基于两相三桥臂开关功放的电磁悬浮系统差动位移估计

doi:10.19595/j.cnki.1000-6753.tces.220286

Abstract
Figure/Table
References
Related Citation (15)

Download: PDF (5913 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract Electromagnetic levitation technology has been widely concerned and studied in recent years because of its excellent characteristics such as no friction, less maintenance, and adjustable dynamic characteristics. However, the integration, reliability, and cost of its system restrict the application and development of electromagnetic levitation technology. The appearance of displacement self-sensing has effectively solved the above problems. Because the traditional displacement self-sensing estimation method uses a single coil to estimate the displacement of the suspension according to the change rate of the current ripple, there are many problems, such as large displacement estimation error and easy to be disturbed by the external environment. Therefore, this paper proposes a displacement self-sensing detection method of an electromagnetic suspension system driven by a two-phase, three-leg switching power amplifier. The displacement of the suspension body is estimated by detecting the ripple change rate of the two-phase differential current. Compared with detecting single-phase current, it can effectively reduce the impacts of switching transients and noise on the accuracy of displacement estimation. The self-induced electromagnetic levitation of the mover is realized on a single degree of freedom rigid electromagnetic levitation experimental platform, which verifies the effectiveness of the proposed method.
Firstly, the structure of the differential control system of a single degree for freedom electromagnetic suspension is introduced. Then, the topology of the two-phase, three-leg switching power amplifier is analyzed. Compared with the traditional full bridge switching power amplifier, the two-phase, three-leg switching power amplifier can reduce 1/4 switching devices while its basic functions and current ripple characteristics remain unchanged. It not only improves the integration of the circuit, but also reduces the number of PWM signals output by the controller and the number of driving circuits, which is conducive to the improvement of the overall integration of the system. Accordingly, the working principle and the modulation mode of the two-phase, three-leg switching power amplifier are introduced.
This paper analyzes the self-sensing principle of the differential electromagnetic levitation system by modeling the single degree of freedom suspension. Through theoretical analysis and derivation, it is proved that the magnitude of the coil inductance is approximately linear with the mover displacement, and the relationship between the differential displacement and the current ripple change rate is obtained. Then, the current ripple characteristics of the two-phase, three-leg switching power amplifier are analyzed theoretically. It is verified that the amplitude of the current ripple is only related to the inductance of the coil under the condition that the bus voltage and the switching frequency are determined. Moreover, the method for measuring the change rate of the current ripple is feasible to realize the self-sensing of the mover displacement. The change rate of the two-phase current ripple is obtained by sampling the rising edge and the falling edge of the current ripple and using the least square method.
In the derivation of differential displacement self-sensing theory, the influence of device and line internal resistance is neglected. The actual power device and the internal resistance of the line are affected by temperature and other factors, which will affect the detection results of the current ripple change rate. Therefore, the influence of loop internal resistance on the current ripple change rate under different bus voltage and current average values is analyzed. The linear relationship between the air gap size and the current ripple change rate is also analyzed. It can be seen from the analysis that the influence of the loop internal resistance change on the displacement estimation accuracy can be ignored in the actual application of the electromagnetic suspension system.
The self-sensing dynamic suspension experiment was carried out on a single degree of freedom rigid electromagnetic suspension balance beam experimental platform. Experimental results show that the differential displacement estimation method based on detecting the current ripple changing rate of two-phase coils can significantly improve the accuracy of displacement estimation compared with the traditional displacement estimation method based on detecting the current ripple changing rate of a single coil.

Key words： Electromagnetic levitation common bridge arm topology self-sensing current ripple

Received: 02 March 2022

PACS:

TM315

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	Zhang Youjun
	Yu Jie

Cite this article:

Zhang Youjun,Yu Jie. Differential Displacement Estimation of Electromagnetic Levitation System Based on Two-Phase-Three-Arm Switching Power Amplifier[J]. Transactions of China Electrotechnical Society, 2023, 38(10): 2698-2708.

URL:

https://dgjsxb.ces-transaction.com/EN/10.19595/j.cnki.1000-6753.tces.220286 OR https://dgjsxb.ces-transaction.com/EN/Y2023/V38/I10/2698

[1] 张维煜, 朱熀秋, 袁野. 磁悬浮轴承应用发展及关键技术综述[J]. 电工技术学报, 2015, 30(12): 12-20.
Zhang Weiyu, Zhu Huangqiu, Yuan Ye.Study on key technologies and applications of magnetic bearings[J]. Transactions of China Electrotechnical Society, 2015, 30(12): 12-20.
[2] 胡烽, 孙宏博, 蒋栋, 等. 基于四相全桥的磁悬浮轴承开关器件开路故障容错控制策略[J]. 电工技术学报, 2022, 37(9): 2295-2305, 2340.
Hu Feng, Sun Hongbo, Jiang Dong, et al.Fault- tolerant strategy of four-phase full-leg for active magnetic bearing in case of open circuit fault of switching device[J]. Transactions of China Electro- technical Society, 2022, 37(9): 2295-2305, 2340.
[3] 张涛, 刘欣凤, 莫丽红, 等. 磁悬浮高速电机系统建模与控制[J]. 电机与控制学报, 2018, 22(4): 98-104.
Zhang Tao, Liu Xinfeng, Mo Lihong, et al.Modeling and control of magnetic suspension high-speed motor[J]. Electric Machines and Control, 2018, 22(4): 98-104.
[4] 余志强, 孙晓云, 邱清泉, 等. 电机外置式径向型高温超导飞轮储能系统样机悬浮测试及旋转实验[J]. 电工技术学报, 2019, 34(10): 2166-2175.
Yu Zhiqiang, Sun Xiaoyun, Qiu Qingquan, et al.Levitation test and rotation experiment of radial-type superconducting flywheel energy storage system prototype with external motor[J]. Transactions of China Electrotechnical Society, 2019, 34(10): 2166-2175.
[5] 刘程子, 湛江, 杨艳, 等. 主动磁悬浮轴承-柔性转子的研究和发展综述[J]. 中国电机工程学报, 2020, 40(14): 4602-4614, 4739.
Liu Chengzi, Zhan Jiang, Yang Yan, et al.Review of research status and development of flexible rotor- magnetic bearing[J]. Proceedings of the CSEE, 2020, 40(14): 4602-4614, 4739.
[6] Tang Enqiong, Han Bangcheng, Zhang Yin.Optimum compensator design for the flexible rotor in mag- netically suspended motor to pass the first bending critical speed[J]. IEEE Transactions on Industrial Electronics, 2016, 63(1): 343-354.
[7] Song Xinda, Fang Jiancheng, Han Bangcheng, et al.Adaptive compensation method for high-speed surface PMSM sensorless drives of EMF-based position estimation error[J]. IEEE Transactions on Power Electronics, 2016, 31(2): 1438-1449.
[8] Noshadi A, Shi Juan, Lee W S, et al.System identi- fication and robust control of multi-input multi-output active magnetic bearing systems[J]. IEEE Transa- ctions on Control Systems Technology, 2016, 24(4): 1227-1239.
[9] Park Y H, Han D C, Park I H, et al.A self-sensing technology of active magnetic bearings using a phase modulation algorithm based on a high frequency voltage injection method[J]. Journal of Mechanical Science and Technology, 2008, 22(9): 1757-1764.
[10] Yu Jie, Wu Xinzhen, Zhang Yuhao, et al.A novel differential estimation method of rotor displacement for active magnetic bearings[C]//2019 22nd Inter- national Conference on Electrical Machines and Systems (ICEMS), Harbin, China, 2019: 1-5.
[11] 于洁, 祝长生, 吴新振. 解调型自传感电磁轴承的位移估计误差分析[J]. 中国电机工程学报, 2019, 39(19): 5876-5884, 5916.
Yu Jie, Zhu Changsheng, Wu Xinzhen.The analysis of displacement estimation errors of demodulation type self-sensing active magnetic bearings[J]. Pro- ceedings of the CSEE, 2019, 39(19): 5876-5884, 5916.
[12] Jiang Yinxiao, Ma Xin, Fan Yahong.Rotor displace- ment self-sensing approach for permanent magnet biased magnetic bearings using double-axis PWM demodulation[J]. IEEE Sensors Journal, 2018, 18(19): 7932-7940.
[13] Jiang Yinxiao, Wang Kun, Sun Maolin, et al.Displacement self-sensing method for AMB-rotor systems using current ripple demodulations combined with PWM command signals[J]. IEEE Sensors Journal, 2019, 19(14): 5460-5469.
[14] Xiong Haojie, Xiao Jun, Yang Dongsheng, et al.Displacement estimation of self-sensing magnetic bearings based on biorthogonal spline wavelet[J]. IEEE Access, 2021, 9: 76213-76223.
[15] Tian Zhongliang, Wei Zhengyuan, Guo Bin, et al.A rotor displacement estimation method for magnetic bearings with direct measurement of the ripple current slope[C]//2019 IEEE International Conference on Mechatronics and Automation (ICMA), Tianjin, China, 2019: 1848-1853.
[16] Wang Jinou, Binder A.Self-sensing magnetic bearings using multiple sampling of currents alone[C]//2013 15th European Conference on Power Electronics and Applications (EPE), Lille, France, 2013: 1-10.
[17] Tang Ming, Zhu Changsheng.New method of position estimation for self-sensing active magnetic bearings based on artificial neural network[C]//2010 International Conference on Electrical and Control Engineering, Wuhan, China, 2010: 1355-1358.
[18] Sadighi A, Kim W J.Adaptive-neuro-fuzzy-based sensorless control of a smart-material actuator[J]. IEEE/ASME Transactions on Mechatronics, 2011, 16(2): 371-379.
[19] 周亮, 李黎川. 电流驱动和电压驱动下实心磁路磁轴承的系统辨识[J]. 中国电机工程学报, 2016, 36(1): 268-273.
Zhou Liang, Li Lichuan.System identification of solid-core active magnetic bearings under current drive and voltage drive[J]. Proceedings of the CSEE, 2016, 36(1): 268-273.
[20] 钟建朋, 李黎川. 实心磁路磁轴承的分数阶系统辨识[J]. 中国电机工程学报, 2013, 33(18): 170-177, 25.
Zhong Jianpeng, Li Lichuan.Fractional-order system identification of a solid-core active magnetic bearing[J]. Proceedings of the CSEE, 2013, 33(18): 170-177, 25.
[21] 叶品州, 李红伟, 于文涛, 等. 考虑材料非线性及涡流影响的径向电磁轴承等效磁路建模[J]. 电工技术学报, 2020, 35(9): 1858-1867.
Ye Pinzhou, Li Hongwei, Yu Wentao, et al.Equi- valent magnetic circuit modeling of radial active magnetic bearing considering material nonlinearity and eddy current effects[J]. Transactions of China Electrotechnical Society, 2020, 35(9): 1858-1867.
[22] 胡载东, 蒋栋, 孙宏博. 一种应用于磁悬浮轴承的四相四桥臂电力电子变换器[J]. 电工技术学报, 2020, 35(20): 4325-4335.
Hu Zaidong, Jiang Dong, Sun Hongbo.A four-phase four-leg power electronics converter for active magnetic bearing drive[J]. Transactions of China Electrotechnical Society, 2020, 35(20): 4325-4335.
[23] Jiang Dong, Li Tian, Hu Zaidong, et al.Novel topologies of power electronics converter as active magnetic bearing drive[J]. IEEE Transactions on Industrial Electronics, 2020, 67(2): 950-959.