基于迭代法的内置式永磁同步电机最大转矩/电流控制

Abstract
Figure/Table
References
Related Citation (15)

Download: PDF (939 KB) HTML (0 KB)
Export: BibTeX | EndNote (RIS)

Abstract The maximun torque per ampere control can take use of the relactance torque of interior permanent magnet scychronous motor. But the lots of computation is brought by this control strategy. So it is not realized easily. In this paper, the iterative method is used to getting the curve of relationship between the electromagnetic torque and the current component. Then three 2-functions are applicated to analoging the relationship curve.Insteading of discrete spots of traditional method of look up table, these approximate curves which are obtained by above threes 2-functions are employed into MTPA. Then the dynamic performance of the system can be enhanced.At last, the dynamic performance of the two method are compared by simulation and experiment. The results approv the effectiveness and advantage of this proposed strategy.

Key words： IPMSM MTPA iterative method curve analog

Received: 23 October 2013 Published: 22 May 2014

PACS:

TM351

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	Zhang Wenjuan
	Feng Yaojing
	Huang Shoudao
	Gao Jian

Cite this article:

Zhang Wenjuan,Feng Yaojing,Huang Shoudao等. The Maxium Torque Per Ampere Control of Permanent Magnet Synchronous Motor Based on Iterative Method[J]. Transactions of China Electrotechnical Society, 2013, 28(2增): 402-407.

URL:

http://dgjsxb.ces-transaction.com/EN/ OR http://dgjsxb.ces-transaction.com/EN/Y2013/V28/I2增/402

[1] Shi J, Liu T, Chang Y. Position control of an interior permanent-magnet synchronous motor without using a shaft position sensor[J]. IEEE Transactions on Industrial Electronics, 2007, 54(4): 1989-2000.
[2] 陈钱春, 阮毅, 王仁峰. 永磁同步电动机矢量控制的研究与分析[J]. 电机控制与应用, 2007, 2. Chen Qianchun, Ruan Yi, Wang Renfeng. Research and analysis of vector control for permanent magnet synchronous motor[J]. Electric Machines&Control Application, 2007, 2.
[3] 唐任远. 现代永磁电机理论与设[M]. 北京: 机械工业出版社, 2006.
[4] Pan Ching Tsai, Sue Shinn Ming. A linear maximum torque per ampere control for IPMSM drives over full-speed range[J]. IEEE Transactions on Energy Conversion, 2005, 20(2).
[5] Eng. M. F. Moussa Dr. A. Helal Prof. Y. Gaber Prof. H. A. Youssef, Unity power factor control of permanent magnet motor drive system[J]. Power System Conference, 2008: 360-367.
[6] Yukinori Inoue, Shigeo Morimoto, and Masayuki Sanada. Examination and linearization of torque control system for direct torque controlled IPMSM[J]. IEEE Transaction on Industry Applications, 2010, 46(1).
[7] Qian W Z, Panda S K, Xu J X. Speed ripple minimization in PM synchronous motor using iterative learning control[J]. IEEE Transactions on Energy Conversion, 2005, 20(1): 53-61.
[8] Cavallaro C, Di Tommaso A O, Miceli R. Eficiency enhancement of permanent—magnet synchronous motor drives by online loss minimization approaches[J]. IEEE Transactions on Industrial Electronics, 2005, 52(4): l153-l160.
[9] 王江, 李涛, 曾启明, 等. 基于观测器的永磁同步电动机微分代数非线性控制[J]. 中国电机工程学报2005, 25(2): 87-92. Wang Jiang, Li Tao, Zeng Qiming et al. Differential algebraic observer-based nonlinear control of PM synchronous motor[J]. Proceeding of the CSEE, 2005, 25(2): 87-92.
[10] 谢乐, 陈乐, 孙坚. 永磁同步电动机的自适应非线性轨迹跟踪控制[J]. 电工技术学报, 2006, 21(1): 82-85. Xie Yue, Chen Le, Sun Jian. Adaptive nonlinear tracking control of permanent magnet synchronous motor[J]. Transactions of China Electrotechnical Society, 2006, 21(1): 82-85.
[11] 李长红, 陈明俊, 吴小役. PMSM调速系统中最大转矩电流比控制方法的研究. 中国电机工程学报. 2005, 25(21): 169-174. Li Changhong, Chen Mingjun, Wu Xiaoyi. Study og a maximum ratio of torque to current control method for PMSM[J]. Proceeding of the CSEE, 2005, 25(21): 169-174.