|
|
|
| Arc Welding Inverter With Embedded Digital Active EMI Controller |
| Ji Junpeng1,Hua Zhiguang1,Chen Wenjie2,Li Jingang1,Zu Aqian1 |
1. Department of Electrical Engineering, Xi’an University of Technology, Xi’an 710048, China;
2. School of Electrical Engineering, Xi’an Jiaotong University, Xi’an 710049, China |
|
|
|
|
Abstract Digital high-frequency arc welding inverter is widely used in welding areas because of its many advantages such as high efficiency, small size, easy to control etc. However, with the development of high frequency of the switching, the conducted EMI generated by arc welding inverter becomes increasingly serious, especially common mode conducted EMI. Basing on digital active EMI filter (DAEF) controller, this paper proposes a new method which can reduce common mode conduction EMI for arc welding inverter. It is a closed EMI control circle by sampling the detected EMI signal, digital compensation control, DAC output and injecting. The EMI control can be embedded in arc welding inverter original controller to reduce controller costs, and it fundamentally solved the problem that size and losses of EMI filter is bigger, because there are no component in series in main circuit topology. In this paper, the arc welding inverter system with DAEF is designed, molded and compensation controlled. Meanwhile, by simulation and analyses, the advantages of arc welding inverter with DAEF in system stability and dynamic performance are showed. Finally, experiment results showed that the proposed method has advantages in reducing conducted EMI emission and improving dynamic performance of arc welding inverter.
|
|
Received: 01 June 2014
Published: 08 September 2015
|
|
|
|
|
|
[1] 聂大涛, 何建萍, 王付鑫, 等. 数字化弧焊电源的现状与分析[J]. 电焊机, 2014, 44(6): 21-25. Nie Datao, He Jianping, Wang Fuxin, et al. Status and analyze of the digital arc welding power source[J]. Electric Welding Machine, 2014, 44(6): 21-25.
[2] Alejandro Navarro-Crespin, Victor Manuel Lopez, Rosario Casanueva, et al. Digital control for an arc welding machine based on resonant converters and synchronous rectification[J]. IEEE Trans. on Industrial Informatics, 2013, 9(2): 839-847.
[3] Yu-Kang Lo, Huang-Jen Chiu, Tzu-Herng Song, et al. A Software-Based CM and DM Measurement System for the Conducted EMI[J]. IEEE Trans. on Industrial Electronics, 2000, 47(4): 977-978.
[4] 王世山, 龚敏, 虞振洋. 差共模噪声相互转化机理及在平面EMI滤波器设计中的应用[J]. 电工技术学报, 2014, 29(2): 239-246. Wang Shishan, Gong Min, Yu Zhenyang. Theoretical Investigation of Mutual Transformation between Differential Mode and Common Mode Noise and Its Implementation in the Design of Planar EMI Filter[J]. Transactions of China Electrotechnical Society, 2014, 29(2): 239-246.
[5] Dianbo Fu, Shuo Wang, Pengju Kong, et al. Novel Techniques to Suppress the Common-Mode EMI Noise Caused by Transformer Parasitic Capacitances in DC-DC Converters[J]. IEEE Trans. on industrial electronics, 2013, 60(11): 4968-4977.
[6] Sheng Ye, Wilson Eberle, Yan-Fei Liu. A Novel EMI Filter Design Method for Switching Power Supplies [J]. IEEE Trans. on industrial electronics, 2004, 19(6): 1668-1678.
[7] Fang Luo, Shuo Wang, Fei (Fred) Wang, et al. Analysis of CM volt-second influence on CM inductor saturation and design for input EMI filters in three- phase DC-fed motor drive systems[J]. IEEE Trans. on Power Electronics, 2010, 25(7): 1905-1914.
[8] Maria Carmela Di Piazza, Antonella Ragusa, Gian- paolo Vitale. Power-Loss Evaluation in CM Active EMI Filters for Bearing Current Suppressions[J]. IEEE Trans. on Industrial Electronics, 2011, 58(11): 5142-5152.
[9] Wenjie Chen, Xu Yang, Zhaoan Wang. A novel hybrid common-mode EMI filter with active impedance multiplication[J]. IEEE Trans. on Industrial Electronics, 2011, 58(5): 1826-1834.
[10] Shuo Wang, Y. Y. Maillet, Fei Wang, et al. Inves- tigation of hybrid EMI filters for common-mode EMI suppression in a motor drive system[J]. IEEE Trans. on Power Electronics, 2010, 25(4): 1034-1045.
[11] D. Hamza, MeiQiu, P. K. Jain. Implementation of an EMI Active Filter in Grid-tied PV Micro-inverter Controller and Stability Verification[J]. 2012-38th Annual Conference on IEEE Industrial Electronics Society, 2012: 477-482.
[12] D. Hamza, MeiQiu, P. K. Jain. Application and Stability Analysis of a Novel Digital Active EMI Filter Used in a Grid-Tied PV Micro-inverter Module [J]. IEEE Trans. on Power Electronics. 2013, 28(6): 2867-2874.
[13] D. Hamza, M. Pahlevaninezhad, P. K. Jain. Imple- mentation of a Novel Digital Active EMI Technique in a DSP-Based DC-DC Digital Controller Used in Electric Vehicle (EV)[J]. IEEE Trans. on Power Electronics, 2013, 28(7): 3126-3137.
[14] 赵阳, 董颖华, 陆婋泉, 等. EMI 噪声分离网络在电力线噪声分析中的应用[J]. 中国电机工程学报, 2010, 30(36): 114-120. Zhao Yang, Dong Yinghua, Lu Xiaoquan, et al. EMI noise discrimination network applied to power-line EMI noise analysis[J]. Proceedings of the CSEE, 2010, 30(36): 114-120.
[15] 陈轶涵, 韦徵, 龚春英. 平均电流控制型移相全桥DC-DC变换器输出阻抗及控制环路优化设计[J]. 电工技术学报, 2013, 28(4): 43-49. Chen Yihan, Wei Zheng, Gong Chunying. Study of Output Impedance and Control Loop Optimization Theoretical for Average Current Mode Control Phase- Shift Full Bridge DC-DC Converter[J]. Transactions of China Electrotechnical Society, 2013, 28(4): 43-49.
[16] 武琳, 刘志刚, 洪祥. 隔离式双向全桥DC-DC变换器的功率控制特性比较与分析[J]. 电工技术学报, 2013, 28(10): 179-187. Wu Lin, Liu Zhigang, Hong Xiang. Comparison and Analysis of Power Control Characteristic for Isolated Bidirectional Full-Bridge DC-DC Converter[J]. Transac- tions of China Electrotechnical Society, 2013, 28(10): 179-187 .
[17] 中国国家标准化管理委员会. GB/T 21419-2013 变压器、电抗器、电源装置及其组合的安全 电磁兼容(EMC)要求[S]. 北京: 中国标准出版社, 2013. Standardization Administration of the People's Republic of China. GB/T 21419-2013 Safety of transformers, reactors, power supply units and combinations thereof- EMC requirements[S]. Beijing: China Standards Press, 2013. |
|
|
|
2015, Vol. 30 
