wenfeng, Chen Hui, Zhang Zehui, et al.A data-driven-based fault diagnosis approach for electrical power DC-DC inverter by using modified convolutional neural network with global average pooling and 2-D feature image[J]. IEEE Access, 2020,8: 73677-73697.
[21] Sun Quan, Wang Youren, Jiang Yuanyuan.A novel fault diagnostic approach for DC-DC converters based on CSA-DBN[J]. IEEE Access, 2017, 6: 6273-6285.
[22] Song Qiang, Wang Mingsheng, Lai Wuxuan, et al.On Bayesian optimization-based residual CNN for estimation of inter-turn short circuit fault in PMSM[J]. IEEE Transactions on Power Electronics, 2023, 38(2): 2456-2468.
[23] Kim S H, Yoo D Y, An S W, et al.Fault detection method using a convolution neural network for hybrid active neutral-point clamped inverters[J]. IEEE Access, 2020, 8: 140632-140642.
[24] Gong Wenfeng, Chen Hui, Zhang Zehui, et al.A novel deep learning method for intelligent fault diagnosis of rotating machinery based on improved CNN-SVM and multichannel data fusion[J]. Sensors, 2019, 19(7): 1693.
[25] 金林. 高频载波移相调制下模块化多电平变换器子模块故障检测技术研究[D]. 杭州: 浙江大学, 2021.
Jin Lin.Research on submodule failure diagnosis methods of MMC with high frequency carrier phase: shifting modulation[D]. Hangzhou: Zhejiang University, 2021.
[26] Chu Zunfang, Li Yaohua, Wang Ping, et al.A novel voltage balancing method of modular multilevel converter based on phase shifted carrier pulse width modulation[C]//2014 9th IEEE Conference on Indu- strial Electronics and Applications, Hangzhou, China, 2014: 364-367.
[27] Moranchel M, Bueno E J, Rodriguez F J, et al.Implementation of nearest level modulation for modular multilevel converter[C]//2015 IEEE 6th International Symposium on Power Electronics for Distributed Generation Systems (PEDG), Aachen, Germany, 2015: 1-5.
[28] Yue Yufei, Xu Qianming, Guo Peng, et al.Capacitor voltage predictor-corrector balancing approach with single sensor for single-phase modular multilevel converter[J]. International Journal of Electrical Power & Energy Systems, 2021, 129: 106729.
[29] D'Arco S, Suul J A. Estimation of sub-module capacitor voltages in modular multilevel con- verters[C]//2013 15th European Conference on Power Electronics and Applications (EPE), Lille, France, 2013: 1-10.
[30] 韩雪, 贺荣栋, 凌志斌. 部分接入电池储能系统的模块化多电平换流器控制方法[J]. 电力系统自动化, 2024, 48(1): 100-108.
Han Xue, He Rongdong, Ling Zhibin.Control method of modular multilevel converter with partly integrated battery energy storage system[J]. Automation of Electric Power Systems, 2024, 48(1): 100-108.
[31] Hinton G E, Osindero S, Teh Y W.A fast learning algorithm for deep belief nets[J]. Neural Computation, 2006, 18(7): 1527-1554. |
|
|
|
2024, Vol. 39 
