三间隙激光触发真空开关触发特性研究

doi:10.19595/j.cnki.1000-6753.tces.220949

Abstract
Figure/Table
References
Related Citation (13)

Download: PDF (1349 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract High-voltage laser-triggered vacuum switches have good application prospects in pulsed power systems. Laser triggered vacuum switch (LTVS) is a new type of pulsed power closed switch that combines pulsed laser technology with vacuum switching technology. Compared with laser-triggered gas switches, laser-triggered vacuum switches can obtain similar or even better delay characteristics under the same conditions, while avoiding a series of technical problems of gas switches. As the application areas of pulsed power technology continue to expand and system capacity grows, LTVS has the potential to become a switching device for higher power applications In this paper, a multi-gap laser-triggered vacuum switch is designed which consists of a laser-triggered gap and two symmetrical curling stainless steel electrodes in series. Based on the detachable vacuum chamber, a laser-triggered multi-gap vacuum switch test platform was built, and triggering characteristics of the multi-gap switch were experimentally studied under different laser energies, different operating voltages, and different voltage split ratios. The delay characteristics of the three-gap laser trigger switch are compared and analyzed, and the main factors affecting the delay characteristics of the multi-gap series switch are explored, and the optimization design scheme of the working parameters of the high-performance multi-gap switch is obtained.The experimental results show that the trigger delay time of the multi-gap switch is not only related to the external working conditions, but also affected by the working parameters among the three gaps. With the increase of laser energy and operating voltage, the trigger delay and jitter time of the switch decrease. By matching with appropriate working parameters, the better time-delay characteristics can be obtained. The on-trigger delay of the three-gap LTVS is determined by the on-delay of each gap and is mainly affected by the delay of its first self-breakdown gap, and the remaining self-breakdown gap can be quickly turned on at a steeper impulse voltage.
The voltage division ratio of each gap of the three-gap LTVS has a significant impact on the working delay of the switch, and the change of the voltage division ratio will change the rate of increase of the superimposed shock voltage during the trigger process, which will make the switch on rate different. When the laser energy and operating voltage are high, the trigger gap has a higher voltage division ratio and the switching trigger performance is relatively good. The trigger delay of the three-gap LTVS gradually decreases with the increase of laser energy and operating voltage, that is, LTVS can obtain better trigger performance at higher laser energy and working voltage. When the laser energy was 30mJ and the operating voltage is 30kV, The trigger on characteristics of the three-gap laser trigger vacuum switch can be improved by increasing the laser energy, working voltage and changing the divider voltage ratio, wherein the on-time delay of the three-gap LTVS can be controlled at 167±3ns when the laser energy is 30mJ, the operating voltage is 30kV, and the partial voltage ratio is 4:1:1. The experimental research in this paper can lay the foundation for the study of high-performance laser-triggered multi-stage vacuum switches in higher voltage fields.

Key words： Laser-triggered vacuum switch multi-gap in series voltage ratio curling stainless steel electrodes trigger characteristics

PACS:

TM56

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	Song Xinzhe
	Liao Minfu
	Lu Gang
	Ma Hui
	Han Xiaotao

Cite this article:

Song Xinzhe,Liao Minfu,Lu Gang等. Research on Triggering Characteristics of Triple-gap Laser Triggered Vacuum Switch[J]. Transactions of China Electrotechnical Society, 0, (): 26-26.

URL:

https://dgjsxb.ces-transaction.com/EN/10.19595/j.cnki.1000-6753.tces.220949 OR https://dgjsxb.ces-transaction.com/EN/Y0/V/I/26

[1] V. S. Bulygin, et al.Laser-triggered vacuum switch[J]. Sov. Phys. Tech. Phys.,1975,20(4):561-565.
[2] 樊文芳,何正浩,王英,等.一种激光触发真空开关的触发特性研究[J].中国电机工程学报,2015,35(20):5360-5366.
Fan Wenfang, He Zhenghao, Wang Ying, et al.Research on the triggering characteristics of a laser-triggered vacuum switch[J]. Chinese Journal of Electrical Engineering, 2015, 35(20): 5360-5366.
[3] L. M. Earley, G. A. Barnes.Low-jitter, high-voltage, infrared, laser-triggered vacuum switch[C]//8th IEEE Conference on Pulsed Power, San Diego, 1991:17-19.
[4] I. Fukushi, M. Watanabe, E. Hotta, et al.Characteristics of laser triggered vacuum switch[C]//19th International Symposium on Discharges and Electrical Insulation in Vacuum.IEEE,2000:511-514.
[5] M. Watanabe, J. Maehara, I. Fukushi, et al.Behaviour of ablated plasma in laser-triggered vacuum switch[C]//IEEE International Conference on Plasma Science, 2001:1425-1428.
[6] 赵通,廖敏夫,陈占清,范忠宪,邹积岩.不同极性激光触发真空开关触发机制研究[J].电工技术学报,2020,35(15):3341-3347.
Zhao Tong, Liao Minfu, Chen Zhanqing, Fan Zhongxian, Zou Jiyan.Research on the triggering mechanism of different polarity laser triggered vacuum switches[J]. Transactions of China Electrotechnical Society, 2020, 35(15):3341-3347.
[7] 赵岩,廖敏夫,段英雄,等.激光出发真空开关触发稳定性及时延特性[J]. 电工技术学报,2017,32(13):178-184.
Zhao Yan, Liao Minfu, Duan Yingxiong, et al.Trigger stability and delay characteristics of laser-started vacuum switch[J]. Transactions of China Electrotechnical Society, 2017, 32(13): 178-184.
[8] 江维华. 高重复频率脉冲功率技术及其应用:(7)主要技术问题和未来发展趋势[J]. 强激光与粒子束,2015,27(1)16-20.
Jiang Weihua.High repetition rate pulse power technology and its application: (7) Main technical issues and future development trends[J]. Intense Laser and Particle Beam, 2015, 27(1) 16-20.
[9] M. E. Savage, K. N. Austin, B. T. Hutsel, et al.Pulsed power performance of the Z machine: ten years after the upgrade[C]//12th IEEE International Conference on Pulsed Power.2017,1-6.
[10] 廖敏夫,董华庆,陈占清,等.不同电极激光触发真空开关高频开断能力研究[J].高电压技术,2020,46(07):2578-2585.
Liao Minfu, Dong Huaqing, Chen Zhanqing, et al.Research on high frequency breaking capability of laser-triggered vacuum switches with different electrodes[J]. High Voltage Technology, 2020, 46(07): 2578-2585.
[11] A.Kim, S. Frolov, V. Alexeenko, et al.Prefire probability of switch type fast LTD[C]. 17^th IEEE International Conference on Pulsed Power. 2009:565-570.
[12] J.R. Woodworth, W. E. Flowler, B. S. Stoltzfus, et al.Compact 810kA linear transformer driver cavity[J]. Physical Review Special Topic. Accelerators and Beams,2011, 14:040401.
[13] 张颖,王景芹,康慧玲,胡德霖.金属掺杂AgSnO_2触头材料的仿真与实验[J].电工技术学报,2021,36(08):1587-1595.
Zhang Ying, Wang Jingqin, Kang Huiling, Hu Delin.Simulation and Experiment of Metal-Doped AgSnO2 Contact Material[J]. Transactions of China Electrotechnical Society, 2021,36(08):1587-1595.
[14] 南江,刘诚威,夏平安. 聚四氟乙烯/纳米碳化硅改性复合材料的制备及其介电特性[J]. 电工技术学报,2021,36(S1):1-7
Nan Jiang, Liu Chengwei, Xia Pingan.Preparation and Dielectric Characteristics of Nano-SiC/PTFE Composite[J]. Transactions of China Electrotechnical Society, 2021,36(S1):1-7
[15] 姚睿丰,王妍,高景晖,陈川,郭经红.压电材料与器件在电气工程领域的应用[J].电工技术学报,2021,36(07):1324-1337
Yao Ruifeng, Wang Yan, Gao Jinghui, Chen Chuan, Guo Jinghong.Applications of Piezoelectric Materials and Devices in Electric Engineering[J]. Transactions of China Electrotechnical Society, 2021,36(07):1324-1337
[16] 周朕蕊,韩冬,赵明月,张国强.电晕放电下C₅F₁₀O混合气体的分解特性[J].电工技术学报,2021,36(02):407-416
Zhou Xiangrui, Han Dong, Zhao Mingyue, Zhang Guoqiang.Decomposition Characteristics of C₅F₁₀O Mixtures under Corona Discharge[J]. Transactions of China Electrotechnical Society, 2021,36(02):407-416
[17] 张志劲,梁田,向缨竹,蒋兴良.去粉化对硅橡胶复合绝缘子性能的影响[J].电工技术学报,2022,37(08):2126-2135.
Zhang Zhijin, Liang Tian, Xiang Miaozhu,Jiang Xingliang.Effect of De-Powdering on the Performance of Silicone Rubber Composite Insulator[J]. Transactions of China Electrotechnical Society, 2022,37(08):2126-2135.
[18] 程显,廖敏夫,段雄英,等.基于光控真空断路器模拟串联的126kV 三断口真空断路器设计与试验[J]. 高电压技术,2015,40(9):3110-3116.
Cheng Xian, Liao Minfu, Duan Xiongying, et al.Design and test of 126kV three-break vacuum circuit breaker based on photo-controlled vacuum circuit breaker simulation series[J]. High Voltage Technology, 2015, 40(9): 3110-3116.