基于快速选择表的永磁同步电机模型预测转矩控制

doi:10.19595/j.cnki.1000-6753.tces.221665

Abstract
Figure/Table
References
Related Citation (15)

Download: PDF (1810 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract An output voltage vector which has adjustable amplitude has been synthesized with the selected voltage vector of an effectiveness and a zero by calculating the duty cycle in the two-vector model prediction torque control, which can effectively reduces the value error of actual and design. But due to the limited selection range, there are still some defects. Thus some three-vector improvement measures have been proposed which have different selection methods. Based on the new two-vector model prediction torque control, a three-vector model prediction torque control strategy based on the fast selection table is proposed. A synthetic voltage vector with adjustable amplitude and range is obtained by increasing the effective voltage vector, and a fast selection table is proposed to reduce the computation of the effective voltage vector selection.
Firstly, by analyzing the influence of the voltage vectors on the slope of torque and stator flux in turn, it can be known that the zero voltage vector mainly affects the torque ripples, while the influence on the stator flux is almost negligible. Therefore, the slope of stator flux under zero voltage vector is not needed to be considered in the operation time allocation. Secondly, the fast selection table is constructed according to the effect of effective voltage vector on torque and stator flux, so that the prediction times can be greatly reduced during the selection of effective voltage vector. Then, the sector judgment is made according to the position of stator flux at the current time, and the effective voltage vector is selected quickly according to the torque value error of actual and design and the value of sectors in the fast selection table. Finally, the operating time of voltage vectors are calculated by the principle of deadbeat control.
The simulation test mainly verifies the transient experiment. Firstly, the motor speed is set at 1500r/min and started in no-load state, then when the motor run stably to 1500r/min, the simulation test condition of load torque is suddenly added to 3N·m at 0.1s. Simulation waveform shows that this strategy can effectively reduce flux fluctuation and torque ripples on the virtual platform, and suppress current harmonics to some extent which the current harmonics reduce from 13.27% to 6.77%. In order to further verify the feasibility of the algorithm, a relevant experimental platform is built for experimental verification, which is mainly divided into two parts: steady-state experiment and transient experiment verification. The steady-state experiment mainly verifies the operation condition of the motor under the two conditions of low-speed with no-load and high-speed with load. The torque ripples and flux fluctuation can be effectively improved to a certain extent under both conditions, and the current harmonics under the condition of high-speed with load are reduced from 32.37% to 25.68%. The transient experiment is to suddenly add load to the motor under the condition of stable operation. Both experiments show that the control strategy in this paper has more obvious improvement, which can reduce current harmonics at the same time, and the steady-state performance is obviously better. In addition, when the torque changes, although the speed will be affected to some extent, the results will be less affected and the dynamic response can be maintained quickly.

Key words： permanent magnet synchronous motor model-predicted torque control three vectors deadbeat control switching table

PACS:

TM351

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	Lan Zhiyong
	Luo Jie
	Li Yanhao
	Li Chao
	Li Fu

Cite this article:

Lan Zhiyong,Luo Jie,Li Yanhao等. Model prediction torque control for Permanent Magnet Synchronous Motor Based on the Fast Selection Table[J]. Transactions of China Electrotechnical Society, 0, (): 82-82.

URL:

https://dgjsxb.ces-transaction.com/EN/10.19595/j.cnki.1000-6753.tces.221665 OR https://dgjsxb.ces-transaction.com/EN/Y0/V/I/82

[1] 黄林森,赵文祥,吉敬华,等.稳态性能改善的双三相永磁电机直接转矩控制[J].电工技术学报,2022,37(02):355-367.
Huang Linsen, Zhao Wenxiang, Ji Jinghua, et al.Direct Torque Control for Dual Three-Phase Permanent-Magnet Machine with Improved Steady State Performance[J]. Transactions of China Electrotechnical Society, 2022,37(02):355-367.
[2] 姚绪梁,黄乘齐,王景芳,等.两相静止坐标系下的永磁同步电动机模型预测功率控制[J].电工技术学报,2021,36(01):60-67.
Yao Xuliang, Huang Shengqi, Wang Jingfang, et al.Model Predictive Power Control of Permanent Magnet Synchronous Motor in Two-Phase Static Coordinate System[J]. Transactions of China Electrotechnical Society, 2021,36(01):60-67.
[3] 章回炫,范涛,边元均,等.永磁同步电机高性能电流预测控制[J].电工技术学报,2022,37(17):4335-4345.
Zhang Huixuan, Fan Tao, et al.Predictive Current Control Strategy of Permanent Magnet Synchronous Motors with High Performance[J]. Transactions of China Electrotechnical Society, 2022,37(17):435-445.
[4] 史婷娜,张维,肖萌,等.基于矢量作用时间的永磁同步电机预测电流控制[J].电工技术学报,2017,32(19):1-10.
Shi Tingna, Zhang Wei, Xiao Meng, et al.Predictive Current Control for Permanent Magnet Synchronous Motor Based on Operating Time of Vector[J]. Transactions of China Electrotechnical Society,2017,32(19):1-10.
[5] 周湛清, 夏长亮, 陈炜, 等. 具有参数鲁棒性的永磁同步电机改进型预测转矩控制[J]. 电工技术学报, 2018, 33(5): 965-972.
Zhou Zhanqing, Xia Changliang, Chen Wei, et al.Modified predictive torque control for PMSM drives with parameter robustness[J]. Transactions of China Electrotechnical Society, 2018, 33(5): 965-972.
[6] Y. Zhang and J. Zhu. A Novel Duty Cycle Control Strategy to Reduce Both Torque and Flux Ripples for DTC of Permanent Magnet Synchronous Motor Drives With Switching Frequency Reduction[J]. IEEE Transactions on Power Electronics, 2011,26(10): 3055-3067.
[7] 刘珅,高琳.永磁同步电机的改进模型预测直接转矩控制[J].电机与控制学报,2020,24(01):10-17.
Liu Shen, Gao Lin.Improved model of predictive direct torque control for permanent magnet synchronous motor[J]. Electric Machines and Control, 2020,24(01):10-17.
[8] F. Niu, B. Wang, A. S. Babel, K. Li.Strangas Comparative Evaluation of Direct Torque Control Strategies for Permanent Magnet Synchronous Machines[J]. IEEE Transactions on Power Electronics,2016,31(2):140 8-1424.
[9] 牛峰, 李奎, 王尧. 基于占空比调制的永磁同步电机直接转矩控制[J]. 电工技术学报, 2014, 29(11):20-29. Niu Feng, Li Kui, Wang Yao. Model predictive direct torque control for permanent magnet synchronous machines based on duty ratio modulation[J]. Transactions of China Electrotechnical Society, 2014,29(11): 20-29
[10] Wang Fengxiang, Li Shihua, Mei Xuezhu, et al.Model-based predictive direct control strategies for electrical drives: an experimental evaluation of PTC and PCC methods[J]. IEEE Transactions on Industrial Informatics, 2015, 11(3): 671-681.
[11] Y. Zhang and H. Yang, Model Predictive Torque Control of Induction Motor Drives With Optimal Duty Cycle Control[J]. IEEE Transactions on Power Electronics, 2014,29(12): 6593-6603.
[12] 廖晓钟,邵立伟.直接转矩控制的十二区段控制方法[J].中国电机工程学报,2006(06):167-173.
Liao Xiaozhong, Shao Liwei.The Twelve-section Control Methods of Direct Torque Control[J]. Proceedings of the CSEE,2006(06):167-173.
[13] 吕帅帅,林辉,李兵强,等.一种改进的PMSM模型预测直接转矩控制方法[J].电机与控制学报,2020,24(07):102-111.
Lu Shuaishuai, Lin Hui, LI Bingqiang, et al.Improved model predictive direct torque control for permanent magnet synchronous motor[J]. Electric Machines and Control,2020,24(07):102-111.
[14] M. Wu, X. Sun, J. Zhu, G. Lei and Y. Guo. Improved Model Predictive Torque Control for PMSM Drives Based on Duty Cycle Optimization[J]. IEEE Transactions on Magnetics, 2021,57(2):1-5.
[15] 徐艳平,李园园,周钦,等.矢量双选取的永磁同步电动机直接转矩控制策略[J].中国电机工程学报,2018,38(17):5211-5218+5318.
Xu Yanping, Li Yuanyuan, Zhou Qin, et al.A double vectors selection direct torque control strategy of permanent magnet synchronous motor[J]. Proceedings
16 of the CSEE, 2018, 38(17): 5211-5218.
[16] 夏长亮,仇旭东,王志强,等.基于矢量作用时间的新型预测转矩控制[J].中国电机工程学报,2016,36(11):3045-3053.
Xia Changliang, Qiu Xudong, Wang Zhiqiang, et al.Predictive Torque Control Based on Optimal Operating Time of Vector[J]. roceedings of the CSEE,2016,36(11):3045-3053.
[17] M. R. Nikzad, B. Asaei and S. O. Ahmadi. Discrete Duty-Cycle-Control Method for Direct Torque Control of Induction Motor Drives With Model Predictive Solution[J]. IEEE Transactions on Power Electronics,2017,33(3): 2317-2329.
[18] Y. Zhang and J. Zhu. Direct Torque Control of Permanent Magnet Synchronous Motor With Reduced Torque Ripple and Commutation Frequency[J]. IEEE Transactions on Power Electronics,2011, 26(1):35-48.
[19] 徐艳平,李园园,张保程,等.一种消除权重系数三矢量模型预测转矩控制[J].电工技术学报,2018,33(16):925-934.
Xu Yanping, Li Yuanyuan, Zhang Baocheng, et al.Three-Vector Based Model Predictive Torque Control of Eliminating Weighting Factor[J]. Transactions of China Electrotechnical Society,2018,33(16):925-934.
[20] 陈炜,曾思坷,张国政,等.永磁同步电机改进型三矢量模型预测转矩控制[J].电工技术学报,2018,33(S2):420-426.
Chen Wei, Zeng Sike, Zhang Guozheng, et al.Improved Three-Vector Model Predictive Torque Control of Permanent Magnet Synchronous Motor[J]. Transactions of China Electrotechnical Society, 2018,33(S2):420-426.