嵌入式同塔三回直流系统多重相模变换及其在故障选线中的应用

doi:10.19595/j.cnki.1000-6753.tces.250692

Abstract
Figure/Table
References
Related Citation (12)

Download: PDF (1345 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract Embedded high voltage direct current system is an effective solution to enhance the regional power grid’s power transfer and dissipation capacity. To effectively utilize the transmission corridor, some projects have transformed the double-circuit AC transmission line on the same tower into three bipolar DC transmission systems. The formed embedded co-tower three-circuit DC system has more complex coupling characteristics and richer fault types. Faults on any line can lead to voltage and current fluctuations on non-faulted lines, which can seriously impact the fault localization of DC lines. However, the existing decoupling schemes cannot realize the effective decoupling of this system, and cannot ensure the regularity and easy recognition of the fault characteristics after decoupling. To address these issues, this paper proposes a faulty line identification scheme based on multiple phase-mode transformation.
The coupling characteristics of the embedded co-tower three-circuit DC system are analyzed. The impedance matrix is constructed by considering the effects of layer height and symmetrical line arrangement. A decoupling method based on multiple phase-mode transformation is proposed, which combines the accurate identification of faulty circuits and the effective decoupling of faulty lines; Aiming at the fault voltage mutation features, the polarity features that are more clear, easy to recognize and have significant differences are extracted, and then a fault line identification scheme based on the modulus polarity combination is proposed. Finally, the performance of the proposed protection scheme is verified by constructing a model of the embedded co-tower three-circuit DC system in PSCAD, and the simulation results show that the proposed scheme is able to identify all fault types accurately, and still has excellent results even under high-resistance fault conditions.
The following conclusions can be drawn from the simulation analysis: (1) The proposed incomplete decoupling method for the embedded co-tower three-circuit DC system is adaptable and has a simple decoupling matrix structure, which significantly reduces the computational difficulty compared to the traditional decoupling scheme. (2) Applying the proposed decoupling scheme, a faulty line identification scheme based on modulus polarity combination is proposed. The fault characteristics of the system are significant during failure, which significantly reduces the complexity and workload of faulty line identification compared with the traditional analysis methods. (3) The proposed fault type prediction method based on multiple phase-mode transformation of fault components can effectively address the problem of overlapping polarity combinations, and has strong capacity of withstanding transition resistance and anti-interference performance.

Key words： Embedded co-tower three-circuit DC system multiple phase-mode transformation voltage mutation overlapping polarity combination

Received: 25 April 2025

PACS:

TM755

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	Li Zhenxing
	An Zhe
	Zhu Yi
	Kong Xiangping
	Weng Hanli

Cite this article:

Li Zhenxing,An Zhe,Zhu Yi等. Multiple Phase-Mode Transformation of Embedded Co-Tower Three-Circuit DC System and Its Application to Fault Line Selection[J]. Transactions of China Electrotechnical Society, 2026, 41(9): 3100-3114.

URL:

https://dgjsxb.ces-transaction.com/EN/10.19595/j.cnki.1000-6753.tces.250692 OR https://dgjsxb.ces-transaction.com/EN/Y2026/V41/I9/3100

[1] 杨金洲, 李业成, 熊鸿韬, 等. 新能源接入的受端电网暂态电压失稳高风险故障快速筛选[J]. 电工技术学报, 2024, 39(21): 6746-6758.
Yang Jinzhou, Li Yecheng, Xiong Hongtao, et al.A fast screening method for the high-risk faults with transient voltage instability in receiving-end power grids interconnected with new energy[J]. Transactions of China Electrotechnical Society, 2024, 39(21): 6746-6758.
[2] 黄萌, 舒思睿, 李锡林, 等. 面向同步稳定性的电力电子并网变流器分析与控制研究综述[J]. 电工技术学报, 2024, 39(19): 5978-5994.
Huang Meng, Shu Sirui, Li Xilin, et al.A review of synchronization-stability-oriented analysis and control of power electronic grid-connected converters[J]. Transactions of China Electrotechnical Society, 2024, 39(19): 5978-5994.
[3] 马燕峰, 李金媛, 王子建, 等. 基于量测数据的新能源电力系统区域等效惯量评估方法[J]. 电工技术学报, 2024, 39(17): 5406-5421.
Ma Yanfeng, Li Jinyuan, Wang Zijian, et al.Assessment method of regional equivalent inertia of new energy power system based on measured data[J]. Transactions of China Electrotechnical Society, 2024, 39(17): 5406-5421.
[4] 郑俊超, 陈松涛, 张献蒙, 等. “嵌入式”对称单极LCC-HVDC系统直流线路接地故障控保协同应对方法[J]. 电网技术, 2025, 49(12): 5314-5324.
Zheng Junchao, Chen Songtao, Zhang Xianmeng, et al.Coordinated control and protection response method for DC line ground faults in embedded symmetric monopolar LCC-HVDC transmission systems[J]. Power System Technology, 2025, 49(12): 5314-5324.
[5] 王之伟, 黄俊辉, 程亮, 等. “嵌入式”直流技术在省级输电网中的规划及应用[J]. 电力工程技术, 2022, 41(6): 65-74.
Wang Zhiwei, Huang Junhui, Cheng Liang, et al.Planning and application of embedded DC transmission technology in the provincial transmission power grid[J]. Electric Power Engineering Technology, 2022, 41(6): 65-74.
[6] 杨亚宇, 邰能灵, 黄文焘, 等. 船舶中压直流综合电力系统(二): 故障保护管理技术[J]. 电工技术学报, 2024, 39(23): 7341-7364.
Yang Yayu, Tai Nengling, Huang Wentao, et al.Shipboard medium-voltage DC integrated power system Ⅱ: protection and fault management technology[J]. Transactions of China Electrotechnical Society, 2024, 39(23): 7341-7364.
[7] Wei Yanfang, Sun Pengyu, Song Zhuoliang, et al.Fault location of VSC based DC distribution network based on traveling wave differential current with Hausdorff distance and cubic spline interpolation[J]. IEEE Access, 2021, 9: 31246-31255.
[8] 王晓卫, 王雪, 王璐, 等. 基于矩阵变换与模态分析的电缆型配电网单相接地故障区段定位[J]. 电工技术学报, 2025, 40(15): 4845-4859.
Wang Xiaowei, Wang Xue, Wang Lu, et al.Single-phase grounding fault section location of the distribution cable networks based on matrix transformation and mode analysis[J]. Transactions of China Electrotechnical Society, 2025, 40(15): 4845-4859.
[9] 张艳霞, 王艳, 伍仕, 等. 基于六序分量法的六相输电系统故障选相[J]. 电力系统自动化, 2009, 33(24): 49-53.
Zhang Yanxia, Wang Yan, Wu Shi, et al.Phase-selection for six-phase power transmission system based on six-sequence components method[J]. Automation of Electric Power Systems, 2009, 33(24): 49-53.
[10] 于仲安, 毕俊强, 郭培育, 等. 同塔四回输电线路故障选线新方案[J]. 电力自动化设备, 2019, 39(11): 127-132.
Yu Zhongan, Bi Junqiang, Guo Peiyu, et al.New fault line selection scheme for four-circuit transmission lines on same tower[J]. Electric Power Automation Equipment, 2019, 39(11): 127-132.
[11] 郭培育, 邰能灵, 于仲安, 等. 基于环流分量的同塔四回输电线路单回线故障选线新方法[J]. 电工技术学报, 2015, 30(24): 206-214.
Guo Peiyu, Tai Nengling, Yu Zhongan, et al.New single-line faulted selecting method for four-parallel transmission lines on the same tower based on loop flow component[J]. Transactions of China Electro-technical Society, 2015, 30(24): 206-214.
[12] 张庆超, 易乐钊. 基于微扰法的不换位输电线路相模变换[J]. 电力系统保护与控制, 2017, 45(10): 18-23.
Zhang Qingchao, Yi Lezhao.Phase-mode transformation of un-transposed transmission lines based on perturbation method[J]. Power System Protection and Control, 2017, 45(10): 18-23.
[13] 刘博, 张庆超. 不换位输电线路参数变换矩阵的校正方法[J]. 电力系统自动化, 2012, 36(7): 62-65.
Liu Bo, Zhang Qingchao.A method of parameter matrix transformation for un-transposed transmission line[J]. Automation of Electric Power Systems, 2012, 36(7): 62-65.
[14] 廖凯, 何正友, 李小鹏. 基于行波固有频率的高压直流输电线路故障定位[J]. 电力系统自动化, 2013, 37(3): 104-109.
Liao Kai, He Zhengyou, Li Xiaopeng.Fault location of HVDC transmission line based on the natural frequency of traveling wave[J]. Automation of Electric Power Systems, 2013, 37(3): 104-109.
[15] 宋国兵, 靳东晖, 靳幸福, 等. CSC-HVDC输电线路单端行波自动故障定位方法[J]. 高电压技术, 2014, 40(2): 588-596.
Song Guobing, Jin Donghui, Jin Xingfu, et al.Automatic fault location method for traveling wave on HVDC transmission line using single-terminal data[J]. High Voltage Engineering, 2014, 40(2): 588-596.
[16] 周念成, 董宇, 廖建权, 等. 金属回流双极直流系统中的极模变换及其在故障分析中的应用[J]. 中国电机工程学报, 2021, 41(增刊1): 130-142.
Zhou Niancheng, Dong Yu, Liao Jianquan, et al.Polar mode transformation in metal reflux bipolar DC system and its application in fault analysis[J]. Proceedings of the CSEE, 2021, 41(S1): 130-142.
[17] 郑宗生, 张巍, 廖建权, 等. 基于改进极模变换的柔性直流输电系统断线故障分析与辨识[J]. 电力系统自动化, 2024, 48(5): 137-145.
Zheng Zongsheng, Zhang Wei, Liao Jianquan, et al.Analysis and identification of line breakage fault for flexible DC transmission system based on improved pole-mode transformation[J]. Automation of Electric Power Systems, 2024, 48(5): 137-145.
[18] 张海燕, 华秀英, 巩英海. 高等代数与解析几何[M]. 北京: 科学出版社, 2016: 159-234.
[19] 王海军, 周全, 梁远升, 等. 基于电压突变量的同塔双回直流输电线路故障选线方法[J]. 电力系统保护与控制, 2015, 43(7): 23-29.
Wang Haijun, Zhou Quan, Liang Yuansheng, et al.Fault line selection of double-circuit HVDC transmission line based on voltage variation[J]. Power System Protection and Control, 2015, 43(7): 23-29.