双馈异步风力发电机的轴电流分析

doi:10.19595/j.cnki.1000-6753.tces.171320

Abstract
Figure/Table
References
Related Citation (15)

Download: PDF (17668 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract Doubly-fed induction generators (DFIG) are widely used in wind power generation systems. The common mode voltage caused by the converter can induce bearing voltage through the coupling capacitance and result in the bearing currents, which seriously affect the efficiency and safety of wind power generation. It’s very important to construct a precise bearing currents model. This paper established a completed bearing currents equivalent model, which considered both stator common mode voltage and rotor common mode voltage. The capacitances of the DFIG could be calculated through finite element method and the measurement method on capacitances of DFIG was provided. Then a 1.5 MW DFIG was analyzed. The result showed that bearing voltage induced by stator common mode voltage was very small, and the effects of the stator part can be neglected. The simplified model which only considered the rotor common mode voltage is suitable for analyzing the bearing current problem of DFIG. The sensitivity analysis on capacitors was carried out. The capacitor C_rwris a key parameter to suppress the bearing voltage and bearing current.

Key words： Doubly-fed induction generators bearing voltage bearing current coupling capacitance bearing voltage ratio

Received: 18 September 2017 Published: 15 October 2018

PACS:

TM315

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	Liu Ruifang
	Ren Xuejiao
	Chen Jiayao

Cite this article:

Liu Ruifang,Ren Xuejiao,Chen Jiayao. Analysis of Bearing Currents in Doubly-Fed Induction Wind Turbines[J]. Transactions of China Electrotechnical Society, 2018, 33(19): 4517-4525.

URL:

https://dgjsxb.ces-transaction.com/EN/10.19595/j.cnki.1000-6753.tces.171320 OR https://dgjsxb.ces-transaction.com/EN/Y2018/V33/I19/4517

[1] 贺益康, 胡家兵, 徐烈. 并网双馈异步风力发电机运行控制[M]. 北京: 中国电力出版社, 2012.
[2] 任清晨. 风力发电机组工作原理和技术基础[M]. 北京: 机械工业出版社, 2013.
[3] Alewine K,Chen W.A review of electrical winding failures in wind turbine generators[J]. IEEE Electrical Insulation Magazine, 2012, 28(4): 8-13.
[4] Hoppler R, Errath R A.Motor bearings, not just a piece of metal[C]//IEEE-IAS/PCA Cement Industry Conference, Charleston, USA, 2007: 214-233.
[5] 白保东, 刘威峰, 王禹, 等. PWM驱动感应电机轴电压轴承电流[J]. 电工技术学报, 2013, 27(增刊2): 434-440.
Bai Baodong, Liu Weifeng, Wang Yu, et al.Analysis of shaft-voltage bearing current of PWM-driven induction motor[J]. Transactions of China Electrotechnical Society, 2013, 27(S2): 434-440.
[6] Muetze A, Tamminen J, Ahola J.Influence of motor operating parameters on discharge bearing current activity[J]. IEEE Transactions on Industry Applications, 2011, 47(4): 1767-1777.
[7] Kolbe H, Muetze A, Hameyer K.Modelling of impulse currents in mechanical rolling element bearings[J]. COMPEL-the International Journal for Computation and Mathematics in Electrical and Electronic Engineering, 2012, 31(6): 1575-1589.
[8] Zitzelsberger J, Hofmann W, Wiese A, et al . Bearing currents in doubly-fed induction generators[C]//2005 European Conference on Power Electronics and Applications, Dresden, Germany, 2006: 9.
[9] Whittle M, Trevelyan J, Tavner P J.Bearing currents in wind turbine generators[J]. Journal of Renewable and Sustainable Energy, 2013, 5(5): 053128.
[10] Adabi J, Zare F, Ghosh A, et al.Calculations of capacitive couplings in induction generators to analyse shaft voltage[J]. IET Power Electronics, 2010, 3(3): 379-390.
[11] Adabi M E, Vahedi A.A survey of shaft voltage reduction strategies for induction generators in wind energy applications[J]. Renewable Energy, 2013, 50(3): 177-187.
[12] Gerwin Preisinger.SKF大型混合陶瓷深沟球轴承——风力发电机的可靠解决方案[J]. 电机与控制应用, 2008, 35(12): 54-57.Gerwin Preisinger. SKF large hybrid ceramic deep groove ball bearings-a reliable solution for wind turbine generators[J]. Motor and Control Applications, 2008, 35(12): 54-57.
[13] 王禹, 白保东, 刘威峰, 等. 频域寄生电容法变频电机Hertz轴承电流密度计算[J]. 电工技术学报, 2015, 30(2): 189-195.Wang Yu, Bai Baodong, Liu Weifeng, et al. Hertz bearing current density calculation of variable frequency driven motors by frequency domain parasitic capacitance method[J]. Transactions of China Electrotechnical Society, 2015, 30(2): 189-195.
[14] 白保东, 王禹, 陈志雪. 基于电磁屏蔽法变频电机轴承电流抑制研究[J]. 电工技术学报, 2016, 31(7): 33-39.Bai Baodong, Wang Yu, Chen Zhixue. Inhibition of bearing currents in frequency variable motor based on electromagnetic shielding[J]. Transactions of China Electrotechnical Society, 2016, 31(7): 33-39.
[15] 刘瑞芳, 陈嘉垚, 马喜平, 等. 基于PWM逆变器供电轴电流问题的交流电机耦合电容的计算与测量[J]. 电工技术学报, 2014, 29(1): 60-67. Liu Ruifang, Chen Jiayao, Ma Xiping, et al. Calculation and measurement of coupling capacitances in AC motors based on bearing currents problem induced by pwm inverters[J]. Transactions of China Electrotechnical Society, 2014, 29(1): 60-67.
[16] 刘瑞芳, 陈嘉垚. 多导体静电独立系统部分电容的测量[J]. 电气电子学报, 2017, 39(2): 89-93.Liu Ruifang, Chen Jiayao. Measurement of the partition capacitance of independent electrostatic multiple conductors system[J]. Journal of Electrical & Electronic Education, 2017, 39(2): 89-93.
[17] 陈嘉垚. 双馈异步风力发电机轴电流的分析与抑制[D]. 北京: 北京交通大学, 2016.
[18] 刘瑞芳, 桑秉谦, 李伟力. 交流电机轴承电容的计算与测量[J]. 中国电机工程学报, 2017, 37(10):2986-2993.Liu Ruifang, Sang Bingqian, Li Weili. Calculations and measurements of bearing capacitance in AC motor bearings[J]. Proceedings of the CSEE, 2017, 37(10): 2986-2993.
[19] 刘瑞芳, 李俊峰, 桑秉谦, 等. 基于电磁场数值计算的变频供电感应电机耦合电容与轴电压的分析[J]. 电工技术学报, 2015, 30(14): 161-169.Liu Ruifang, Li Junfeng, Sang Bingqian, et al. Analysis of coupling capacitance and shaft voltage of induction motor based on electromagnetic field numerical calculation[J]. Transactions of China Electrotechnical Society, 2015, 30(14): 161-169.
(编辑于玲玲)