|
|
|
| Winding Loss Optimization for Planar Transformer in LLC Resonant Converter |
| Liao Jiawen, Zhang Junming, Zhang Yi, Qian Zhaoming |
| Zhejiang University Hangzhou 310027 China |
|
|
|
|
Abstract This paper analyzes the winding loss of planar transformer with PCB windings in LLC resonant converter. Unlike conventional power transformer, the transformer in LLC is a combination of inductor and transformer. The primary side current and secondary side current is not in phase, which increases the power loss of the windings. In this paper, the effects of winding structure and air gap are analyzed respectively. Based on the loss analysis, some optimization method to design a planar transformer in LLC resonant converter are presented and discussed. Finite element analysis (FEA) simulation is used to aid the theoretical analysis. A prototype with 300-400V input and 12V/33A output is built to verify the analysis and FEA simulation.
|
|
Received: 02 November 2010
Published: 19 March 2014
|
|
|
|
|
|
[1] Lazar JF, Martinelli R. Steady-state analysis of the LLC series resonant converter[C]. Proceedings of the 17th IEEE Applied Power Electronics Conference and Exposition, 2001, 2: 728-735.
[2] Yang B, Lee FC, Zhang AJ, et al. LLC resonant converter
for front end DC-DC conversion[C]. Proceedings of the 17th IEEE Applied Power Electronics Conference and Exposition, 2002, 2: 1108-1112.
[3] Liu T, Zhou Z, Xiong A, et al. A novel precise design method for LLC series resonant converter[C]. Proceedings of the 28th International, Telecomm- unications Energy Conference, 2006: 1-6.
[4] Niu H, Pei Y, Yang X, et al. Design of high power density DC bus converter based on LLC resonant converter with synchronous rectifier[C]. Proceedings of the IEEE 6th International Power Electronics and Motion Control Conference, 2009: 540.
[5] Chen W, Yan Y, Hu Y, et al. Model and design of PCB parallel winding for planar transformer[J]. IEEE Transactions on Magnetics, September 2003, 39(5): 3202-3404.
[6] Margueron X, Keradec JP, Besri A. Current sharing between parallel turns of a planar transformer: prediction and improvement using a circuit simulation software[C]Proceedings of the 2007 IEEE Industry Applications Conference, 2007: 1787- 1793.
[7] Komma T, Gueldner H. The effect of different air-gap positions on the winding losses of modern planar ferrite cores in switch mode power supplies[C] Proceedings of the Power Electronics Electrical Drives, Automation and Motion, 2008: 632-637.
[8] Ebert CL, Carpes WP, Fagundes J. Determination of magnetic losses in planar magnetic elements[C]. Proceedings of the 18th International Conference on Electrical Machines, 2008: 1-4.
[9] Ackermann B, Lewalter A, Waffenschmidt E. Analytical Modelling of Winding Capacitances and Dielectric Losses for Planar Transformers[C]. Proceedings of the IEEE Computers in Power Electronics, 2004: 2-9.
[10] Maxwell 2D version 11, Ansoft corporation, http://www.ansoft.com/ |
|
|
|
2012, Vol. 27 
