Transactions of China Electrotechnical Society  2025, Vol. 40 Issue (2): 488-503    DOI: 10.19595/j.cnki.1000-6753.tces.232115
Current Issue| Next Issue| Archive| Adv Search |
Inductor Current Ripple Reduction Strategy Based on Two-Domain Space Vector PWM for Qusai-Z Source Inverter
Liang Weihua, Mu Xiangshang, Shen Yongpeng, Li Hailin
College of Electrical and Information Engineering Zhengzhou University of Light Industry Zhengzhou 450002 China

Download: PDF (2715 KB)   HTML (1 KB) 
Export: BibTeX | EndNote (RIS)      
Abstract  The quasi-Z-source inverter (qZSI) couples an impedance network, consisting of two inductors and two capacitors, between the dc source and the inverter. A shoot-through zero state is inserted into the inverter's switches to boost the DC input voltages up to a higher voltage level. Compared with the DC-DC boost circuitry-based two-stage inverter, the qZSI efficiency can be increased, and cost savings can be achieved. Additionally, the inverter reliability is highly improved, allowing turning on one bridge leg's upper and lower switches simultaneously without damaging the inverter. However, the qZSI must use two large inductors to limit the ripple of the inductor current. Since the size and weight of the qZS network impact the overall volume and weight of the system, large inductors reduce the power density of the entire system. Therefore, it is necessary to minimize the inductor current ripple. One approach is increasing the operating frequency of the inductors. Another approach is modifying the modulation and switching sequence. The former is challenging to maximize the effectiveness because it depends on the switching performance and circuit layout. The latter requires immense computations and hardware resources for two reasons. (1) Two shoot-through references are added to compare with the triangular-carrier wave to generate the shoot-through state. (2) The procedure is complicated due to the difficulty in the location determination of the reference, the calculation of active, zero, and shoot-through times in every sector, and the switching state selection. In addition, the calculations involved in coordinate transformation and triangular functions can result in a high computational burden, potentially leading to delay errors in the system. This paper proposes a new modulation for the three-phase qZSI with minimum inductor current ripple, reducing calculation burden and saving controller resources.
Firstly, the two-domain pulse width modulation (2D-PWM) technique performs shoot-through behavior based on the geometric representation of the three-phase output voltage ranges in a two-dimensional Cartesian coordinate system. The generated geometry is the control region, a series of elliptic curves bounded by a cube for the three-phase qZSI. According to the size relationship between va, vb, and vc, the control region of 2D-PWM can be divided into six sections in the coordinate axes.
Then, the qZS inductors are charged at the shoot-through state (inductor currents rise) and discharged at active and zero states (inductor currents decrease). The charging current ripple is determined by the shoot-through duty ratio, and the discharging current ripple is determined by the active time and zero time. Therefore, the inductor current ripple can be mitigated by choosing the suitable switching sequence and switching times. The shoot-through state time is divided into six unequal parts in one switching cycle, and the times of the six shoot-through intervals are designed. Consequently, the charging current ripple generated in shoot-through intervals equals the discharging current ripple generated in the nearest non-shoot-through intervals, resulting in reduced inductor current ripple.
The maximum inductor current ripple of SVM-6 (2.9 A) is 1.61 times larger than that of the proposed 2D-PWM (1.8 A) in the simulation test. In the experimental test, the maximum inductor current ripples of the proposed 2D-PWM and traditional SVM-6 are about 1.1 A and 2.4 A, reduced by 54.1% compared with traditional SVM-6.
Key wordsQuasi-Z-source inverter      space vector modulation      pulse-width modulation      inductor current ripple     
Received: 20 December 2023     
PACS: TM46  
Service
E-mail this article
Add to my bookshelf
Add to citation manager
E-mail Alert
RSS
Articles by authors
Liang Weihua
Mu Xiangshang
Shen Yongpeng
Li Hailin
Cite this article:   
Liang Weihua,Mu Xiangshang,Shen Yongpeng等. Inductor Current Ripple Reduction Strategy Based on Two-Domain Space Vector PWM for Qusai-Z Source Inverter[J]. Transactions of China Electrotechnical Society, 2025, 40(2): 488-503.
URL:  
https://dgjsxb.ces-transaction.com/EN/10.19595/j.cnki.1000-6753.tces.232115     OR     https://dgjsxb.ces-transaction.com/EN/Y2025/V40/I2/488
Copyright © Transactions of China Electrotechnical Society
Supported by: Beijing Magtech