|
|
|
| Design and Implementation of SVPWM Switching Power Amplifiers for Active Magnetic Bearing |
| Han Fujun1, 2, Fang Jiancheng1, 2, Liu Gang1, 2 |
| 1. Beijing University of Aeronautics and Astronautics Beijing 100083 China 2. Key Laboratory of Fundmental Science for National Defense of Novel Inertial Instrument and Navigation System Technology Beijing 100083 China |
|
|
|
|
Abstract The magnetic bearing biased by permanent magnetic body needs bipolar current, so the full-bridge structure is often used in its switching power amplifier. The conventional full-bridge power amplifier has many power-tubes in magnetic bearing system, and this will leads more power-loss and less reliability. In this paper, a 3-leg switching power amplifier circuit is adopted to realize the SVPWM modulator approach using the digital system which includes DSP and FPGA. The test results indicate that this method can reduce the eddy-current-loss remarkably due to the reduction of current ripple relative to the two-level method, and can reduce the switch-loss due to the less number of power-tubes relative to the three-level method with full-bridge power amplifier. In the same time, this method can increase the reliable of system due to the less of the power-tubes.
|
|
Received: 18 October 2007
Published: 14 February 2014
|
|
|
|
|
|
[1] Keith F J, Maslen E H, Humphris R R, et al. Switching amplifier design for magnetic bearings[C]. Proceedings of the Second International Symposium on Magnetic Bearing, 1990: 211-218.
[2] Zhilichev Y. Analysis of a magnetic bearing pair with a permanent magnet excitation[J]. IEEE Transaction on Magnetics, 2000, 36(5): 3690-3692.
[3] Reisinger M, Amrhein W, Silber S, et al. Development of a low cost permanent magnet biased bearing[C]. Proceedings of the Ninth International Symposium on Magnetic Bearing, 2004:113-118.
[4] Zhang Jing, Jens Oliver Schulze, et al. Synchronous three-level PWM power amplifier for active magnetic bearings[C]. Proceedings of the Fifth International Symposium on Magnetic Bearing, 1996: 277-282.
[5] 杨贵杰, 孙力, 崔乃政, 等. 空间矢量脉宽调制方法的研究[J]. 中国电机工程学报, 2001, 21(5): 79-83.
[6] Jung S Y, Jang H K, Seung K S. A novel cost-effective scheme of power amplifier for AMB using space vector technology[C]. Proceedings of the Eighth International Symposium on Magnetic Bear- ings, 2002: 101-105.
[7] 李冰. 电磁轴承系统集成化技术的研究[D]. 南京：南京航空航天大学, 2003.
[8] 阎治安, 唐名, 易萍虎. 电机控制中电压空间矢量脉宽调制算法的探究[J]. 西安交通大学学报, 2006, 40(12): 1374-1377.
[9] 张亮, 房建成. 电磁轴承脉宽调制型开关功放的实现及电流纹波分析[J]. 电工技术学报, 2007, 22(3): 13-20. |
|
|
|
2009, Vol. 24 
