采用开关周期最优利用率控制的电流断续模式升压功率因数校正变换器

Abstract
Figure/Table
References
Related Citation (15)

Download: PDF (3573 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract An optimum utilization control of switching cycles is proposed in this paper.The efficiency is improved as the critical inductance can be increased and the peak and rms current value of the main power electronics device is therefore decreased.The proposed method also diminishes the output voltage ripple or the energy storage of the output storage capacitor.The experimental results of a 120 W prototype are given to verify the effectiveness of the proposed method.

Key words： Critical inductance switching cycles optimum utilization efficiency

Received: 18 December 2014 Published: 07 December 2015

PACS:

TM46

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	Yao Kai Li Qiang Bo Yuming Hu Wenbin Lv Jianguo

Cite this article:

Yao Kai Li Qiang Bo Yuming Hu Wenbin Lv Jianguo. DCM Boost PFC Converter with Optimum Utilization Control of Switching Cycles[J]. Transactions of China Electrotechnical Society, 2015, 30(17): 13-25.

URL:

https://dgjsxb.ces-transaction.com/EN/ OR https://dgjsxb.ces-transaction.com/EN/Y2015/V30/I17/13

[1] Garcia O,Cobos J A,Prieto R,et al.Single phase power factor correction:a survey[J].IEEE Transactions on Power Electronics,2003,18(3):749-755.
[2] Yang Zaohong,Sen P C.Recent developments in high power factor switch-mode converters[C].IEEE Canadian Conference on Electrical and Computer Engineering,Waterloo,1998,2:477-480.
[3] Agamy M S,Jain P K.A three-level resonant single-stage power factor correction converter:analysis,design,and implementation[J].IEEE Transactions on Industrial Electronics,2009,56(6):2095-2107.
[4] Nussbaumer T,Raggl K,Kolar J W.Design guidelines for interleaved single-phase boost PFC circuits[J].IEEE Transactions on Industrial Electronics,2009,56(7):2559-2573.
[5] Hwu K I,Yau Y T.An interleaved AC-DC converter based on current tracking[J].IEEE Transactions on Industrial Electronics,2009,56(5):1456-1463.
[6] Zhang J,Lu D D C,Sun T.Flyback-based single-stage power-factor-correction schemewith time-multiplexing control[J].IEEE Transactions on Industrial Electronics,2010,57(3):1041-1049.
[7] Lu D D C,Lu H H C,Pjevalica V.Single-stage AC/DC boost-forward converter with high power factor and regulated bus and output voltages[J].IEEE Transactions on Industrial Electronics,2009,56(6):2128-2132.
[8] Liu Y M,Chang L K.Single-stage soft-switching AC-DC converter with input-current shaping for universal line applications[J].IEEE Transactions on Industrial Electronics,2009,56(2):467-479.
[9] Ma Hao,Ji Yue,Xu Ye.Design and analysis of single-stage power factor correction converter with a feedback winding[J].IEEE Transactions on Power Electronics,2010,25(6):1460-1470.
[10]Azcondo F J,Castro A D,López V M,et al.Power factor correction without current sensor based on digital current rebuilding[J].IEEE Transactions on Power Electronics,2010,25(6):1527-1536.
[11]Athab H S,Lu D D C.A high-efficiency AC/DC converter with quasi-active power factor correction[J].IEEE Transactions on Power Electronics,2010,25(5):1103-1109.
[12]邹建龙,马西奎,杨宇.功率因数校正Boost变换器中慢时标分岔的影响因素分析与分岔控制[J].中国电机工程学报,2010,30(3):1-7.
Zou Jianlong,Ma Xikui,Yang Yu.Influencing factors to slow-scale bifurcation in PFC boost converters and bifurcation control[J].Proceedings of the CSEE,2010,30(3):1-7.
[13]林维明,汪晶慧,黄俊来,等.一种高效倍压升压型软开关功率因数校正电路[J].中国电机工程学报,2008,28(36):62-67.
Lin Weiming,Wang Jinghui,Huang Junlai,et al.A high efficiency zero-voltage-switching boost voltage doubler for power factor correction[J].Proceedings of the CSEE,2008,28(36):62-67.
[14]Dixon L H.High power factor pre-regulators for off-line power supplies[C].Unitrode Switching Regulator Power Supply Design Seminar Manual,Paper 12,SEM-700,1990.
[15]杨平,许建平,董政,等.低输入电感电流纹波二次型Boost PFC变换器[J].电机工程学报,2013,33(12):32-38.
Yang Ping,Xu Jianping,Dong Zheng,et al.Quadratic boost power factor correction converters with small input inductor current ripple[J].Proceedings of the CSEE,2013,33(12):32-38.
[16]Chen Y C,Hsu Jhih-Da,Ang Yong-Ann,et al.A new phase shedding scheme for improved transient behavior of interleaved Boost PFC converters[C].Twenty-Ninth Annual IEEE Applied Power Electronics Conference and Exposition,Fort Worth,TX,2014:1916-1919.
[17]Das P,Pahlevaninezhad M,Drobnik J,et al.A nonlinear controller based on a discrete energy function for an AC/DC Boost PFC converter[J].IEEE Transactions on Power Electronics,2013,28(12):5458-5476.
[18]Genc N,Iskender I,Celik M A.Application of interleaved bridgeless boost PFC converter without current sensing[C].IEEE 8th International Power Engineering and Optimization Conference,Langkawi,2014:1-6.
[19]Sun Daying,Sun Weifeng,Wang Qing,et al.A novel digital controller for boost PFC converter with high power factor and fast dynamic response[C].IEEE 10^th International Conference on ASIC (ASICON),Shenzhen,2013:1-4.
[20]罗全明,闫欢,孙明坤,等.基于拓扑组合的高增益 Boost 变换器[J].电工技术学报,2012,27(6):96-102.
Luo Quanming,Yan Huan,Sun Mingkun,et al.High step-up boost converter based on topology combination[J].Proceedings of the CSEE,2012,27(6):96-102.
[21]Lai J S,Chen D.Design consideration for power factor correction boost converter operating at the boundary of continuous conduction mode and discontinuous conduction mode[C].Conference Proceedings Applied Power Electronics Conference and Exposition,San Diego,CA,1993:267-273.
[22]杨飞,阮新波,杨洋,等.采用耦合电感的交错并联电流临界连续[J].电工技术学报,2013,28(1):215-214.
Yang Fei,Ruan Xinbo,Yang Yang,et al.Interleaved critical conduction mode boost PFC converter with coupled inductor[J].Proceedings of the CSEE,2013,28(1):215-214.
[23]Yang Fei,Ruan Xinbo,Ji Qing,et al.Input differential-mode EMI of CRM Boost PFC converter[J].IEEE Transactions on Power Electronics,2013,28(3):1177-1188.
[24]Ryu M,Baek J,Kim J,et al.Electrolytic capacitor-less,non-isolated PFC converter for high-voltage LEDs driving[C].IEEE 8^th International Conference on Power Electronics (ICPE),Melbourne,2011:499-506.
[25]Chen H J,Lee S Y,Chen Y M,et al.A stepping on-time adjustment method for interleaving three-channel critical[C].IEEE Energy Conversion Congress and Exposition,Denver,2013:749-754.
[26]Liu K H,Lin Y L.Current waveform distortion in power factor correction circuits employing discontinuous-mode boost converters[C].20th Annual IEEE Power Electronics Specialists Conference,Milwaukee,USA,1989,2:825-829.
[27]Shu F L,Khambadkone A M.A simple digital DCM control scheme for Boost PFC operating in both CCM and DCM[J].IEEE Transactions on Industrial Electronics,2011,47(4):1802-1812.
[28]C e Silva L S,de Seixas F J M,da S Oliveira P.Experimental evaluation of the bridgeless interleaved boost PFC converter[C].10th IEEE/IAS International Conference on Industry Applications,Fortaleza,2012:1-7.
[29]Simonetti D S L,Vieira J L F,Sebastian J,et al.Simplifying the design of a DCM boost PFP[C].IEEE International Power Electronics Congress,Cuernavaca,1996:138-141.
[30]Simonetti D,Sebastian J,Cobos J A,et al.Analysis of the conduction boundary of a boost PFP fed by universal input[C].27th Annual IEEE Power Electronics Specialists Conference,Baveno,1996,2:1204-1208.
[31]Lazar J,Cuk S.Open loop control of a unity power factor,discontinuous conduction mode boost rectifier[C].17th International Telecommunications Energy Conference,The Hague,Netherlands,1995:671-677.
[32]Lazar J,Cuk S.Feedback loop analysis for AC/DC rectifiers operating in discontinuous conduction mode[C].Conference Proceedings Applied Power Electronics Conference and Exposition,San Jose,CA,1996,2:797-806.
[33]Taniguchi K,Nakaya Y.Analysis and improvement of input current waveforms for discontinuous-mode boost converter with unity power factor[C].Proceedings of the Power Conversion Conference,Nagaoka,1997,1:399-404.
[34]Ye Z Z,Jovanovic M M,Irving B T.Digital implementation of a unity-power-factor constant-frequency DCM boost converter[C].Twentieth Annual IEEE Applied Power Electronics Conference and Exposition,Austin,TX,2005,2:818-824.
[35]Ye Z Z,Jovanovic M M.Implementation and performance evaluation of DSP-based control for constant-frequency discontinuous-conduction-mode boost PFC front end[J].IEEE Transactions on Industrial Electronics,2005,52(1):98-107.
[36]Lai Z,Smedley K M,Ma Y.Time quantity one-cycle control for power-factor-correctors[J].IEEE Transactions on Power Electronics,1997,12(2):369-375.
[37]Redl R.Reducing distortion in boost rectifiers with automatic control[C].Conference Proceedings Applied Power Electronics Conference and Exposition,Atlanta,GA,1997,1:74-80.
[38]Athab H S.A duty cycle control technique for elimination of line current harmonics in single-stage DCM boost PFC circuit[C].IEEE Region 10 Conference TENCON,Hyderabad,2008:1-6.
[39]Weng Dafeng,Yuvarajian S.Constant switching frequency AC-DC converter using second harmonic injected PWM[J].IEEE Transactions on Power Electronics,1996,11(1):115-121.
[40]Schramm D S,Buss M O.Mathematical analysis of a new harmonic cancellation technique of the input line current in DICM boost converters[C].29th Annual IEEE Power Electronics Specialists Conference,Fukuoka,1998,2:1337-1343.
[41]Zhang Xiaotian,Spencer J W.Analysis of Boost PFC converters operating in the discontinuous conduction mode[J].IEEE Transactions on Power Electronics,2011,26(12):3621-3628.
[42]Chan C H,Pong M H.Interleaved boost power factor corrector operating in discontinuous-inductor-current mode[C].Proceedings of the Power Conversion Conference,Nagaoka,1997,1:405-410.
[43]Teodorescu R,Kjaer S B,Munk-Nielsen S,et al.Comparative analysis of three interleaved boost power factor corrected topologies in DCM[C].IEEE 32nd Annual Power Electronics Specialists Conference Vancouver,BC,2001,1:3-7.