|
|
|
| Isolated Interleaved DC/DC Converters With Winding-Cross-Coupled Inductors |
| Li Wuhua1, He Xiangning1, Wu Jianyong2 |
| 1. Zhejiang University Hangzhou 310027 China 2. Equipment Department of China PLA Air Force Beijing 100843 China |
|
|
|
|
Abstract Four main types of isolated interleaved structures are discussed in this paper. Then, a series of Boost or Buck type converters are derived from the conventional interleaved Flyback converter by employing winding-cross-coupled inductors (WCCIs) and interleaved structure. Furthermore, a ZVT interleaved Flyback-Boost converter with WCCIs, active clamp circuit and primary-parallel-secondary-series (PPSS) structure is analyzed as an example to explore the circuit performance. ZVT performance is realized for both the main and the clamp switches during the whole switching transition. Only one set of active clamp circuit is necessary to recycle the leakage energy and to suppress the turn-off voltage spikes. The output diode reverse-recovery problem is alleviated by the leakage inductance. A prototype with 40V-to-760V rated at 1kW has been built to verify the effectiveness of the converters.
|
|
Received: 14 February 2008
Published: 17 February 2014
|
|
|
|
|
|
[1] 姚刚, 沈雁群, 李武华, 等. 一种新型的有源交错并联Boost软开关电路[J].中国电机工程学报, 2005, 25(19): 65-69.
[2] Wong P, Xu P, Yang B, et al. Performance improvements of interleaving VRMs with coupling inductors[J]. IEEE Transactions on Power Electronics, 2001, 16(4): 499-507.
[3] Liu C, Johnson A, Lai J S. A novel three-phase high-power soft-switched DC/DC converter for low-voltage fuel cell applications[J]. IEEE Transactions on Power Electronics, 2005, 41(6): 1691-1697.
[4] Li W, He X. An interleaved winding-coupled Boost converter with passive lossless clamp circuits[J]. IEEE Transactions on Power Electronics, 22(4): 1499-1507.
[5] 穆新华. 交错并联式双管正激变换器工作模式分析 及系统设计[J].中国电机工程学报, 2004, 24(12): 38-42.
[6] 石健将, 洪峰, 严仰光. 双管正-反激组合变换器研究[J]. 电工技术学报, 2003, 18 (5): 87-90.
[7] 石健将, 严仰光, 何湘宁. 一种具有输入端电容均压的串-并型双管正激组合变换器研究[J]. 中国电机工程学报, 2004, 24(12):92-97.
[8] Erickson R W, Maksimovic D. Fundamentals of power electronics[J]. 2nd ed. Holland: Kluwer Academic Publishers, 2001.
[9] Watson R, Lee F C, Hua G C. Utilization of an active-clamp circuit to achieve soft switching in flyback converters[J]. IEEE Transactions on Power Electronics, 1996, 11(1): 162-169.
[10] Zhao Q, Lee F C. High-efficiency, high step-up DC-DC converters[J]. IEEE Transactions on Power Electronics, 2003, 18(1): 65-73. |
|
|
|
2009, Vol. 24 
