多三相分数槽集中式绕组容错电机匝间短路故障温度场分析

doi:10.19595/j.cnki.1000-6753.tces.230027

Abstract
Figure/Table
References
Related Citation (15)

Download: PDF (5251 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract Permanent magnet synchronous motors (PMSMs) are widely used in aerospace and electrified transportation due to their high efficiency and simple structure. However, faults such as open-circuit, short-circuit, and inter-turn short-circuit may occur in practical operations due to different operating conditions, which is big challenge forthe safety of applications. Therefore, a detailed 2D electromagnetic model and a 3D fluid-solid-thermal coupling model are established to investigate the temperature distribution of the target motor before and after an inter-turn short-circuit fault.This article provides a basis for further study of preventing inter-turn short circuit fault.
In this paper, a fault-tolerant multiple 3-phase permanent magnet synchronous reluctance machine (PM-SynRM) with 18 slots, 14 polesand concentrated winding is selected as the study object. First, the target motor and its winding were modelled. Assuming that the fault occurred in the A1 coil, the phase A winding was divided into the healthy coil AH, the faulty coil AF, and the healthy coil A2. Then, the Ansys-Fluent software was used to construct a fluid-solid-thermal coupling simulation model in which the eight-turn coils were modelled individually. In the model, a large air domain was applied to simulate the natural cooling processin order to reduce the calculation error. The simulation was set to operate at 2 000 r/min with a load of 67 A to obtain the machine temperature distribution before the short-circuit fault. The overall temperature of the motor gradually decreased from the middle to the end, and the winding temperature decreased radially toward the motor shell. Then, the motor with an inter-turn short-circuit fault at the end was simulated to obtain the temperature distribution. The results showed that the established model is an effective toolto investigate the temperature distribution of the motor before and after an inter-turn short-circuit fault. Then, the factors affecting the temperature rise due to inter-turn short-circuit were analyzed. Different simulation scenarios were conducted for short-circuit coils consideringfour aspects: position of the short-circuit coil, number of short-circuit turns, load current and operation speed.It is found that the coil at position 1 on the outermost layer was the most severely affected when a single-turn fault occurred, and the temperature was peaked at 165℃. The short-circuit current and the temperature decreased with the number of short-circuited turns increasing and the load current and speed reducing.Finally, an experimental platform was built using a 5 kW 9-phase PMSM and the most severe single-turn fault was selected for testing.The motor temperature before and after the fault happened under rated load conditions were measured. Furthermore, the temperature with a load current of 40 A after fault was measuredin order to confirm the factors affecting the temperature rise of inter-turn short circuit. The experimental results verified the correctness of the simulation model.
According to the investigation, the following conclusions can be drawn: (1) A 3D finite element fluid-solid-thermal coupling model is established which can accurately predict the temperature rise of the motor before and after a turn fault, and the highest temperature of the motor is usually located at the end winding. (2) Detailed winding modeling is helpful for investigating the temperature rise due to inter-turn short-circuit faults, and the temperature is affected by the position and number of short-circuited turns, with the single-layer coil located at the slot opening being the most severely affected. (3) As the load and speed increase, both the short-circuit current of the motor and the temperature increase.(4) Terminal short-circuit can effectively suppress the inter-turn short-circuit current and achieve good fault-tolerant effect.

Key words： Multiple 3-phase permanent magnet synchronous reluctance motor inter turn short circuit temperature field analysis finite element simulation

Received: 05 January 2023

PACS:

TM341

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	Wang Bo
	Huang Jun
	Zha Chencheng
	Cheng Ming
	Hua Wei

Cite this article:

Wang Bo,Huang Jun,Zha Chencheng等. Thermal Analysis of Multiple 3-Phase Fractional Slot Concentrated Winding Fault Tolerant Machine with Turn Fault[J]. Transactions of China Electrotechnical Society, 2023, 38(19): 5101-5111.

URL:

https://dgjsxb.ces-transaction.com/EN/10.19595/j.cnki.1000-6753.tces.230027 OR https://dgjsxb.ces-transaction.com/EN/Y2023/V38/I19/5101

[1] 周华伟, 陈铖, 赵宇恒, 等. 基于自然容错开关表的五相永磁同步电机直接转矩控制[J]. 中国电机工程学报, 2022, 59(10): 1-14.
Zhou Huawei, Chen Cheng, Zhao Yuheng, et al.Natural fault-tolerant switching-table-based DTC for five-phase PMSM[J]. Proceedings of the CSEE, 2022, 59(10): 1-14.
[2] 刘国海, 高猛虎, 周华伟, 等. 五相永磁同步电机磁链改进型容错直接转矩控制[J]. 中国电机工程学报, 2019, 39(2): 359-365.
Liu Guohai, Gao Menghu, Zhou Huawei, et al.Flux-modification-based fault-tolerant DTC for five-phase PMSM[J]. Proceedings of the CSEE, 2019, 39(2): 359-365.
[3] 谢颖, 胡圣明, 陈鹏, 等. 永磁同步电机匝间短路故障温度场分析[J]. 电工技术学报, 2022, 37(2): 322-331.
Xie Ying, Hu Shengming, Chen Peng, et al.Thermal field analysis on inter-turn short circuit fault of permanent magnet synchronous motor[J]. Transactions of China Electrotechnical Society, 2022, 37(2): 322-331.
[4] Wang Bo, Wang Jiabin, Griffo A, et al.Effective turn fault mitigation by creating zero sequence current path for a triple redundant 3×3-phase PMA SynRM[J]. IEEE Transactions on Power Electronics, 2019, 34(11): 11080-11089.
[5] Wang Bo, Wang Jiabin, Griffo A, et al.Investigation into fault-tolerant capability of a triple redundant PMA SynRM drive[J]. IEEE Transactions on Power Electronics, 2019, 34(2): 1611-1621.
[6] Qi Yuan, Zafarani M, Gurusamy V, et al.Advanced severity monitoring of interturn short circuit faults in PMSMs[J]. IEEE Transactions on Transportation Electrification, 2019, 5(2): 395-404.
[7] 魏东, 刘侃, 丁荣军, 等. 基于多重同步压缩变换的永磁同步电机初期匝间短路故障检测[J]. 电工技术学报, 2022, 37(18): 4651-4663.
Wei Dong, Liu Kan, Ding Rongjun, et al.A multi-synchrosqueezing transformation based early stage detection of inter-turn short circuit fault in permanent magnet synchronous machine[J]. Transactions of China Electrotechnical Society, 2022, 37(18): 4651-4663.
[8] 吴胜男, 郝大全, 佟文明. 基于等效热网络法和CFD法高速永磁同步电机热计算研究[J]. 电机与控制学报, 2022, 26(7): 29-36.
Wu Shengnan, Hao Daquan, Tong Wenming.Thermal calculation of high speed permanent magnet synchronous motor based on equivalent thermal network and CFD method[J]. Electric Machines and Control, 2022, 26(7): 29-36.
[9] Shi Yanwen, Wang Jiabin, Wang Bo.Electromagnetic-thermal coupled simulation under various fault conditions of a triple redundant 9-phase PMASynRM[J]. IEEE Transactions on Industry Applications, 2020, 56(1): 128-137.
[10] 王立坤, 李渊, 陶大军, 等. 压缩机用水冷永磁同步电机转子旋态下流固耦合传热研究[J]. 中国电机工程学报, 2021, 41(22): 7830-7840.
Wang Likun, Li Yuan, Tao Dajun, et al.Research on coupling heat transfer of fluid and solid under rotating state of water-cooled permanent magnet synchronous motor for compressor[J]. Proceedings of the CSEE, 2021, 41(22): 7830-7840.
[11] Boglietti A, Cavagnino A, Pastorelli M, et al.Thermal analysis of induction and synchronous reluctance motors[J]. IEEE Transactions on Industry Applications, 2006, 42(3): 675-680.
[12] Simpson N, Wrobel R, Mellor P H.Estimation of equivalent thermal parameters of impregnated electrical windings[J]. IEEE Transactions on Industry Applications, 2013, 49(6): 2505-2515.
[13] Shi Yanwen, Wang Jiabin, Hu Rongguang, et al.Electromagnetic and thermal behavior of a triple redundant 9-phase PMASynRM with insulation deterioration fault[J]. IEEE Transactions on Industry Applications, 2020, 56(6): 6374-6383.
[14] 郑迪, 王大志, 于林鑫, 等. 盘式永磁涡流驱动器的电磁-温度耦合解析模型[J]. 电工技术学报, 2019, 34(11): 2315-2323.
Zheng Di, Wang Dazhi, Yu Linxin, et al.Electromagnetic-thermal analytical model of axial-flux permanent magnet eddy current driver[J]. Transactions of China Electrotechnical Society, 2019, 34(11): 2315-2323.
[15] 韩雪岩, 宋聪. 基于磁热耦合法车用永磁同步电机温升计算及影响因素的研究[J]. 电机与控制学报, 2020, 24(2): 28-35.
Han Xueyan, Song Cong.Research on temperature rise influencing factors and calculation of permanent magnet synchronous motor for vehicle based on magneto-thermal coupling method[J]. Electric Machines and Control, 2020, 24(2): 28-35.
[16] Shi Yanwen, Wang Jiabin, Wang Bo.Electro-magnetic-thermal-coupled fault analysis of PMASynRM with turn-to-turn short-circuit involving a few strands[J]. IEEE Transactions on Industry Applications, 2022, 58(1): 294-303.
[17] Chen Xiao, Wang Jiabin, Patel V I, et al.A nine-phase 18-slot 14-pole interior permanent magnet machine with low space harmonics for electric vehicle applications[J]. IEEE Transactions on Energy Con-version, 2016, 31(3): 860-871.
[18] 杭观荣, 李林, 郭曼丽, 等. 国外电喷推进技术发展与趋势[J]. 飞控与探测, 2022(4): 1-11.
Hang Guanrong, Li Lin, Guo Manli, et al.Development and trends of foreign electrospray propulsion technology[J]. Flight Control & Detection, 2022(4): 1-11.
[19] 陈益广, 郑军, 魏娟, 等. 舵机用永磁同步电机的设计与温度场分析[J]. 电工技术学报, 2015, 30(14): 94-99.
Chen Yiguang, Zheng Jun, Wei Juan, et al.Design of PMSM for actuator and its temperature field analysis[J]. Transactions of China Electrotechnical Society, 2015, 30(14): 94-99.
[20] 崔刚, 熊斌, 顾国彪. 新能源汽车扁铜线绕组电机槽内绝缘等效导热系数分析与计算[J]. 电机与控制学报, 2022, 26(11): 1-13.
Cui Gang, Xiong Bin, Gu Guobiao.Analysis and calculation of equivalent thermal conductivity of slot insulation system of flat copper wire winding motor for new energy vehicle[J]. Electric Machines and Control, 2022, 26(11): 1-13.