|
|
Lithium-Ion Battery Polarization Characteristics at Different Charging Modes |
Yang Fan1, Qiao Yanlong1, Gan Degang2, Wang Qian3, Chen Wei3 |
1. State Key Laboratory of Power Transmission Equipment & System Security and New Technology Chongqing University Chongqing 400044 China; 2. State Grid Sichuan Electric Power Corporation Research Institute Chengdu 610000 China; 3. State Grid Chongqing Electric Power Corporation Research Institute Chongqing 400000 China |
|
|
Abstract High current fast charging of Lithium-ion battery has become a developing trend in recent years. However, high current charging will cause great polarization within the battery, which has great influence on its performance and cycle life. Lithium-ion battery polarization characteristics at different charging methods were investigated. Firstly, an electrochemical-thermal transient numerical model based on LiMn2O4/graphite was established. Herein, the electrochemical process and real-time heat source change were taken into full consideration. Secondly, variation current charging was utilized, and time-varying characteristics of three polarizations were analyzed based on cell voltage and spatial distributions of electrolyte salt concentration. Then cell voltage and polarization voltage along with SOC at different constant current charging rates were analyzed. Subsequently, two variables PA and SOCc were defined to represent the degree of polarization and available capacity. Polarization voltage characteristics under different charging conditions were analyzed quantitatively. Finally, polarization of reflex fast charging influence of different tch on charging was studied. The results show that polarization voltage is affected by charging current and SOC directly, while the polarization affects cell voltage on the other hand. Reflex fast charging can suppress the polarization voltage and weaken its influence on charging.
|
Received: 14 October 2015
Published: 30 June 2017
|
|
|
|
|
[1] 冯飞, 逯仁贵, 朱春波. 一种锂离子电池低温SOC估计算法[J]. 电工技术学报, 2014, 29(7): 53-58. Feng Fei, Lu Rengui, Zhu Chunbo. State of charge estimation of Li-ion battery at low temperature[J]. Transactions of China Electrotechnical Society, 2014, 29(7): 53-58. [2] 徐煌, 王武, 郭晓君. 不同工况下的电动汽车锂离子动力电池特性研究[J]. 电气技术, 2015, 16(2): 12-16. Xu Huang, Wang Wu, Guo Xiaojun. Electric vehicle lithium-ion power battery characteristics research under different operating conditions[J]. Electrical Engineering, 2015, 16(2): 12-16. [3] 刘金枝, 杨鹏, 李练兵. 一种基于能量建模的锂离子电池电量估算方法[J]. 电工技术学报, 2015, 30(13): 100-107. Liu Jinzhi, Yang Peng, Li Lianbing. A method to estimate the capacity of the lithium-ion battery based on energy model[J]. Transactions of China Electro- technical Society, 2015, 30(13): 100-107. [4] Park C K, Zhang Z, Xu Z, et al. Variables study for the fast charging lithium ion batteries[J]. Journal of Power Sources, 2007, 165(2): 892-896. [5] Zhang S S. The effect of the charging protocol on the cycle life of a Li-ion battery[J]. Journal of Power Sources, 2006, 161(2): 1385-1391. [6] 谢涛, 曹军威, 高田, 等. 基于滑动最小二乘算法和电池荷电状态的储能系统平滑控制策略[J]. 电力系统保护与控制, 2015, 43(5): 1-7. Xie Tao, Cao Junwei, Gao Tian, et al. An energy storage system smoothing control strategy based on sliding least square algorithm and battery SOC[J]. Power System Protection and Control, 2015, 43(5): 1-7. [7] 冯飞, 宋凯, 逯仁贵, 等. 磷酸铁锂电池组均衡控制策略及荷电状态估计算法[J]. 电工技术学报, 2015, 30(1): 22-29. Feng Fei, Song Kai, Lu Rengui, et al. Equalization control strategy and SOC estimation for LiFePO 4 battery pack[J]. Transactions of China Electro- technical Society, 2015, 30(1): 22-29. [8] Nyman A, Zavalis T G, Elger R, et al. Analysis of the polarization in a Li-ion battery cell by numerical simulations[J]. Journal of the Electrochemical Society, 2010, 157(11): A1236-A1246. [9] 刘艳莉, 戴胜, 程泽, 等. 基于有限差分扩展卡尔曼滤波的锂离子电池SOC估计[J]. 电工技术学报, 2014, 29(1): 221-228. Liu Yanli, Dai Sheng, Cheng Ze, et al. Estimation of state of charge of lithium-ion battery based on finite difference extended Kalman filter[J]. Transactions of China Electrotechnical Society, 2014, 29(1): 221- 228. [10] Lee J S, Lee J J, Kim M R, et al. Electric model of Li-ion polymer battery for motor driving circuit in hybrid electric vehicle[J]. Journal of Electrical Engineering & Technology, 2012, 7(6): 932-939. [11] Kim J H, Lee S J, Kim S K, et al. Modeling of battery for EV using EMTP/ATPDraw[J]. Journal of Elec- trical Engineering & Technology, 2014, 9(1): 98-105. [12] Nyman A, Zavalis T G, Elger R, et al. Analysis of the polarization in a Li-ion battery cell by numerical simulations[J]. Journal of the Electrochemical Society, 2010, 157(11): A1236-A1246. [13] 姚雷, 王震坡. 锂离子电池极化电压特性分析[J]. 北京理工大学学报, 2014, 34(9): 912-922. Yao Lei, Wang Zhenpo. Polarization characteristics of the lithium-ion battery[J]. Transactions of Beijing Institute of Technology, 2014, 34(9): 912-922. [14] Jiang J C, Liu Q, Zhang C, et al. Evaluation of acceptable charging current of power Li-ion batteries based on polarization characteristics[J]. IEEE Transa- ctions on Industrial Electronics, 2014, 61(12): 6844- 6851. [15] 张凯, 汤依伟, 邹忠, 等. 锂离子电池LiMn 2 O 4 /石墨电极放电过程中扩散极化的仿真[J]. 中国有色金属学报, 2013, 23(8): 2235-2242. Zhang Kai, Tang Yiwei, Zou Zhong, et al. Simulation of diffusion polarization in LiMn 2 O 4 /graphite Li-ion battery during discharge process[J]. Chinese Journal of Nonferrous Metals, 2013, 23(8): 2235-2242. [16] 陈息坤, 孙冬, 陈小虎. 锂离子电池建模及其荷电状态鲁棒估计[J]. 电工技术学报, 2015, 30(15): 141-147. Chen Xikun, Sun Dong, Chen Xiaohu. Modeling and state of charge rubost estimation for lithium-ion batteries[J]. Transactions of China Electrotechnical Society, 2015, 30(15): 141-147. [17] Doyle M, Newman J, Gozdz A S, et al. Comparison of modeling predictions with experimental data from plastic lithium ion cells[J]. Journal of the Electro- chemical Society, 1996, 143(6): 1890-1903. [18] 王坚. 慢脉冲快速充电方法的研究[J]. 电池, 2003, 33(6): 366-368. Wang Jian. The fast charge with slow pulse on controlling the polarization of battery[J]. Battery Bimonthly, 2003, 33(6): 366-368. [19] Ou S Y, Tian J H, Yang C Y. Design and imple- mentation of a DSP-based fast charger for Li-ion battery[C]//Proceedings of the International Con- ference on Power Electronics & Drive Systems, 2011: 809-812. |
|
|
|