|
|
|
| Current Sensorless Control Method of Switched Reluctance Motors |
| Fang Chenghui1,2,3, Chen Hao1,2,3, Galina Demidova4, Alecksey Anuchin5, Yassen Gorbounov6 |
1. School of Electrical Engineering China University of Mining and Technology Xuzhou 221116 China;
2. International Joint Research Center of Central and Eastern European Countries on New Energy Electric Vehicle Technology and Equipment Xuzhou 221008 China;
3. International Cooperation Joint Laboratory of New Energy Power Generation and Electric Vehicles of Jiangsu Province Colleges and Universities Xuzhou 221008 China;
4. Faculty of Control Systems and Robotics Engineer Saint-Petersburg National Research University of Information Technologies Mechanics and Optics St. Petersburg 197101 Russia;
5. Electric Drives Department Moscow Power Engineering Institute National Research University Moscow 111250 Russia;
6. Department of Automation of Mining Production University of Mining and Geology "St. Ivan Rilski" Sofia 1700 Bulgaria |
|
|
|
Abstract Control variables are usually measured by sensors. However, sensors can increase system costs, cause interference, and reduce reliability. Thus, the sensorless technique is widely studied. For switch reluctance motor (SRM) systems, according to present control methods, current information is necessary to torque control. A new control variable is toned to replace the current and have a simple relation with electromagnetic torque to achieve good control performance without current sensors. Rotor position and speed are necessary for any SRM control methods, usually measured by a position sensor. The first derivative of position is speed, the second derivative of position is acceleration, and the third and more derivatives of position have no physical meaning. When only a position sensor is used in the SRM system, besides the speed, the acceleration is the unique possible feedback variable. Therefore, a current sensorless control method of SRMs using double closed loops of speed and acceleration is proposed.
Firstly, the feasibility of the proposed method is analyzed in two points. ① Its convergence is proven; ② The approximate linear relation between electromagnetic torque and acceleration in a steady state is proven, and the equivalence of torque control and acceleration control is analyzed further. Subsequently, a hysteresis control method with three bounds is proposed to track reference acceleration. According to flux features of the SRM, there is a position where inductance increase sharply, and if the phase current cannot be reduced timely, the electromagnetic torque will also increase sharply, leading to a large torque ripple. Thus, an extra upper bound is set, and a negative voltage is used to quickly reduce the phase current when the acceleration is beyond the upper bound. Finally, Given both motor efficiency and torque ripple, turn-on and turn-off angle are appropriately selected.
Angle position control (APC) and voltage pulse width modulation (VPWM) are two existing current sensorless control methods of SRMs. VPWM has better control performance than APC. Therefore, taking VPWM as a comparison object, the improvement of the proposed method is verified by experiments. The direct torque control (DTC) method is another comparison object to demonstrate the equivalence of torque control and acceleration control. The experiments are carried out under four conditions: low speed and light load, high speed and heavy load, speed change, and load change. Under (600r/min, 0.2N·m), the torque ripple of VPMM is about 0.32N·m, and those of DTC and the proposed method are about 0.2N·m. Under (1 500r/min, 0.7N·m), the torque ripple of VPMM is about 1.6N·m, and those of DTC and the proposed method are about 0.5N·m. If the initial condition is set to (600r/min, 0.2N·m), during speed change, the max torque of VPMM is about 4N·m, and those of DTC and the proposed method are about 0.2N·m. If the initial condition is set to (600r/min, 0.2N·m), during load change, the torque ripple of VPMM is about 2N·m, and those of DTC and the proposed method are about 0.5N·m.
The experimental results show that the proposed method is comparable to the DTC and better than the VPWM in control performance. In addition, the relationship between the current and the electromagnetic torque is complex and nonlinear, but the conversion between them is needed in DTC. Due to the approximately linear relationship between electromagnetic torque and acceleration, the proposed method is independent of the electromagnetic torque, thus having a lower computational cost.
|
|
Received: 30 December 2021
|
|
|
|
|
|
[1] Gou Lifeng, Wang Chenchen, Zhou Minglei, et al.Integral sliding mode control for starting speed sensorless controlled induction motor in the rotating condition[J]. IEEE Transactions on Power Electronics, 2020, 35(4): 4105-4116.
[2] Verrelli C M, Bifaretti S, Carfagna E, et al.Speed sensor fault tolerant PMSM machines: from position-sensorless to sensorless control[J]. IEEE Transactions on Industry Applications, 2019, 55(4): 3946-3954.
[3] Corne A, Yang Nanfang, Martin J P, et al.Nonlinear estimation of stator currents in a wound rotor syn-chronous machine[J]. IEEE Transactions on Industry Applications, 2018, 54(4): 3858-3867.
[4] Eull M, Mohamadian M, Luedtke D, et al.A current observer to reduce the sensor count in three-phase pm synchronous machine drives[J]. IEEE Transactions on Industry Applications, 2019, 55(5): 4780-4789.
[5] Martín C, Arahal M R, Barrero F, et al.Five-phase induction motor rotor current observer for finite con-trol set model predictive control of stator current[J]. IEEE Transactions on Industrial Electronics, 2016, 63(7): 4527-4538.
[6] Xiong Fei, Wu Junyong, Liu Zicheng, et al.Current sensorless control for dual active bridge DC-DC converter with estimated load-current feedforward[J]. IEEE Transactions on Power Electronics, 2018, 33(4): 3552-3566.
[7] Das D, Madichetty S, Singh B, et al.Luenberger observer based current estimated Boost converter for PV maximum power extraction-a current sensorless approach[J]. IEEE Journal of Photovoltaics, 2019, 9(1): 278-286.
[8] 阙鸿杰, 全力, 张丽, 等. 基于自适应滤波器在线解耦的磁场增强型永磁电机无位置传感器控制[J]. 电工技术学报, 2022, 37(2): 344-354.
Que Hongjie, Quan Li, Zhang Li, et al.Sensorless control of flux-intensifying permanent magnet syn-chronous motor based on adaptive Notch filter online decoupling[J]. Transactions of China Electrotechnical Society, 2022, 37(2): 344-354.
[9] Ahn J W, Lukman G F.Switched reluctance motor: research trends and overview[J]. CES Transactions on Electrical Machines and Systems, 2018, 2(4): 339-347.
[10] Zhang Man, Bahri I, Mininger X, et al.Vibration reduction controller for a switched reluctance machine based on HW/SW partitioning[J]. IEEE Transactions on Industrial Informatics, 2021, 17(6): 3879-3889.
[11] 闫文举, 陈昊, 刘永强, 等. 一种用于电动汽车磁场解耦型双定子开关磁阻电机的新型功率变换器[J]. 电工技术学报, 2021, 36(24): 5081-5091.
Yan Wenju, Chen Hao, Liu Yongqiang, et al.A novel power converter on magnetic field decoupling double stator switched reluctance machine for electric vehicles[J]. Transactions of China Electrotechnical Society, 2021, 36(24): 5081-5091.
[12] 丁文, 李可, 付海刚. 一种12/10极模块化定子混合励磁开关磁阻电机分析[J]. 电工技术学报, 2022, 37(8): 1948-1958.
Ding Wen, Li Ke, Fu Haigang.Analysis of a 12/10-pole modular-stator hybrid-excited switched reluctance machine[J]. Transactions of China Electrotechnical Society, 2022, 37(8): 1948-1958.
[13] 孙德博, 胡艳芳, 牛峰, 等. 开关磁阻电机调速系统故障诊断和容错控制方法研究现状及展望[J]. 电工技术学报, 2022, 37(9): 2211-2229.
Sun Debo, Hu Yanfang, Niu Feng, et al.Status and prospect of fault diagnosis and tolerant control methods for switched reluctance motor drive system[J]. Transactions of China Electrotechnical Society, 2022, 37(9): 2211-2229.
[14] Davarpanah G, Faiz J.A novel structure of switched reluctance machine with higher mean torque and lower torque ripple[J]. IEEE Transactions on Energy Conversion, 2020, 35(4): 1859-1867.
[15] Aiso K, Akatsu K.High speed SRM using vector control for electric vehicle[J]. CES Transactions on Electrical Machines and Systems, 2020, 4(1): 61-68.
[16] Cai Jun, Liu Zeyuan, Zeng Yu.Aligned position estimation based fault-tolerant sensorless control strategy for SRM drives[J]. IEEE Transactions on Power Electronics, 2019, 34(8): 7754-7762.
[17] Ho C Y, Wang J C, Hu Kaiwei, et al.Development and operation control of a switched-reluctance motor driven flywheel[J]. IEEE Transactions on Power Electronics, 2019, 34(1): 526-537.
[18] Husain T, Uddin W, Sozer Y.Performance com-parison of short-pitched and fully pitched switched reluctance machines over wide speed operations[J]. IEEE Transactions on Industry Applications, 2018, 54(5): 4278-4287.
[19] 费晨, 颜建虎, 汪盼, 等. 基于改进的转矩分配函数法的开关磁阻电机转矩脉动抑制[J]. 电工技术学报, 2018, 33(增刊2): 394-400.
Fei Chen, Yan Jianhu, Wang Pan, et al.Torque ripple suppression of switched reluctance motor based on modified torque sharing function[J]. Transactions of China Electrotechnical Society, 2018, 33(S2): 394-400.
[20] 卿龙, 王惠民, 葛兴来. 一种高效率开关磁阻电机转矩脉动抑制方法[J]. 电工技术学报, 2020, 35(9): 1912-1920.
Qing Long, Wang Huimin, Ge Xinglai.A high efficiency torque ripple suppression method for switched reluctance motor[J]. Transactions of China Electrotechnical Society, 2020, 35(9): 1912-1920.
[21] Valencia D F, Tarvirdilu-Asl R, Garcia C, et al.Vision, challenges, and future trends of model predictive control in switched reluctance motor drives[J]. IEEE Access, 2021, 9: 69926-69937.
[22] Valencia D F, Tarvirdilu-Asl R, Garcia C, et al.A review of predictive control techniques for switched reluctance machine drives. part Ⅱ: torque control, assessment and challenges[J]. IEEE Transactions on Energy Conversion, 2021, 36(2): 1323-1335.
[23] Dhale S, Nahid-Mobarakeh B, Emadi A.A review of fixed switching frequency current control techniques for switched reluctance machines[J]. IEEE Access, 2021, 9: 39375-39391.
[24] 闫文举, 陈昊, 马小平, 等. 不同转子极数下磁场解耦型双定子开关磁阻电机的研究[J]. 电工技术学报, 2021, 36(14): 2945-2956.
Yan Wenju, Chen Hao, Ma Xiaoping, et al.Deve-lopment and investigation on magnetic field decoupling double stator switched reluctance machine with different rotor pole numbers[J]. Transactions of China Electrotechnical Society, 2021, 36(14): 2945-2956.
[25] Han Guoqiang, Chen Hao, Shi Xianqiang, et al.Phase current reconstruction strategy for switched relu-ctance machines with fault-tolerant capability[J]. IET Electric Power Applications, 2017, 11(3): 399-411.
[26] Sun Qingguo, Wu Jianhua, Gan Chun, et al.A multiplexed current sensors-based phase current detection scheme for multiphase SRMs[J]. IEEE Transactions on Industrial Electronics, 2019, 66(9): 6824-6835.
[27] Sun Qingguo, Wu Jianhua, Gan Chun, et al.A new phase current reconstruction scheme for four-phase SRM drives using improved converter topology without voltage penalty[J]. IEEE Transactions on Industrial Electronics, 2018, 65(1): 133-144. |
|
|
|
2023, Vol. 38 
