|
|
Speed Sensorless Model Predictive Control for Load Commutated Inverter-Fed Electrically Excited Synchronous Motor |
Kou Jiabao, Gao Qiang, Teng Yongxiao, Xu Dianguo |
School of Electrical Engineering and Automation Harbin Institute of Technology Harbin 150001 China |
|
|
Abstract Load commutated inverter (LCI)-fed electrically excited synchronous motor control system is widely used in medium and high voltage industrial applications. In response to disturbances and load change, the system dynamic response performance is poor due to its large inertia coefficient and low switching frequency. A speed sensorless model predictive control method based on LCI-fed electrically excited synchronous motor is proposed in this paper. Firstly, the prediction equation of state is established according to the LCI model, and the appropriate cost function and constraint conditions are given. Then, the control vector model in load commutation mode is analyzed. The design method and parameter selection principle of designed speed observer are given, and the effect of load change on speed observation is analyzed and compensated. At the same time, the designed observer can observe the inverter input voltage and terminal voltage phase. Finally, the proposed speed sensorless model predictive control method is verified at a 3.75kW LCI-fed electrically excited synchronous motor experimental platform. The results show that the proposed control method can effectively improve the dynamic response performance of system, and the designed observer is feasible. The speed observation error is less than 13° with rated step load.
|
Received: 30 June 2020
|
|
|
|
|
[1] Kataoka T, Nishikata S. Transient performance analysis of self-controlled synchronous motors[J]. IEEE Transactions on Industry Applications, 1981, IA-17(2): 152-159. [2] Besselmann T J, Almér S, Ferreau H J.Model predictive control of load-commutated inverter-fed synchronous machines[J]. IEEE Transactions on Power Electronics, 2016, 31(10): 7384-7393. [3] Mohamadian S, Tessarolo A, Castellan S, et al.Steady-state simulation of LCI-fed synchronous motor drives through a computationally efficient algebraic method[J]. IEEE Transactions on Power Electronics, 2017, 32(1): 452-470. [4] 寇佳宝, 高强, 徐可, 等. 负载换相逆变器驱动电励磁同步电机静止及低速转子位置检测方法[J]. 电工技术学报, 2018, 33(24): 5670-5677.Kou Jiabao, Gao Qiang, Xu Ke, et al. Rotor position detection method at standstill or low speed for load commutated inverter-fed electrically excited synchronous motor[J]. Transactions of China Electrotechnical Society, 2018, 33(24): 5670-5677. [5] Titus J, Hatua K.An asymmetric nine-phase induction motor for LCI-fed medium voltage drive applications[J]. IEEE Transactions on Power Electronics, 2020, 35(5): 5047-5056. [6] 林茂, 李颖晖, 吴辰, 等. 基于滑模模型参考自适应系统观测器的永磁同步电机预测控制[J]. 电工技术学报, 2017, 32(6): 156-163.Lin Mao, Li Yinghui, Wu Chen, et al. A model reference adaptive system based sliding mode observer for model predictive controlled permanent magnet synchronous motor drive[J]. Transactions of China Electrotechnical Society, 2017, 32(6): 156-163. [7] 刘珅, 高琳. 永磁同步电机的改进模型预测直接转矩控制[J]. 电机与控制学报, 2020, 24(1): 10-17.Liu Kun, Gao Lin. Improved model of predictive direct torque control for permanent magnet synchronous motor[J]. Electric Machines and Control, 2020, 24(1): 10-17. [8] Ahmed A A, Koh B K, Lee Y I.A comparison of finite control set and continuous control set model predictive control schemes for speed control of induction motors[J]. IEEE Transactions on Industrial Informatics, 2018, 14(4): 1334-1346. [9] Hu Yuansheng, Hu Cungang, Zhang Pinjia, et al.A novel hybrid seven-level converter for permanent magnet synchronous motor driving system based on model predictive control[J]. CES Transactions on Electrical Machines and Systems, 2019, 3(4): 389-396. [10] Besselmann T J, Almér S, Ferreau H J.Model predictive control of load-commutated inverter-fed synchronous machines[J]. IEEE Transactions on Power Electronics, 2016, 31(10): 7384-7393. [11] Besselmann T J, Van de moortel S, Almér S, et al. Model predictive control in the multi-megawatt range[J]. IEEE Transactions on Industrial Electronics, 2016, 63(7): 4641-4648. [12] 赵远洋, 韩邦成, 陈宝栋. 基于霍尔矢量相位跟踪的永磁同步电机转子位置与速度估算方法[J]. 电工技术学报, 2019, 34(15): 3147-3157.Zhao Yuanyang, Han Bangcheng, Chen Baodong. Speed and rotor position estimation for PMSM based on hall vector phase-tracking[J]. Transactions of China Electrotechnical Society, 2019, 34(15): 3147-3157. [13] Cai Jun, Liu Zeyuan, Zeng Yu.Aligned position estimation based fault-tolerant sensorless control strategy for SRM drives[J]. IEEE Transactions on Power Electronics, 2019, 34(8): 7754-7762. [14] Xu Wei, Wang Lei, Liu Yi, et al.Improved rotor flux observer for sensorless control of PMSM with adaptive harmonic elimination and phase compensation[J]. CES Transactions on Electrical Machines and Systems, 2019, 3(2): 151-159. [15] 孙兴法, 聂子玲, 朱俊杰, 等. 基于低阶串行双扩展卡尔曼滤波的永磁直线同步电机无速度传感器控制策略[J]. 电工技术学报, 2018, 33(12): 2685-2694.Sun Xingfa, Nie Ziling, Zhu Junjie, et al. A speed sensorless control strategy for a permanent magnet linear synchronous motor based on low-order serial dual extended Kalman filters[J]. Transactions of China Electrotechnical Society, 2018, 33(12): 2685-2694. [16] Hasegawa C, Nishikata S.A sensorless rotor position detecting method for self-controlled synchronous motors[C]//2008 International Conference on Electrical Machines and Systems, Wuhan, China, 2008: 1017-1021. [17] Kou Jiabao, Gao Qiang, Xu Ke, et al.A sensorless rotor position estimation method based on the field current harmonic for an LCI-fed EESM[J]. IEEE Transactions on Industrial Electronics, 2019, 66(4): 2561-2569. |
|
|
|